不规则柱状节理岩体常规三轴压缩力学各向异性试验研究

doi:10.13722/j.cnki.jrme.2022.0272

Abstract
Figure/Table
References (0)
Related Citation (6)

Download: PDF (2843 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract Based on 3D printing and physical model test method，artificial irregular columnar jointed rock mass specimens with seven different dip angles were prepared by one-shot moulding method where brittle green wax was chosen as 3D printing material to print irregular columnar joint network in which white cement slurry was poured. Conventional triaxial compression tests were performed on these artificial irregular columnar jointed rock mass specimens，from which their strength and deformation anisotropy and typical failure modes were derived. From the experimental results，it showed that the strength，deformation modulus and lateral strain ratio of irregular columnar jointed rock mass exhibited moderate or high anisotropy and confining pressure had significant effect on its mechanical anisotropy. Furthermore，the typical failure modes of irregular columnar jointed rock mass under conventional compression condition had been classified into four kinds，that was，Y-shaped conjugate shear failure along columnar joints，splitting failure along both intact column and columnar joint，shear slip failure along columnar joint and axial splitting of intact columns. Finally，the influence of 3D printed green wax irregular columnar joint network on mechanical behaviors of irregular columnar jointed rock mass was analyzed.

Key words： rock mechanics rock mass columnar joints conventional triaxial compression test mechanical anisotropy

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	XIAO Weimin1
	2
	HAN Juncheng1
	2
	TIAN Mengting1
	2
	WU Zhiyou1
	2

Cite this article:

XIAO Weimin1,2,HAN Juncheng1, et al. Experimental study on mechanical anisotropy of irregular columnar jointed rock mass under conventional triaxial compression condition[J]. , 2023, 42(S1): 3131-3140.

URL:

https://rockmech.whrsm.ac.cn/EN/10.13722/j.cnki.jrme.2022.0272 OR https://rockmech.whrsm.ac.cn/EN/Y2023/V42/IS1/3131

[1]	徐松年. 火山岩柱状节理构造研究[M]. 杭州：杭州大学出版社，1995：2.(XU Songnian. Research on volcanic rock columnar joint structure[M]. Hangzhou：Hangzhou University Press，1995：2.(in Chinese))
[2]	QUE X C，ZHU Z D，LU W B. Anisotropic constitutive model of pentagonal prism columnar jointed rock mass[J]. Bulletin of Engineering Geology and the Environment，2020，79(1)：269-286.
[3]	卢轶然. 柱状节理玄武岩变形各向异性研究[硕士学位论文][D]. 武汉：长江科学院，2010.(LU Yiran. Deformation anisotropy study of columnar jointed rock masses[M. S. Thesis][D]. Wuhan：Changjiang River Scientific Research Institute，2010.(in Chinese))
[4]	张宜虎，周火明，钟作武，等. YXSW-12现场岩体真三轴试验系统及其应用[J]. 岩石力学与工程学报，2011，30(11)：2 312-2 320. (ZHANG Yihu，ZHOU Huoming，ZHONG Zuowu，et al. In situ rock masses triaxial test system YXSW-12 and its application[J]. Chinese Journal of Rock Mechanics and Engineering，2011，30(11)：2 312-2 320.(in Chinese))
[5]	江权，冯夏庭，樊义林，等. 柱状节理玄武岩各向异性特性的调查与试验研究[J]. 岩石力学与工程学报，2013，32(12)：2 527-2 535. (JIANG Quan，FENG Xiating，FAN Yilin，et al. Survey and laboratory study of anisotropic properties for columnar jointed basaltic rock mass[J]. Chinese Journal of Rock Mechanics and Engineering，2013，32(12)：2 527-2 535.(in Chinese))
[6]	宁宇，徐卫亚，郑文棠，等. 柱状节理岩体随机模拟及其表征单元体尺寸研究[J]. 岩石力学与工程学报，2008，27(6)：1 202-1 208. (NING Yu，XU Weiya，ZHENG Wentang，et al. Study of random simulation of columnar jointed rock mass and its representative elementary volume scale[J]. Chinese Journal of Rock Mechanics and Engineering，2008，27(6)：1 202-1 208.(in Chinese))
[7]	朱道建，杨林德，蔡永昌. 柱状节理岩体各向异性特性及尺寸效应研究[J]. 岩石力学与工程学报，2009，28(7)：1 405-1 414.(ZHU Daojian，YANG Linde，CAI Yongchang. Research on anisotropic characteristics and size effect of columnar jointed rock mass[J]. Chinese Journal of Rock Mechanics and Engineering，2009，28(7)：1 405- 1 414.(in Chinese))
[8]	YAN L，XU W Y，WANG R B，et al. Numerical simulation of the anisotropic properties of a columnar jointed rock mass under triaxial compression[J]. Engineering Computations，2018，35(4)：1 788-1 804.
[9]	MENG Q X，WANG H L，XU W Y. Numerical homogenization study on the effects of columnar jointed structure on the mechanical properties of rock mass[J]. International Journal of Rock Mechanics and Mining Sciences，2019，124：104127.
[10]	刘海宁，王俊梅，王思敬. 白鹤滩柱状节理岩体真三轴模型试验研究[J]. 岩土力学，2010，31(增1)：163-171.(LIU Haining，WANG Junmei，WANG Sijing. Experimental research of columnar jointed basalt with true triaxial apparatus at Baihetan Hydropower Station[J]. Rock and Soil Mechanics，2010，31(Supp.1)：163-171.(in Chinese))
[11]	JI H，ZHANG J C，XU W Y，et al. Experimental investigation of the anisotropic mechanical properties of a columnar jointed rock mass：observations from laboratory-based physical modelling[J]. Rock Mechanics and Rock Engineering，2017，50(7)：1 919-1 931.
[12]	LIN Z N，XU W Y，WANG W，et al. Determination of strength and deformation properties of columnar jointed rock mass using physical model tests[J]. KSCE Journal of Civil Engineering，2018，22(9)： 3 302-3 311.
[13]	JIN C Y，LI S G，LIU J P. Anisotropic mechanical behaviors of columnar jointed basalt under compression[J]. Bulletin of Engineering Geology and the Environment，2018，77(1)：317-330.
[14]	柯志强，王环玲，徐卫亚，等. 含横向节理的柱状节理岩体力学特性试验研究[J]. 岩土力学，2019，40(2)：660-667.(KE Zhiqiang，WANG Huanling，XU Weiya，et al. Experimental study of mechanical behaviour of artificial columnar jointed rock mass containing transverse joints[J]. Rock and Soil Mechanics，2019，40(2)：660-667.(in Chinese))
[15]	ZHU Z D，QUE X C，NIU Z H，et al. Model test study on the anisotropic characteristics of columnar jointed rock mass[J]. Symmetry，2020，12(9)：1 528.
[16]	QUE X C，ZHU Z D，NIU Z H，et al. Estimating the strength and deformation of columnar jointed rock mass based on physical model test[J]. Bulletin of Engineering Geology and the Environment，2020，80(2)：1 557-1 570.
[17]	LU W B，ZHU Z D，HE Y X，et al. Strength characteristics and failure mechanism of a columnar jointed rock mass under uniaxial，triaxial，and true triaxial confinement[J]. Rock Mechanics and Rock Engineering，2021，54(5)：2 425-2 439.
[18]	阙相成，朱珍德，牛子豪，等. 不同截面柱状节理岩体变形及强度各向异性研究[J]. 岩土力学，2021，42(9)：2 416-2 426.(QUE Xiangcheng，ZHU Zhende，NIU Zihao，et al. Deformation and strength anisotropy of columnar jointed rock mass with different cross-sectional shapes[J]. Rock and Soil Mechanics，2021，42(9)：2 416-2 426.(in Chinese))
[19]	XIA Y J，ZHANG C Q，ZHOU H，et al. Mechanical behavior of structurally reconstructed irregular columnar jointed rock mass using 3D printing[J]. Engineering Geology，2020，268：105509.
[20]	XIA Y J，ZHANG C Q，ZHOU H，et al. Study on model structure and mechanical anisotropy of columnar jointed rock mass based on three-dimensional printing method[J]. International Journal of Geomechanics，2020，20(11)：04020208.
[21]	LIN Z N，XU W Y，WANG H L，et al. Anisotropic characteristic of irregular columnar-jointed rock mass based on physical model test[J]. KSCE Journal of Civil Engineering，2017，21(5)：1 728-1 734.
[22]	黄巍，肖维民，田梦婷，等. 不规则柱状节理岩体力学特性模型试验研究[J]. 岩土力学，2020，41(7)：2 349-2 359.(HUANG Wei，XIAO Weimin，TIAN Mengting，et al. Model test study on mechanical characteristics of irregular columnar jointed rock mass[J]. Rock and Soil Mechanics，2020，41(7)：2 349-2 359.(in Chinese))
[23]	中华人民共和国行业标准编写组. SL/T264—2020 水利水电工程岩石试验规程[S]. 北京：中国水利水电出版社，2020.(The Professional Standards Compilation Group of People?s Republic of China. SL/ T264－2020 Code for rock tests in water and hydropower projects[S]. Beijing：China Water and Power Press，2020.(in Chinese))
[24]	RAMANURTHY T. Strength and modulus responses of anisotropic rocks[C]// Comprehensive Rock Engineering. Oxford：Pergamon Press，1993：313-329.
[25]	KWASNIEWSKI M A. Mechanical behavior of anisotropic rocks[C]// Comprehensive Rock Engineering. Oxford：Pergamon Press，1993：285-312.