基于质量分级的岩体强度参数统计

摘要
图/表
参考文献
相关文章 (15)

全文: PDF (0 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要整理长江科学院历年来现场岩石力学试验成果和《岩基抗剪强度参数》一书收集的现场岩体抗剪强度试验资料，从中筛选出岩体抗剪强度试验值样本186个，其中I级岩体7个，II级岩体41个，III级岩体46个，IV级岩体76个，V级岩体16个；分别统计各级别岩体强度参数试验值，提出各级别岩体强度参数试验值取值范围，将此取值范围与《工程岩体分级标准》所给取值范围对比。结果表明，《工程岩体分级标准》所给岩体抗剪强度参数偏低。对40余个典型工程的前期勘测资料进行整理，从中筛选出岩体抗剪强度地质建议值样本110个，其中I级岩体12个，II级岩体22个，III级岩体28个，IV级岩体30个，V级岩体18个；分级进行统计，提出各级别岩体强度参数地质建议值范围，将地质建议值范围与《水利水电工程地质勘察规范》所给取值范围对比，结果表明两者基本一致。研究成果一方面为现有规程规范修订提供依据，另外还能深化工程人员对岩体强度的认识，为今后更合理确定岩体强度参数提供支撑。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章

关键词 ：岩石力学, 强度, 质量分级, 地质建议值, 统计分析

Abstract：186 samples of in situ rock masses strength parameters testing values，which include 7 samples of class I，41 samples of class II，46 samples of class III，76 samples of class IV，16 samples of class V，are screened out based on in-situ testing datum of CRSRI and information collected in Rock Masses Strength Parameters. By statistical analyzing，the scope of strength parameters of each class is given out，and the scopes are compared with the suggesting values in Standard for engineering classification of rock masses. Result indicates that the suggesting values in Standard for Engineering Classification of Rock Masses is much lower and needs to be corrected. 110 samples of geological suggestion values，which include 12 of class I，22 of class II，28 of class III，30 of class IV，18 of class V，are also screened out based on engineering geological datum of above 40 typical projects. The scope of geological suggestion values of each class is then given out，and compared with the values in Code for Engineering Geological Investigation of water resources and hydropower. Result indicates that the two scopes consist with each other well. Researching achievements can not only be helpful in standards or codes modification，but also be meaningful in enhancing the understanding of rock masses strength for engineers.

Key words： rock mechanics strength classification geological suggestion value statistical analyzing

收稿日期: 2010-10-06

引用本文:

张宜虎，周火明，邬爱清，钟作武，秦磊. 基于质量分级的岩体强度参数统计[J]. 岩石力学与工程学报, 2011, 30(S2): 3825-3830.
ZHANG Yihu，ZHOU Huoming，WU Aiqing，ZHONG Zuowu，QIN Lei. STATISTICAL ANALYZING OF ROCK MASSES STRENGTH PARAMETERS BASED ON CLASSIFICATION. , 2011, 30(S2): 3825-3830.

链接本文:

http://www.rockmech.org/CN/Y2011/V30/IS2/3825

[2]	周火明，盛谦，熊诗湖，等. 复杂岩体力学参数取值研究[J]. 岩石力学与工程学报，2002，21(增)：2 045-2 048.(ZHOU Huoming，SHENG Qian，XIONG Shihu，et al. Study on selection of mechanical parameters for complicated rock masses[J]. Chinese Journal of Rock Mechanics and Engineering，2002，21(Supp.)：2 045-2 048.(in Chinese)) " target="_blank">
[4]	张志强. 非贯通裂隙岩体破坏细观特征及其宏观力学参数确定方法[J]. 岩石力学与工程学报，2009，28(9)：1 945-1 950.(ZHANG Zhiqiang. Mesomechanical failure characteristics and macromechanical parameter estimation of fractured rock mass with non-penetrative fissures[J]. Chinese Journal of Rock Mechanics and Engineering，2009，28(9)：1 945-1 950.(in Chinese)) " target="_blank">
[7]	杨强，陈英儒，刘耀儒，等. 岩体等效强度参数确定的理论和方法[J]. 岩石力学与工程学报，2008，27(10)：1 993-1 999.(YANG Qiang，CHEN Yingru，LIU Yaoru，et al. Theory and method of determining equivalent strength parameters of rock mass[J]. Chinese Journal of Rock Mechanics and Engineering，2008，27(10)：1 993- 1 999.(in Chinese)) " target="_blank">
[9]	陈卫忠，杨建平，邹喜德，等. 裂隙岩体宏观力学参数研究[J]. 岩石力学与工程学报，2008，27(8)：1 569-1 575.(CHEN Weizhong，YANG Jianping，ZOU Xide，et al. Research on marcomechanical parameters of fractured rock masses[J]. Chinese Journal of Rock Mechanics and Engineering，2008，27(8)：1 569-1 575.(in Chinese)) " target="_blank">
[12]	MIN K B，JING L R. Numerical determination of the equivalent elastic compliance tensor for fractured rock masses using the distinct element method[J]. International Journal of Rock Mechanics and Mining Sciences，2003，40(5)：795-816. " target="_blank">
[14]	中华人民共和国国家标准编写组. GB50021—2001 岩土工程勘察规范[S]. 北京：中国计划出版社，2009.(The National Standards Compilation Group of People?s Republic of China. GB50021—2001 Code for geotechnical engineering investigation[S]. Beijing：China Planning Press，2009.(in Chinese)) " target="_blank">
[16]	HOEK E，BROWN E. Practical estimates of rock mass strength[J]. International Journal of Rock Mechanics and Mining Sciences，1997，34(8)：1 165-1 187. " target="_blank">
[23]	中华人民共和国国家标准编写组. GB50487—2008 水利水电工程地质勘察规范[S]. 北京：中国计划出版社，2009.(The National Standards Compilation Group of People?s Republic of China. GB 50487—2008 Code for engineering geological investigation of water resources and hydropower[S]. Beijing：China Planning Press，2009.(in Chinese)) " target="_blank">
[1]	董学晟，田野，邬爱清. 水工岩石力学[M]. 北京：中国水利水电出版社，2004：2-4.(DONG Xuecheng，TIAN Ye，WU Aiqing. Rock mechanics in hydraulic engineering[M]. Beijing：China Water Power Press，2004：2-4.(in Chinese)) " target="_blank">
[3]	汪斌，朱杰兵，邬爱清，等. 高应力下岩石非线性强度特性的试验验证[J]. 岩石力学与工程学报，2010，29(3)：542-548.(WANG Bin，ZHU Jiebing，WU Aiqing，et al. Experimental validation of nonlinear strength property of rock under high geostress[J]. Chinese Journal of Rock Mechanics and Engineering，2010，29(3)：542-548.(in Chinese))
[6]	苏永华，封立志，李志勇，等. Hoek-Brown准则中确定地质强度指标因素的量化[J]. 岩石力学与工程学报，2009，28(4)：679-686.(SU Yonghua，FENG Lizhi，LI Zhiyong，et al. Qualification of elements for geological strength index in Hoek-Brown criterion[J]. Chinese Journal of Rock Mechanics and Engineering，2009，28(4)：679-686.(in Chinese))
[8]	张斌，聂德新. 利用岩石结构面网络模拟计算岩体带宽连通率及岩体强度参数[J]. 中国地质灾害与防治学报，2003，14(4)：90-94. (ZHANG Bin，NIE Dexin. Computing joint persistence ratio and strength of rock mass by using rock discontinuity network simulation[J]. The Chinese Journal of Geological Hazard and Control，2003，14(4)：90-94.(in Chinese)) " target="_blank">
[11]	ODA M. An equivalent continuum model for coupled stress and fluid flow analysis in jointed rock masses[J]. Water Resource Research，1986，22(13)：1 845-1 856. " target="_blank">
[13]	陈胜宏，王鸿儒，熊文林. 节理岩体的数值分析和模型试验研究[J]. 岩土工程学报，1989，11(3)：22-30.(CHEN Shenghong，WANG Hongru，XIONG Wenlin. Numerical analyzing and model testing research on jointed rock masses[J]. Chinese Journal of Geotechnical Engineering，1989，11(3)：22-30.(in Chinese))
[18]	巫德斌，徐卫亚. 基于Hoek-Brown准则的边坡开挖岩体力学参数研究[J]. 河海大学学报：自然科学版，2005，33(1)：89-93.(WU Debin，XU Weiya. Research on excavated slope rock masses mechanical parameters based on Hoek-Brown criterion[J]. Journal of Hohai University：Natural Science，2005，33(1)：89-93.(in Chinese)) " target="_blank">
[5]	李同录. 节理岩体力学参数的选取与应用[J]. 岩石力学与工程学报，2004，23(13)：2 182-2 186.(LI Tonglu. Determination and application of mechanical parameters for jointed rock masses[J]. Chinese Journal of Rock Mechanics and Engineering，2004，23(13)： 2 182-2 186.(in Chinese)) " target="_blank">
[10]	向波，周立荣，马建林. 基于岩体结构面分级的抗剪强度确定法[J]. 岩石力学与工程学报，2008，27(增2)：3 547-3 552.(XIANG Bo，ZHOU Lirong，MA Jianlin. Determination method of shear strength based on rock joints classification[J]. Chinese Journal of Rock Mechanics and Engineering，2008，27(Supp.2)：3 547-3 552.(in Chinese)) " target="_blank">
[15]	中国人民共和国行业标准编写组. SL264—2001 水利水电工程岩石试验规程[S]. 北京：中国水利水电出版社，2001.(The Professional Standards Compilation Group of People?s Republic of China. SL264—2001 Specifications for rock tests in water conservancy and hydroelectric engineering[S]. Beijing：China Water Power Press，2001.(in Chinese)) " target="_blank">
[17]	SONMEZ H，ULUSAY R. Modifications to the geological strength index(GSI) and their applicability to stability of slopes[J]. International Journal of Rock Mechanics and Mining Sciences，1999，36(5)：743-760. " target="_blank">
[21]	汪小刚，董育坚. 岩基抗剪强度参数[M]. 1版. 北京：中国水利水电出版社，2010：58-103.(WANG Xiaogang，DONG Yujian. Shear strength parameters of rock foundation[M]. 1st ed. Beijing：China Water Power Press，2010：58-103.(in Chinese)) " target="_blank">
[19]	AL-JBORI A，ZHANG Y X. Most used rock mass classifications for underground opening[J]. American Jourmal of Engineering and Applied Sciences，2010，3(2)：403-411. " target="_blank">
[20]	林韵梅. 岩石分级的理论与实践[M]. 北京：冶金工业出版社，1996：10-15.(LIN Yunmei. Theory and practice of rock mass classification[M]. Beijing：China Metallurgical Industry Press，1996：10-15.(in Chinese)) " target="_blank">
[22]	中华人民共和国国家标准编写组. GB50218—94 工程岩体分级标准[S]. 北京：中国计划出版社，1995.(The National Standards Compilation Group of People?s Republic of China. GB50218—94 Standard for engineering classification of rock masses[S]. Beijing：China Planning Press，1995.(in Chinese)) " target="_blank">