Citation Search Quick Search
  2024, Vol. 43 Issue (5): 1282-1290    DOI: 10.13722/j.cnki.jrme.2023.0750
Artiles Current Issue | Archive | Adv Search |
A combined preparation method of stratified preloading and centrifuge operation for soft clay foundations
LAN Jingyan1,2,XIAN Ganling1,WANG Yongzhi3,4,WANG Tiqiang3,4,LIU Xiangyu1,REN Hongyi1,TANG Zhaoguang3,4
(1. College of Civil Engineering,Guilin University of Technology,Guilin,Guangxi 541004,China;2. Guangxi Key Laboratory of Geomechanics and Geotechnical Engineering,Guilin University of Technology,Guilin,Guangxi 541004,China;3. Key Laboratory of Earthquake Engineering and Engineering Vibration,Institute of Engineering Mechanics,China Earthquake Administration,Harbin,Heilongjiang 150080,China;4. Key Laboratory of Earthquake Disaster Prevention and Emergency Management Department,Institute of Engineering Mechanics,China Earthquake Administration,
Harbin,Heilongjiang 150080,China)
Download: PDF (1008 KB)   HTML (1 KB) 
Export: BibTeX | EndNote (RIS)      
Abstract  The preparation of centrifugal model of soft clay foundation is both the prerequisite and foundation of the test,and at the same time,it is also a technical difficulty. In this paper,a centrifugal model preparation method for saturated soft clay is proposed based on the combination of layered pre-consolidation and centrifuge consolidation under conventional gravity conditions,the principle and steps of layered consolidation method are elaborated in detail,and the changes of pore pressure and vertical displacement in the process of consolidation are analyzed and compared with the theoretical calculations of compression amount. The results show that: for the layered pre-compression consolidation,the settlement rate of 0.2 mm/h and the dissipation rate of excess pore water pressure of 0.2 kPa/h can be taken as the conditions for the consolidation and stabilization of the soft clay model when applying each level of loading;for the centrifuge consolidation,the model achieves the consolidation and stabilization state when the centrifugal acceleration reaches the target value of 5 hours,and the dissipation of the excess pore water pressure of up to 2 kPa/h and the surface vertical settlement up to 0.15 mm/h can be taken as the stabilization conditions for centrifugal consolidation of soft clay model. The research results and test steps can be used to provide methodological references and technical support for the preparation of soft clay centrifugal shaking table tests in the future,which is of scientific significance for improving the preparation accuracy of soft clay centrifugal models.
Key wordssoil mechanics      saturated soft clay      centrifugal model test      layered consolidation drainage      excess pore water pressure     
Service
E-mail this article
Add to my bookshelf
Add to citation manager
E-mail Alert
RSS
Articles by authors
LAN Jingyan1
2
XIAN Ganling1
WANG Yongzhi3
4
WANG Tiqiang3
4
LIU Xiangyu1
REN Hongyi1
TANG Zhaoguang3
4
Cite this article:   
LAN Jingyan1,2,XIAN Ganling1, et al. A combined preparation method of stratified preloading and centrifuge operation for soft clay foundations[J]. , 2024, 43(5): 1282-1290.
URL:  
http://rockmech.whrsm.ac.cn/EN/10.13722/j.cnki.jrme.2023.0750      OR      http://rockmech.whrsm.ac.cn/EN/Y2024/V43/I5/1282
Copyright © 2005-2015 Edited and Published by Editorial Office for Chinese Journal of Rock Mechanics and Engineering
Sponsored by : Chinese Society for Rock Mechanics and Engineering 
Published by : Science Press 
Address: Wuhan 430071, China  Tel: (027)87199250  Fax: (027)87199250  Email: rock@whrsm.ac.cn
DESIGNED BY: Beijing Magtech Science & Technolgy Development Co.,Ltd.
鄂公网安备 42010602003581号