基于面积和应力修正的直剪试验数据分析

摘要
图/表
参考文献
相关文章 (15)

全文: PDF (278 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要直剪试验具有方便、经济的优点，被广泛应用，提高直剪试验数据的可靠性具有重要意义。在总结前人研究成果的基础上，将直剪试验结果数据的修正分为2类：单点面积修正方法和多点面积修正方法。通过简化受剪切土体受力物理模型，提出基于面积修正和正应力修正的单点面积应力修正方法。结果表明：该方法是有效、可靠的，修正后的强度指标要大于其他2种方法，并且对3种方法的实际运用进行简单探讨。在推导过程中，提出面积修正系数和正应力修正系数。修正系数结果表明：随着剪切位移的增加，有效剪切面上的剪应力大于实测值；有效剪切面积上的正应力小于施加的竖向应力，并且随着剪切位移的增加而逐渐减小；非有效剪切面上的正应力呈逐渐增大趋势。由于直剪试验本身的缺陷，使得其修正后的强度参数与三轴试验结果存在一定差别。提出的单点面积应力修正方法提高了利用直剪试验获取土体抗剪强度参数的可靠性和准确性。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章

关键词 ：土力学, 直剪试验, 抗剪强度参数修正, 面积修正, 应力修正

Abstract：The direct shear test(DST) is widely used because of its convenience and economy. It is of great significance to improve the reliability of the DST data. Based on the summary of former test results，the DST data correction is divide into two types，single-point area correction method and multipoint area correction method. By simplifying the force analysis model of shearing soil，an area-stress correction(ASC) method is presented. The results show that this method is effective and reliable. The corrected strength parameters are more than those of other two methods. A simple discussion on the practical application of these methods is done. In the derivation process，the area correction coefficient and the normal stress correction coefficient are put forward. The correction coefficients of ASC show that the shear stress on the effective shear plane is greater than the measured results；and the normal stress on the effective shear area is less than the applied vertical stress with the shear displacement increasing. The normal stress on the non-effective shear plane is increasing. Since the disadvantages and defects of the DST，there are some differences between the corrected strength parameters and those of triaxial test. The mathematical analysis and test results indicate that ASC method is effective and reliable. It improves the accuracy of soil shear strength parameters obtained from DST.

Key words： soil mechanics direct shear test shear strength parameters correction area correction stress correction

收稿日期: 2013-01-30

引用本文:

余凯1，2，姚鑫1，张永双1，李成功3，欧璐4. 基于面积和应力修正的直剪试验数据分析[J]. 岩石力学与工程学报, 2014, 33(1): 118-124.
YU Kai1，2，YAO Xin1，ZHANG Yongshuang1，LI Chenggong3，OU Lu4. ANALYSIS OF DIRECT SHEAR TEST DATA BASED ON AREA AND STRESS CORRECTION. , 2014, 33(1): 118-124.

链接本文:

http://www.rockmech.org/CN/Y2014/V33/I1/118

[3]	中华人民共和国国家标准编写组. GB/T 50123—1999 土工试验方法标准[S]. 北京：中国计划出版社，1999.(The National Standards Compilation Group of the People?s Republic of China. GB/T 50123—1999 Standard for soil test method[S]. Beijing：China Planning Press，1999.(in Chinese)) " target="_blank">
[12]	LIU S H. Simulating a direct shear box test by DEM[J]. Canadian Geotechnical Journal，2006，43(2)：155-168. " target="_blank">
[14]	WANG J，DOVE J E，GUTIERREZ M S. Discrete-continuum analysis of shear banding in the direct shear test[J]. Geotechnique，2007，57(6)：513-526. " target="_blank">
[16]	王艳宏，杨金钟. 直剪试验和三轴剪切试验对比分析[J]. 天津建设科技，2005，15(增1)：209-210.(WANG Yanhong，YANG Jinzhong. Comparative analysis of direct shear test and triaxial shear test[J]. Tianjin Construction Science and Technology，2005，15(Supp.1)：209-210.(in Chinese)) " target="_blank">
[18]	王文志，孙红，石志亮. 浅谈直剪试验与三轴试验的异同[J]. 内蒙古水利，2011，(2)：19-20.(WANG Wenzhi，SUN Hong，SHI Zhiliang. Similarities and differences between the direct shear test and triaxial shear test[J]. Inner Mongolia Water Resources，2011，(2)：19-20.(in Chinese)) " target="_blank">
[7]	刘海波，张丽华，林大超，等. 直剪试验有效剪切面积动态变化的改进计算[J]. 沈阳建筑大学学报：自然科学版，2010，26(3)：503-506.(LIU Haibo，ZHANG Lihua，LIN Dachao，et al. The improve calculation of the dynamic changes of the effective shear area in the direct shear test[J]. Journal of Shenyang Jianzhu University：Natural Science，2010，26(3)：503-506.(in Chinese)) " target="_blank">
[9]	徐志伟，周国庆，刘志强，等. 直剪试验的面积校正方法及误差分析[J]. 中国矿业大学学报，2007，36(5)：658-662.(XU Zhiwei，ZHOU Guoqing，LIU Zhiqiang，et al. Correcting method and error analysis for sample area in direct shear test[J]. Journal of China University of Mining and Technology，2007，36(5)：658-662.(in Chinese)) " target="_blank">
[1]	李广信. 高等土力学[M]. 北京：清华大学出版社，2004：143-155.(LI Guangxin. Advanced soil mechanics[M]. Beijing：Tsinghua University Press，2004：143-155.(in Chinese)) " target="_blank">
[5]	KISHIDA H，UESUGI M. Tests of the interface between sand and steel in the simple shear apparatus[J]. Géotechnique，1987，37(1)：45-52. " target="_blank">
[8]	张敏江，郭尧，张丽萍，等. 直剪试验中对土抗剪强度的一种修正方法[J]. 沈阳建筑大学学报：自然科学版，2005，21(2)：96-98.(ZHANG Minjiang，GUO Yao，ZHANG Liping，et al. A revising method of shear strength of soils in direct shear test[J]. Journal of Shenyang Jianzhu University：Natural Science，2005，21(2)：96-98.(in Chinese)) " target="_blank">
[2]	李广信，吕禾. 土强度试验的排水条件与强度指标的应用[J]. 工程勘察，2006，(3)：11-14.(LI Guangxin，LU He. Drainage conditions for tests of soil strength and the application of strength indices[J]. Journal of Geotechnical Investigation and Surveying，2006，(3)：11-14.(in Chinese)) " target="_blank">
[4]	中华人民共和国行业标准编写组. JTG E40—2007 公路土工试验规程[S]. 北京：人民交通出版社，2007.(The Professional Standards Compilation Group of the People¢s Republic of China. JTG E40—2007 Test methods of soils for highway engineering[S]. Beijing：China Communications Press，2007.(in Chinese)) " target="_blank">
[6]	何满潮. 直剪试验中的有效面积校正[J]. 露天开采，1986，(2)：16-19.(HE Manchao. Effective area correction in the direct shear test[J]. Opencast Mining Technology，1986，(2)：16-19.(in Chinese)) " target="_blank">
[10]	胡黎明，马杰，张丙印. 直剪试验中接触面渐进破坏的数值模拟[J]. 清华大学学报：自然科学版，2008，48(6)：943-946.(HU Liming，MA Jie，ZHANG Bingyin. Numerical simutation of interface failure during direct shear tests[J]. Journal of Tsinghua University：Science and Technology，2008，48(6)：943-946.(in Chinese)) " target="_blank">
[13]	蒋明镜，王富周，朱合华，等. 密实散粒体宏微观特性的直剪试验离散元数值分析[J]. 河海大学学报：自然科学版，2010，38(5)：538-544.(JIANG Mingjing，WANG Fuzhou，ZHU Hehua，et al. DEM simutation of macro-micro mechanical properties of dense granular materials in direct shear test[J]. Journal of Hohai University：Natural Science，2010，38(5)：538-544.(in Chinese)) " target="_blank">
[17]	ROWE P W. The relation between the shear strength of sands in triaxial compression，plane strain and direct shear[J]. Geotechnique，1969，19(1)：75-86. " target="_blank">
[11]	THORNTON C，ZHANG L. Numerical Simulations of the direct shear test[J]. Chemical Engineering and Technology，2003，26(2)：153-156. " target="_blank">
[15]	魏汝龙. 三轴和直剪试验的固结快剪指标[J]. 大坝观测与土工测试，1998，22(1)：23-41.(WEI Rulong. Consolidated undrained strength targets obtained by triaxial and direct shear test[J]. Dam Observation and Geotechnical Tests，1998，22(1)：23-41.(in Chinese)) " target="_blank">