加筋土挡墙压实应力数值模拟分析

doi:10.13722/j.cnki.jrme.2019.0901

Abstract
Figure/Table
References (0)
Related Citation (15)

Download: PDF (2395 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract Based on the literature numerical modeling type II(2D)，a three-dimensional dynamic compaction model considering different load widths is proposed and verified. At the same time，a calculation formula of compaction stress retaining wall considering Chinese norms was introduced，and the three-dimensional dynamic load moving mode was discussed. First，through the selection of equivalent load loading method，the influence of different load widths on the retaining wall is discussed according to the strain of the reinforcement，the lateral deformation of the panel，the soil pressure behind the wall and the compressive stress distribution of the base. And the depth of compaction stress is used to provide verification for the calculation formula. The analysis shows that the calculation method of the equivalent load movement method is closer to the measured value than the second and third methods；the strain change trend of each layer is basically the same，showing two peaks，the first one is located at the back of the panel，the second place Peak load point due to shear strain concentration(potential fracture surface)；the type of compaction modeling does not affect the distribution of vertical compressive stress at the bottom of the wall；only when the additional load of the retaining wall exceeds the compaction load，the compaction stress the effect will dissipate. At the same time，for different compaction stresses，ribs and soil properties，the corresponding compaction depth is also different；The strip load width(B) has obvious impaction on the internal stress prediction of the retaining wall.

Key words： soil mechanics reinforced earth retaining wall numerical model compaction stress load width

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	LI Lihua
	LI Hang
	XIAO Henglin
	LIU Yiming
	HU Zhi
	YAN Han

Cite this article:

LI Lihua,LI Hang,XIAO Henglin, et al. Numerical simulation of compaction stress for the analysis of reinforced earth retaining wall[J]. , 2020, 39(S1): 3130-3138.

URL:

https://rockmech.whrsm.ac.cn/EN/10.13722/j.cnki.jrme.2019.0901 OR https://rockmech.whrsm.ac.cn/EN/Y2020/V39/IS1/3130

[1]	EHRLICH M，MITCHELL J K. Working stress design method for reinforced soil walls[J]. Journal of Geotechnical Engineering，1994，121(4)：625–645.
[2]	BATHURST R J，NERNHEIM A，WALTERS D L，et al. Influence of reinforcement stiffness and compaction on the performance of four geosynthetic-reinforced soil walls[J]. Geosynthetics International，2009，16(1)：43–56.
[3]	EHRLICH M，MIRMORADI S H，SARAMAGO R P. Evaluation of the effect of compaction on the behavior of geosynthetic-reinforced soil walls[J]. Geotextiles and Geomembranes，2012，34：108–115.
[4]	MIRMORADI S H，EHRLICH M. Numerical evaluation of the behavior of grs walls with segmental block facing under working stress conditions[J]. Journal of Geotechnical and Geoenvironmental Engineering，2014，141(3)：04014109.1–04014109.8.
[5]	杨广庆. 加筋挡土墙合理设计方法的探讨[J]. 长江科学院院报，2014，31(3)：11–18.(YANG Guangqing. Discussion on reasonable design method for reinforced earth retaining wall[J]. Journal of Yangtze River Scientific Research Institute，2014，31(3)：11–18.(in Chinese))
[6]	李广信. 关于土工合成材料加筋设计的若干问题[J]. 岩土工程学报，2013，35(4)：605–610.(LI Guangxin. Some problems in design of geosynthetic-reinforced soil structures[J]. Chinese Journal of Geotechnical Engineering，2013，35(4)：605–610.(in Chinese))
[7]	徐超，罗玉珊. 加筋土挡墙设计方法对比与实例分析[J]. 水文地质工程地质，2011，38(5)：43–47.(XU Chao，LUO Yushan. Comparison of design methods for reinforced soil wall and example analysis[J]. Hydrogeology and Engineering Geology，2011，38(5)：43–47.(in Chinese))
[8]	中华人民共和国国家标准编写组. GB/T 50290—2014 土工合成材料应用技术规范[S]. 北京：中国计划出版社，2015.(The National Standards Compilation Group of People?s Republic of China. GB/T 50290—2014 Technical standard for applications of geosynthetics[S]. Beijing：China Planning Press，2015.(in Chinese))
[9]	BERG R R，CHRISTOPHER B R，SAMTANI N C. FHWA-NHI-10-024 Design and construction of mechanically stabilized earth walls and reinforced soil slopes[S]. Washington，D.C：National Highway Instiute Federal Highway Adminstration and U.S. Department of Transportation，2009.
[10]	JENNINGS K，NAUGHTON P J. BS 8006—1：2010 Code of practice for strengthened/reinforced soils and other fills[S]. London，UK：British Standards Institution，2010.
[11]	HERRMANN L R. Numerical analysis of reinforced soil systems[J]. Forest Ecology and Management，2006，234(Supp. l)：117.
[12]	KERRY R R. A review of the behavior of reinforced soil walls, Keynote Lecture[J]. Proceedings of International Symp. on Earth Enforcement Practice，1992.
[13]	HO S K，ROWE R K. Effect of wall geometry on the behaviour of reinforced soil walls[J]. Geotextiles and Geomembranes，1996，14(10)：521–541.
[14]	LIU H，WON M S. Long-term reinforcement load of geosynthetic-reinforced soil retaining walls[J]. Journal of Geotechnical and Geoenvironmental Engineering，2009，135(7)：875–889.
[15]	GU M，COLLIN J G，HAN J，et al. Numerical analysis of instrumented mechanically stabilized gabion walls with large vertical reinforcement spacing[J]. Geotextiles and Geomembranes，2017，45(4)：294–306.
[16]	HATAMI K，BATHURST R J. Development and verification of a numerical model for the analysis of geosynthetic reinforced-soil segmental walls[J]. Journal of Geotechnical Engineering，2005，42 (4)：1 066–1 085.
[17]	E. Guler M H M D . Numerical analysis of reinforced soil-retaining wall structures with cohesive and granular backfills[J]. Geosynthetics International，2007，14(6)：330–345.
[18]	AMBAUEN S，LESHCHINSKY B，XIE Y，et al. Service-state behavior of reinforced soil walls supporting spread footings：A parametric study using finite-element analysis[J]. Geosynthetics International，2015，23(3)：1–15.
[19]	YU Y，BATHURST R J，ALLEN T M . Numerical modelling of two full-scale reinforced soil wrapped-face walls[J]. Geotextiles and Geomembranes，2017，45(4)：237–249.
[20]	MIRMORADI S H，EHRLICH M. Modeling of the compaction-induced stress on reinforced soil walls[J]. Geotextiles and Geomembranes，2015，43(1)：82–88.
[21]	SCOTLAND I，DIXON N，FROST M，et al. Modelling deformation during the construction of wrapped geogrid-reinforced structures. Geosynth[J]. Geosynthetics International，2016，23(3)：219–232.
[22]	MIRMORADI S H，EHRLICH M. Modeling of the compaction-induced stress on reinforced soil walls[J]. Geotextiles and Geomembranes，2015，43(1)：82–88.
[23]	MIRMORADI S H，EHRLICH M. Compaction-induced stress: Numerical Modeling[C]// XV Panamerican Conference on Soil Mechanics and Geotechnical Engineering. [S. l.]：[s. n.]，2015.
[24]	YU Y，BATHURST R J，ALLEN T M. Numerical Modeling of the SR-18 Geogrid Reinforced Modular Block Retaining Walls[J]. Journal of Geotechnical and Geoenvironmental Engineering，2016，142(5)：04016003.
[25]	焦占拴. 《土工合成材料应用技术规范》(GB50290—98)简介[J]. 施工技术，1999，(4)：53–54.(JIAO Zhanshuan. Introduction of "Technical Specifications for Geosynthetics" (GB50290—98)[J]. Construction Technology，1999，(4)：53–54.(in Chinese))
[26]	WU J T H，PHAM T Q. An analytical model for evaluation of compaction-induced stresses in a reinforced soil mass[J]. International Journal of Geotechnical Engineering，2010，4(4)：549–556.
[27]	SEED R M. Compaction-induced stresses and deflections on earth structure[Ph. D. Thesis][D]. Berkeley，CA：University of California，1983.
[28]	DUNCAN J M，SEED R B. Compaction-induced earth pressures under Ko-conditions[J]. Journal of Geotechnical Engineering，1986，112(1)：1–22.