等向强化–软化Drucker-Prager材料强度参数演化

doi:10.13722/j.cnki.jrme.2016.0552

摘要
图/表
参考文献
相关文章 (15)

全文: PDF (934 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要 Drucker-Prager屈服准则中压力相关系数和黏聚剪切强度的实测结果少有报道。根据同一组致密砂岩三轴压缩试验，同时测试Mohr-Coulomb准则中的内摩擦角和黏聚力以及Drucker-Prager准则中的压力相关系数和黏聚剪切强度。测试结果显示，描述岩石内摩擦性质的参数和随着塑性变形的增长而增长，但是增长速率逐渐减小；描述岩石胶结性质的参数和在岩石初始屈服后会先上升至峰值，然后随着塑性变形的增长从峰值逐渐下降。同时，从5种常用的Mohr-Coulomb准则与Drucker-Prager准则转换关系中，通过同一组三轴压缩试验结果寻找到吻合程度最高的换算关系。Drucker-Prager材料强度参数的变化将来可应用到岩土类材料的数值计算中来模拟材料的强化和软化性质，同时也可以为Mohr-Coulomb准则参数与Drucker-Prager准则参数转换提供一定参考。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	丁祥
	张广清

关键词 ：岩土工程, Drucker-Prager准则, Mohr-Coulomb准则, 压力相关系数, 黏聚剪切强度

Abstract：The experimental research on the strength parameters of Drucker-Prager criterion, i.e. the coefficient of pressure sensitivity and the shearing strength of cohesion ，was rarely reported. The parameters including the internal friction angle ，the cohesion ，the coefficient of pressure sensitivity and the shearing strength of cohesion were measured simultaneously with the same group of triaxial compression tests on dense sandstone. The results show that and gradually increase with the plastic deformation in a decreasing rate，while and firstly increase to their peak values and then decrease with the plastic deformation. Five pairs of mostly used parameter conversion formulae for Mohr-Coulomb criterion and Drucker-Prager criterion were compared so that a pair of best fit conversion formulae were found with the same group of triaxial compression tests. The variation of strength parameters in Mohr-Coulomb criterion and Drucker-Prager criterion can be used to simulate the hardening and softening of geomaterials in the future numerical computation of geotechnical engineering.

Key words： geotechnical engineering Drucker-Prager criterion Mohr-Coulomb criterion coefficient of pressure sensitivity shearing strength of cohesion

引用本文:

丁祥，张广清. 等向强化–软化Drucker-Prager材料强度参数演化[J]. 岩石力学与工程学报, 2017, 36(4): 910-916.
DING Xiang，ZHANG Guangqing. Variation of strength parameters of Drucker-Prager material with isotropic hardening and softening. , 2017, 36(4): 910-916.

链接本文:

http://www.rockmech.org/CN/10.13722/j.cnki.jrme.2016.0552 或 http://www.rockmech.org/CN/Y2017/V36/I4/910

[5]	CHEN W F，LIU X L. limit analysis in soil mechanics[M]. Amsterdam：Elsevier，1990：88-89. " target="_blank">
[13]	FJÆR E，HOLT R M，HORSRUD P，et al. Petroleum related rock mechanics[M]. Hungary：Elsevier，2008：79. " target="_blank">
[4]	DAVIS R O，SELVADURAI A P S. Plasticity and Geomechanics[M]. Cambridge：Cambridge University Press，2002：65-67. " target="_blank">
[30]	BISHOP A W. Shear strength parameters for undisturbed and remoulded soil specimens [C]// Proceedings of the Roscoe Memorial Symp. Cambridge：[s.n.]，1972：3-58. " target="_blank">
[2]	殷有泉. 岩石类材料塑性力学[M]. 北京：北京大学出版社， 2014：66.(YIN Youquan. Plasticity of geomaterials[M]. Beijing： Peking University Press，2014：66.(in Chinese)) " target="_blank">
[16]	VERMEER P A，DE BORST R. Non-associated plasticity for soils，concrete and rock[J]. Heron，1984，29 (3)：1-64. " target="_blank">
[8]	时卫民，郑颖人. 莫尔-库仑屈服准则的等效变换及其在边坡分析中的应用[J]. 岩土工程技术，2003，(3)：155-159.(SHI Weimin，ZHENG Yingren. Equivalent transformation of Mohr-Coulomb criterion and its application in slope stability analysis[J]. Geotechnical Engineering Technique，2003，(3)：155-159.(in Chinese)) " target="_blank">
[10]	郑颖人，沈珠江，龚晓南. 岩土塑性力学原理[M]. 北京：中国建筑工业出版社，2002：55-61.(ZHENG Yingren，SHEN Zhujiang，GONG Xiaonan. The principles of geotechnical plastic mechanics[M]. Beijing：China Architecture and Building Press，2002：55-61.(in Chinese)) " target="_blank">
[11]	陈惠发. 土木工程材料的本构方程[M]. 武汉：华中科技大学出版社，2001：375.(CHEN W F. Constitutive equations of civil engineering materials[M]. Wuhan：Huazhong University of Science and Technology Press，2001：375.(in Chinese)) " target="_blank">
[15]	HAJIABDOLMAJID V，KAISER P K，MARTIN C D. Modelling brittle failure of rock[J]. International Journal of Rock Mechanics and Mining Sciences，2002，39(6)：731-741.
[18]	MARTIN C D. Seventeenth Canadian geotechnical colloquium：the effect of cohesion loss and stress path on brittle rock strength[J]. Canadian Geotechnical Journal，1997，34(5)：698-725. " target="_blank">
[21]	WANG H C，ZHAO W H，SUN D S，et al. Mohr-coulomb yield criterion in rock plastic mechanics[J]. Chinese Journal of Geophysics，2012，55(6)：733-741. " target="_blank">
[28]	KOVARI K，TISA A，EINSTEIN H H，et al. Suggested methods for determining the strength of rock materials in triaxial compression：revised version[J]. International Journal of Rock Mechanics and Mining Sciences，1983，20(6)：283-290. " target="_blank">
[31]	SCHMERTMANN J H，OSTERBERG J H. An experimental study of the development of cohesion and friction with axial strain in saturated cohesive soils[C]// Proceedings of the Research Conference on Shear Strength of Cohesive Soils. New York：ASCE，1960：643-694. " target="_blank">
[1]	DRUCKER D C，PRAGER W J. Soil mechanics and plastic analysis for limit design[J]. Quarterly of Applied Mathematics，1952，10(2)：157-165. " target="_blank">
[3]	姚再兴. 软化Drucker-Prager材料强度参数的测定方法[J]. 岩石力学与工程学报，2014，33(6)：1 187-1 193.(YAO Zaixing. A method for measuring strength parameters of softening Drucker-Prager material[J]. Chinese Journal of Rock Mechanics and Engineering，2014，33(6)：1 187-1 193.(in Chinese)) " target="_blank">
[6]	陈惠发，萨里普. 弹性与塑性力学[M]. 北京：中国建筑工业出版社，2005：209-210.(CHEN W F，SALEEB A F. Elasticity and plasticity[M]. Beijing：China Architecture and Building Press，2005：209-210.(in Chinese)) " target="_blank">
[9]	刘金龙，栾茂田，许成顺，等. Drucker-Prager准则参数特性分析[J]. 岩石力学与工程学报，2006，25(增2)：4 009-4 015.(LIU Jinlong，LUAN Maotian，XU Chengshun，et al. study on parametric characters of Drucker-Prager Criterion[J]. Chinese Journal of Rock Mechanics and Engineering，2006，25(Supp.2)：4 009-4 015.(in Chinese)) " target="_blank">
[12]	熊敬，张建海. Drucker-Prager型屈服准则与强度储备安全系数的相关分析[J]. 岩土力学，2008，29(7)：1 905-1 910.(XIONG Jing，ZHANG Jianhai. Correlation analysis of relationship between Druker- Prager yield criteria and strength margin safety factor[J]. Rock and Soil Mechanics，2008，29(7)：1 905-1 910.(in Chinese))
[14]	王红才，赵卫华，孙东生，等. 岩石塑性变形条件下的Mohr- Coulomb屈服准则[J]. 地球物理学报，2012，55(12)：4 231-4 238. (WANG Hongcai，ZHAO Weihua，SUN Dongsheng，et al. Mohr- Coulomb yield criterion in rock plastic mechanics[J]. Chinese Journal of Geophysics，2012，55(12)：4 231-4 238.(in Chinese)) " target="_blank">
[19]	ZHANG K，ZHOU H，SHAO J. An experimental investigation and an elastoplastic constitutive model for a porous rock[J]. Rock mechanics and rock engineering，2013，46(6)：1 499-1 511. " target="_blank">
[22]	JAFARPOUR M，RAHMATI H，AZADBAKHT S，et al. Determination of mobilized strength properties of degrading sandstone[J]. Soils and Foundations，2012，52(4)：658-667. " target="_blank">
[24]	POURHOSSEINI O，SHABANIMASHCOOL M. Development of an elasto-plastic constitutive model for intact rocks[J]. International Journal of Rock Mechanics and Mining Sciences，2014，66(66)：1-12. " target="_blank">
[7]	殷有泉. 岩石力学与岩石工程的稳定性[M]. 北京：北京大学出版社，2011：100-101.(YIN Youquan. Stability of rock mechanics and rock engineering[M]. Beijing： Peking University Press，2011：100-101.(in Chinese)) " target="_blank">
[26]	张后全，贺永年，周纪军，等. 岩石破损过程强度变化规律实测研究[J]. 岩石力学与工程学报，2010，29(增1)：3 273-3 279.(ZHANG Houquan，HE Yongnian，ZHOU Jijun，et al. Experimental study of strength evolution laws in rock failure process[J]. Chinese Journal of Rock Mechanics and Engineering，2010，29(Supp.1)：3 273-3 279.(in Chinese))
[29]	中华人民共和国国家标准编写组. GB/T 23561.9—2009煤和岩石物理力学性质测定方法第9部分：煤和岩石三轴强度及变形参数测定方法[S]. 北京：[s.n.]，2009.(The National Standards Compilation Group of People?s Republic of China. GB/T 23561.9—2009 Methods for determining the physical and mechanical properties of coal and rock. Part 9：Methods for determining the triaxial strength and deformation parameters of coal and rock[S]. Beijing：[s.n.]，2009.(in Chinese)) " target="_blank">
[17]	LI H，XIONG G，ZHAO G. An elasto-plastic constitutive model for soft rock considering mobilization of strength[J]. Transactions of Nonferrous Metals Society of China，2016，26(3)：822-834. " target="_blank">
[20]	MA L，XU H，TONG Q，et al. Post-yield plastic frictional parameters of a rock salt using the concept of mobilized strength[J]. Engineering Geology，2014，177(14)：25-31. " target="_blank">
[23]	LEE K H，LEE I M，SHIN Y J. Brittle rock property and damage index assessment for predicting brittle failure in excavations[J]. Rock Mechanics and Rock Engineering，2012，45(2)：251-257.
[25]	ZHANG H Q，TANNANT D D，JING H W，et al. Evolution of cohesion and friction angle during microfracture accumulation in rock[J]. Natural Hazards，2015，77(1)：497-510. " target="_blank">
[27]	张帆，盛谦，朱泽奇，等. 三峡花岗岩峰后力学特性及应变软化模型研究[J]. 岩石力学与工程学报，2008，27(增1)：2 651-2 655. (ZHANG Fan，SHENG Qian，ZHU Zeqi，et al. Study on post-peak mechanical behaviour and strain softening model of three gorges granite[J]. Chinese Journal of Rock Mechanics and Engineering，2008，27(Supp.1)：2 651-2 655.(in Chinese))