大断面公路隧道的过程设计方法研究

摘要
图/表
参考文献
相关文章 (8)

全文: PDF (0 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要通过龙头山隧道、岚峰隧道的现场试验研究和数值分析，提出大断面公路隧道的过程设计方法，并建立应用模型。过程设计方法以荷载–结构法为基础，并以极限拉应变值来确定围岩松动区范围。与传统的公路隧道设计规范、普氏理论等方法相比，设计荷载中重点考虑施工过程的影响，从而在保证隧道安全性的同时优化偏于保守的支护参数。通过双侧壁导坑开挖方法和单侧壁导坑开挖方法这2个应用实例表明：过程设计方法比状态设计方法更为可靠和实用，更符合大断面隧道的实际情况。研究结果将有助于为大断面公路隧道寻求更为有效、合理的设计方法，提高大断面隧道的设计水平。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章

关键词 ：公路工程, 大断面公路隧道, 过程设计方法, 隧道荷载

Abstract：Process design method(PDM) of road tunnel with large cross-section is introduced according to the in-situ test study and finite element method(FEM) numerical simulation analysis of road tunnels in Longtoushan and Lanfeng，while the correlative practical mode is built subsequently. PDM is established based on the load-structure design method，and the loose load zone is defined by maximum tension strain of surrounding rock. PDM emphasizes more consideration about effect of a tunnel construction process，which is very different from both traditional road tunnel design codes and Протодъякнов?s(PUSI) theory. PDM optimizes the comparatively conservative support parameters by common design method，at the same time，of course can ensure the tunnel be at a whole safe state. Two engineering applications with different construction methods：double and single side-wall drift pilot excavations are studied，and the results show that PDM is more credible and practical than usual state one，and is better fit for the in-situ construction of tunnels with large cross-section. The results from this paper are in favor of advancing more efficient and reasonable design method of road tunnel with large cross-section，as well as to promote the current design level.

Key words： highway engineering large cross-section road tunnel process design method(PDM) tunnel load

收稿日期: 2010-05-21

引用本文:

朱合华1，曲海锋2，蔡永昌1，黄锋1. 大断面公路隧道的过程设计方法研究[J]. 岩石力学与工程学报, 2011, 30(S2): 3450-3456.
ZHU Hehua1，QU Haifeng2，CAI Yongchang1，HUANG Feng1. STUDY OF PROCESS DESIGN METHOD OF LARGE CROSS-SECTION ROAD TUNNEL. , 2011, 30(S2): 3450-3456.

链接本文:

http://www.rockmech.org/CN/Y2011/V30/IS2/3450

[1]	PALMSTRÖM A. Recent developments in rock support estimates by the RMI[J]. Journal of Rock Mechanics and Tunneling Technology，2000，6(1)：1-19. " target="_blank">
[2]	PALMSTROM A，BROCH E. Use and misuse of rock mass classification systems with particular reference to the Q-system[J]. Tunneling and Underground Space Technology，2006，21(6)：575-593. " target="_blank">
[7]	FRALDI M，GUARRACINO F. Analytical solutions for collapse mechanisms in tunnels with arbitrary cross sections[J]. International Journal of Solids and Structures，2010，47(2)：216-223.
[8]	CHEN S H，QIANG S，CHEN S F，et al. Composite element model of the fully grouted rock bolt[J]. Rock Mechanics and Rock Engineering，2004，37(3)：193-212.
[9]	FARIAS M M D，JUNIOR A H M，ASSIS A P D. Displacement control in tunnels excavated by the NATM：3D numerical simulations[J]. Tunneling and Underground Space Technology，2004，19(3)：283-293.
[12]	中华人民共和国行业标准编写组. JTGD70—2004公路隧道设计规范[S]. 北京：人民交通出版社，2004.(The Professional Standards Compilation Group of People?s Republic of China. JTGD70—2004 Code for design of road tunnel[S]. Beijing：China Communications Press，2004.(in Chinese)) " target="_blank">
[16]	周丁恒，曲海锋，蔡永昌，等. 特大断面大跨度隧道围岩变形的现场试验研究[J]. 岩石力学与工程学报，2009，28(9)：1 773-1 782. (ZHOU Dingheng，QU Haifeng，CAI Yongchang，et al. In-situ test on surrounding rock deformation in super-large section and large-span tunnel[J]. Chinese Journal of Rock Mechanics and Engineering，2009，28(9)：1 773-1 782.(in Chinese)) " target="_blank">
[18]	杨林德. 宜兴抽水蓄能电站地下厂房洞室群围岩稳定性的分析研究报告[R]. 上海：同济大学，2001.(YANG Linde. The analysis of stability about tunnels under power station in Yixing[R]. Shanghai：Tongji University，2001.(in Chinese)) " target="_blank">
[19]	杨林德，朱合华，夏才初. 围岩变形特征、主要洞室变形预测及变形监控标准建议值研究总报告[R]. 上海：同济大学，2003.(YANG Linde，ZHU Hehua，XIA Caichu. The report of about the characters，stain，and monitoring displacement of surrounding rock[R]. Shanghai：Tongji University，2003.(in Chinese)) " target="_blank">
[21]	刘洪洲，陈佳. 浅埋、小净距、大跨度扁坦公路隧道结构设计与分析[J]. 公路，2006，(12)：212-217.(LIU Hongzhou，CHEN Jia. Structure design and analysis of shallow-embedding long-span neighborhood[J]. Highway，2006，(12)：212-217. (in Chinese)) " target="_blank">
[13]	曲海锋. 扁平特大断面隧道修筑及研究概述[J]. 隧道建设，2009，29(2)：166-171.(QU Haifeng. An overview on construction and research of super-large cross-section tunnels with low height-span ratios[J]. Tunnel Construction，2009，29(2)：166-171.(in Chinese))
[14]	SATO J，NAKATA M，KUSUMOTO H. Suggestion of the tunnel support design method by characteristic curve law with the theory solution for super large tunnel in squeezing rock[C]// Proceedings of the World Tunnel Congress and the 36th General Assembly. Vancounver，Canada：[s.n.]，2010：1-8. " target="_blank">
[22]	李云鹏，王芝银，韩常领，等. 不同围岩类别小间距隧道施工过程模拟研究[J]. 岩土力学，2006，27(1)：11-16.(LI Yunpeng，WANG Zhiyin，HAN Changling，et al. Simulating study on construction process of tunnels with small spacing for different classes of surrounding rocks[J]. Rock and Soil Mechanics，2006，27(1)：11-16.(in Chinese)) " target="_blank">
[3]	OSGOUI R. On the assessment of the effect of the anisotropy in in-situ stress on support pressure in tunnels[C]// International Symposium on In-Situ Rock Stress. Norway：Taylor and Francis Ltd.，2006：307-317. " target="_blank">
[4]	WONG H，SUBRIN D，DIAS D. Convergence-confinement analysis of a bolt-supported tunnel using the homogenization method[J]. Canadian Geotechnical Journal，2006，43(5)：462-483. " target="_blank">
[5]	GUAN Z C，JIANG Y J，TANABASI Y，et al. Reinforcement mechanics of passive bolts in conventional tunneling[J]. International Journal of Rock Mechanics and Mining Sciences，2007，44(4)：625-636.
[6]	OSGOUI R. Development of an elasto-plastic analytical model for design of grouted rock bolts in tunnels with particular reference to poor rock masses[Ph. D. Thesis][D]. Ankara，Turkey：Middle East Technical University，2007. " target="_blank">
[10]	曲海锋，杨重存，朱合华，等. 公路隧道围岩压力研究与发展[J]. 地下空间与工程学报，2007，3(3)：536-543.(QU Haifeng，YANG Zhongcun，ZHU Hehua，et al. Research and development on surrounding rock pressure of road tunnel[J]. Chinese Journal of Underground Space and Engineering，2007，3(3)：536-543.(in Chinese)) " target="_blank">
[11]	曲海锋，朱合华，蔡永昌. 扁平大跨度公路隧道松动荷载计算方法探讨[J]. 岩土力学，2008，29(4)：989-1 000.(QU Haifeng，ZHU Hehua，CAI Yongchang. Discussion on calculation of loose load on extra-large cross-section and large-span road tunnel[J]. Rock and Soil Mechanics，2008，29(4)：989-1 000.(in Chinese)) " target="_blank">
[15]	曲海锋. 扁平特大断面公路隧道荷载模式及应用研究[博士学位论文][D]. 上海：同济大学，2007.(QU Haifeng. Study on load mode of road tunnel with extra-large cross-section and low flat-ratio and its application[Ph. D. Thesis][D]. Shanghai：Tongji University，2007.(in Chinese)) " target="_blank">
[17]	STACEY T R，PAGE C H. 地下岩石力学实用手册[M]. 朱浮声译.北京：煤炭工业出版社，1990：7-10.(STACEY T R，PAGE C H . Application manual of underground rock mechanics[M]. ZHU Fusheng ed. Beijing：China Coal Industry Publishing House，1990：7-10.(in Chinese)) " target="_blank">
[20]	谢兴华，速宝玉，詹美礼. 基于应变的脆性岩石破坏强度研究[J]. 岩石力学与工程学报，2004，23(7)：1 087-1 090.(XIE Xinghua，SU Baoyu，ZHAN Meili. Study of failure criterion for brittle rocks based on strains[J]. Chinese Journal of Rock Mechanics and Engineering，2004，23(7)：1 087-1 090.(in Chinese)) " target="_blank">
[23]	夏才初，龚建伍，唐颖，等. 大断面小净距公路隧道现场监测分析研究[J]. 岩石力学与工程学报，2007，26(1)：44-50.(XIA Caichu，GONG Jianwu，TANG Ying，et al. Study on site monitoring of large-section highway tunnels with small clear spacing[J]. Chinese Journal of Rock Mechanics and Engineering，2007，26(1)：44-50.(in Chinese))
[24]	胡建明. 大跨度小净距公路隧道施工监测及围岩稳定性研究[硕士学位论文][D]. 重庆：重庆大学，2006.(HU Jianming. Study on construction monitoring and stability of surrounding rock for neighborhood highway tunnel of large span[M. S. Thesis][D]. Chongqing：Chongqing University，2006.(in Chinese)) " target="_blank">