随机形貌岩石节理剪切数值模拟和非线性剪胀模型

摘要
图/表
参考文献
相关文章 (15)

全文: PDF (868 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要采用满足正态分布的随机函数，构造岩石节理剖面的形貌，为研究受剪岩石节理的细观剪切特性和宏观剪胀效应提供研究基础。利用UDEC软件，基于CY微段节理模型，开发随机形貌岩石节理直剪特性的数值分析程序，采用CY微段节理模型的细观剪切力学参数，探讨微段节理的细观剪切特性和岩石节理的宏观剪切响应，提出节理抗剪强度参数与节理面粗糙度系数JRC之间的拟合关系。得到如下结论：JRC越大，岩石节理的宏观剪切峰值强度和剪胀角随之增大，而峰值剪切位移与JRC成反变化关系；随着法向应力的增加，节理的剪胀效应逐渐减弱；这些数值结论得到模型实验的充分验证。微段节理的细观切向爬坡和剪胀效应是岩石节理产生宏观剪胀的细观力学机制。通过对随机形貌岩石节理的宏观剪胀数值曲线性态进行分析，提出能考虑节理粗糙度JRC和法向应力影响的非线性剪胀本构模型，该模型较好描述了受剪岩石节理的剪缩段和剪胀段。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章

关键词 ：岩石力学, 岩石节理, 剪切, 剪胀模型, 数值模拟

Abstract：Using random function obeying normal distribution to construct rock joint profile morphology， a kind of simulation method of rock joint profile provides the search foundation for microscopic shear characteristics of rock joint and the effects of macroscopical shear dilatation. Using UDEC software，based on improved CY joint model，a numerical analysis program for direct shear characteristics of random morphology rock joint was developed. Microscopic shear characteristics of micro-segment joint and macroscopic shear response of rock joint are discussed by using microscopic shear mechanical parameters of CY micro-segement joint model. The fitting relationships between joint shear strength parameters and joint roughness coefficient(JRC) are proposed. As the results，the greater the JRC is，the greater the peak shear strength and dilatancy angle of rock joints are. But the peak shear displacement is inversely related to JRC. With the increase of the normal stress，the dilatancy effect of joint is gradually weakened；these simulation results have been fully verified by modeling experiment. The microscopic tangential climbing and dilatancy effect of micro-segment joint are the meso-scopic mechanical mechanism of macroscopic shear dilatation of rock joints. Through the analysis of macroscopic shear dilatation numerical curves of random morphology rock joints，a nonlinear shear dilation constitutive model considering the effect of JRC and normal stress is proposed；the model can well describe shearing shrinkage and the shear dilatation during shearing process of rock joint.

Key words： rock mechanics rock joint shear shear dilatancy model numerical simulation

收稿日期: 2012-09-17

引用本文:

赵延林1，2，万文1，2，王卫军1，2，王敏1，2，彭青阳1，2. 随机形貌岩石节理剪切数值模拟和非线性剪胀模型[J]. 岩石力学与工程学报, 2013, 32(8): 1666-1676.
ZHAO Yanlin1，2，WAN Wen1，2，WANG Weijun1，2，WANG Min1，2，PENG Qingyang1，2. SHEAR NUMERICAL SIMULATION OF RANDOM MORPHOLOGY ROCK JOINT AND NONLINEAR SHEAR DILATANCY MODEL. , 2013, 32(8): 1666-1676.

链接本文:

http://www.rockmech.org/CN/Y2013/V32/I8/1666

[2]	李博，蒋宇静. 岩石单节理面剪切与渗流特性的试验研究与数值分析[J]. 岩石力学与工程学报，2008，27(12)：2 431-2 439.(LI Bo，JIANG Yujing. Experimental study and numerical analysis of shear and flow behaviors of rock with single joint[J]. Chinese Journal of Rock Mechanics and Engineering，2008，27(12)：2 431-2 439.(in Chinese))
[3]	沈明荣，张清照. 规则齿型结构面剪切特性的模型试验研究[J]. 岩石力学与工程学报，2010，29(4)：713-719.(SHEN Mingrong，ZHANG Qingzhao. Experimental study of shear deformation characteristics of rock mass discontinuities[J]. Chinese Journal of Rock Mechanics and Engineering，2010，29(4)：713-719.(in Chinese))
[4]	JING L，STEPHANSSON O，NORDLUND E. Study of rock joints under cyclic loading conditions[J]. Rock Mechanics and Rock Engineering，1993，26(3)：215-232. " target="_blank">
[6]	SIMON R. Analysis of fault-slip mechanics in hard rock mining[Ph. D Thesis][D]. Montreal：McGill University，1999：118-120. " target="_blank">
[7]	肖卫国，兑关锁，陈铁林，等. 剪胀和破坏耦合的节理岩体本构模型的研究[J]. 岩石力学与工程学报，2009，28(12)：2 535-2 543. (XIAO Weiguo，DUI Guansuo，CHEN Tielin，et al. A study of constitutive model coupling dilatancy and degradation for jointed rock[J]. Chinese Journal of Rock Mechanics and Engineering，2009，28(12)：2 535- 2 543.(in Chinese)) " target="_blank">
[8]	唐志成，夏才初，肖素光. 节理剪切应力-位移本构模型及剪胀现象分析[J]. 岩石力学与工程学报，2011，30(5)：917-925.(TANG Zhicheng，XIA Caichu，XIAO Suguang. Constitutive model for joint shear stress-displacement and analysis of dilation[J]. Chinese Journal of Rock Mechanics and Engineering，2011，30(5)：917-925.(in Chinese))
[10]	JIANG Y J，LI B，YAMASHITA Y J . Simulation of cracking near a large underground cavern in a discontinuous rock mass using the expanded distinct element method[J]. International Journal of Rock Mechanics and Mining Sciences，2009，46(1)：97-106
[11]	ITASCA Consulting Group，Inc.. UDEC and 3DEC manual[R]. [S. l.]：ITASCA Consulting Group，Inc.，2008. " target="_blank">
[12]	BARTON N. Review of a new shear strength criterion for rock joints[J]. Engineering Geology，1973，7(4)：579-602. " target="_blank">
[14]	夏才初，孙宗颀. 工程岩体节理力学[M]. 上海：同济大学出版社， 2001：68-87.(XIA Caichu，SUN Zongqi. Engineering rock mass joints mechanics[M]. Shanghai：Tongji University Press，2001：68-87.(in Chinese)) " target="_blank">
[15]	BARRY B H，BRADY H G. Rock mechanics for underground mining[M]. [S. l.]：Springer，2004：132-141. " target="_blank">
[16]	CUNDALL P A，HART R D. Analysis of block test No. 1. Inelastic rock mass behavior：phase 2—a characterization of joint behavior (final report)[R]. [S. l.]：[s. n.]，1984. " target="_blank">
[17]	MASIVARS D. Water inflow into excavations in fractured rock—a three-dimensional hydro-mechanical numerical study[J]. International Journal of Rock Mechanics and Mining Sciences，2006，43(5)：705-725. " target="_blank">
[19]	夏才初，唐志成，宋英龙，等. 节理峰值剪切位移及其影响因素分析[J]. 岩土力学，2011，32(6)：1 654-1 658.(XIA Caichu，TANG Zhicheng，SONG Yinglong，et al. Analysis of relationship between joint peak shear displacement and its influence factors[J]. Rock and Soil Mechanics，2011，32(6)：1 654-1 658.(in Chinese))
[21]	LOPEZA P，RISSA J，ARCHAMBAULT G. An experimental method to link morphological properties of rock fracture surfaces to their mechanical properties[J]. International Journal of Rock Mechanics and Mining Sciences，2003，40(6)：947-954.
[23]	张鹏. 裂隙表面几何形态对裂隙介质力学、水力学特性的影响规律研究[博士学位论文][D]. 西安：西安理工大学，2007.(ZHANG Peng. Research on influence of the morphology of the joint surface on the deformation and seepage behaviors of single joint rock mass[Ph. D. Thesis][D]. Xi?an：Xi?an University of Technology，2007.(in Chinese)) " target="_blank">
[22]	GENTIER S，LAMONTAGNE E，ARCHAMBAULT G. et al. Anisotropy of flow in a fracture undergoing shear and its relationship to the direction of shearing and injection pressure[J]. International Journal of Rock Mechanics and Mining Sciences，1997，34(3/4)：94. " target="_blank">
[13]	TSE R，CRUDEN D M. Estimating joint roughness coefficients[J]. International Journal of Rock Mechanics and Mining Sciences and Geomechanics Abstracts，1979，16(4)：303-307. " target="_blank">
[20]	孙宗颀. 不连续面应力-变形性质的研究[J]. 岩石力学与工程学报，1987，6(4)：287-300.(SUN Zongqi. Study of stress-relative displacement properties of discontinuities[J]. Chinese Journal of Rock Mechanics and Engineering，1987，6(4)：287-300.(in Chinese)) " target="_blank">
[1]	李海波，刘博，冯海鹏，等. 模拟岩石节理试件剪切变形特征和破坏机制研究[J]. 岩土力学，2008，29(7)：1 741-1 752.(LI Haibo，LIU Bo，FENG Haipeng，et al. Study of deformability behaviour and failure mechanism by simulating rock joints sample under different loading conditions[J]. Rock and Soil Mechanics，2008，29(7)：1 741- 1 752.(in Chinese)) " target="_blank">
[25]	LADANYI B，ARCHAMBAULT G. Simulation of shear behaviour of a jointed rock mass[C]// Proceedings of the 11th Symposium on Rock Mechanics(AIME). [S. l.]：[s. n.]，1970：105-125. " target="_blank">
[27]	巩磊，曾联波，苗凤彬，等. 分形几何方法在复杂裂缝系统描述中的应用[J] .湖南科技大学学报：自然科学版，2012，27(4)：6-10. (GONG Lei，ZENG Lianbo，MIAO Fengbin，et al. Application of fractal geometry on the description of complex fracture systems[J]. Journal of Huanan University of Science and Technology：Natural Science，2012，27(4)：6-10.(in Chinese))
[5]	BARTON N. Review of a new shear strength criterion for rock joints[J]. Engineering Geology，1973，7(4)：287-332. " target="_blank">
[9]	张庆伦，赵延林，刘杰，等. 剪切作用下类岩石断续裂纹岩桥破裂实验与数值分析[[J]. 矿业工程研究，2012，27(2)：31-36.(ZHANG Qinglun，ZHAO Yanlin，LIU Jie，et al. Experimental and simulation analysis of fracture of rock bridge under shear pressure[J]. Mineral Engineering Research，2012，27(2)：31-36.(in Chinese))
[18]	ASADOLLAHI P. Stability analysis of a single three dimensional rock block：effect of dilatancy and high-velocity water jet impact[Ph. D Thesis]. Texas：University of Texas at Austin，2009. " target="_blank">
[24]	杜守继，朱建栋，职洪涛. 岩石节理经历不同变形历史的剪切试验研究[J]. 岩石力学与工程学报，2006，25(1)：56-60.(DU Shouji，ZHU Jiandong，ZHI Hongtao. Shear tests on rock joints under differentshear deformation histories[J]. Chinese Journal of Rock Mechanics and Engineering，2006，25(1)：56-60.(in Chinese))
[28]	王敏，万文，赵延林. 双轴拉伸条件下张开型裂纹的数值模拟[J]. 矿业工程研究，2013，28(1)：7-10. (WANG Min，WAN Wen，ZHAO Yanlin. Numerical simulation calculation of model I crack under biaxial tension[J]. Mineral Engineering Research，2013，28(1)：7-10.(in Chinese))
[26]	LEICHNITZ W. Mechanical properties of rock joints[J]. International Journal of Rock Mechanics and Mining Sciences and Geomechanics Abstracts，1985，22(5)：81-91. " target="_blank">