MODE AND MECHANISM OF BURSTING IN FOUNDATION PIT BASED ON CENTRIFUGAL MODEL TEST
(1. Department of Civil and Architecture Engineering,Tongling University,Tongling,Anhui 244000,China;2. Key Laboratory
of Road and Traffic Engineering of Ministry of Education,Tongji University,Shanghai 201804,China)
Abstract:In the soft soil areas,bursting induced by confined water is the most important factor which affects the safety and stability of deep foundation pit,and is the key technological problem of design and construction which is urgently solved. The influence of different impermeable layer types,pile types and the layouts of piles on the bursting stability and failure modes of foundation pit are studied systematically by centrifugal model test. The test results show that the failure modes of foundation pits bursting in soft soil areas can be mainly divided into three kinds,i.e. water and sand inrushing in contact surface between soil and underground structures,overall heaving failure and sand boiling on impermeable layer surface. Based on theoretical analysis,the internal mechanisms of bursting in foundation pits are cleared respectively that the contact surface between impermeable-layer and underground structures occurs hydraulic fracturing,contact surface or nearby occurs shear failure and impermeable layer occurs complex tensile-shear failure and shear failure.
孙玉永1,周顺华2. 基于离心模型试验的基坑突涌模式及机制研究[J]. 岩石力学与工程学报, 2010, 29(12): 2551-2557.
SUN Yuyong1,ZHOU Shunhua2. MODE AND MECHANISM OF BURSTING IN FOUNDATION PIT BASED ON CENTRIFUGAL MODEL TEST. , 2010, 29(12): 2551-2557.
刘国彬,王洪新. 上海浅层粉砂地层承压水对基坑的危害及治理[J]. 岩土工程学报,2002,24(6):790-792.(LIU Guobin,WANG Hongxin. Damage of the pressure water in shallow silty sand in Shanghai to excavation of foundation pit and its treatment[J]. Chinese Journal of Geotechnical Engineering,2002,24(6):790-792.(in Chinese))
[2]
李长山. 杭州地铁秋涛路站基坑施工管涌分析处理[J]. 路基工程,2006,(3):111-114.(LI Changshan. Analysis and treatment of piping in Qiutao road station foundation pit construction of Hangzhou Metro[J]. Subgrade Engineering,2006,(3):111-114.(in Chinese))
Your browse does not support frame!