岩巷掘进准直眼掏槽爆破模型试验研究

摘要
图/表
参考文献
相关文章 (15)

全文: PDF (327 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要为了更好地应用准直眼掏槽爆破技术，基于相似理论，建立准直眼掏槽模型试验相似准则，进行准直眼掏槽方式的物理模型试验。以主掏槽孔孔口间距、炮孔排距和主掏槽孔倾斜角度为主导因子进行正交试验。极差分析结果表明：对于掏槽深度，主掏槽孔孔口间距的影响最大，主掏槽孔倾斜角度其次，炮孔排距影响最小；对于槽腔体积，主掏槽孔孔口间距影响最大，炮孔排距的影响其次，主掏槽孔倾斜角度影响最小。方差法分析结果表明：主掏槽炮孔孔口间距对掏槽深度有极为显著的影响，主掏槽炮孔倾斜角度有显著影响，而炮孔排距无显著影响；主掏槽炮孔孔口间距、炮孔排距和主掏槽炮孔倾斜角度对槽腔体积均有极为显著的影响。此外，开展主掏槽孔倾斜角度大于85°的模型试验，结果表明：主掏槽孔倾斜角度对准直眼掏槽爆破的影响极为明显。该结果同时也验证准直眼与自由面夹角取值范围的分析。模型试验最优爆破参数为：主掏槽孔孔口间距150 mm，炮孔排距70 mm，主掏槽孔倾斜角度83°。现场应用由该模型方案所转化的现场试验方案，取得良好的爆破效果。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章

关键词 ：采矿工程, 爆破工程, 岩巷掘进, 准直眼掏槽, 模型试验

Abstract：In order to better apply the technique of quasi-parallel cutting blast，based on similarity theory，the similarity criterion of model test of quasi-parallel cutting is established. The physical model tests of quasi-parallel cutting are carried out. Taking the face spacing，array pitch and angle of main cut holes as the key factors，the orthogonal tests are conducted. The results of range analysis show that：(1) The face spacing of main cut holes has the maximum effect on cut depth，next is the angle，and the minimum is the array pitch. (2) For cavity volume，the face spacing of main cut holes has the maximum effect，next is the array pitch，and the minimum is the angle. The results of variance analysis show that：(1) The face spacing of main cut holes has a very significant effect on cut depth，the angle has a significant effect on cut depth，while the array pitch has no effect on cut depth. (2) The three factors all have very significant effects on cavity volume. Besides，the model tests are conducted under the condition that the angle of main cut holes is greater than 85°. The test results show that the influence of angle of main cut holes on quasi-parallel cutting blast is very apparent. Meantime，the test results prove the analysis of corner span between quasi-parallel hole and the free face. The optimization blast parameters of model test are obtained as following：the face spacing of main cut holes is 150 mm；the array pitch of holes is 70 mm and the angle of main cut holes is 83°. The good blast effects are achieved by using the transformation scheme from the above scheme in field engineering.

Key words： mining engineering blast engineering rock drivage quasi-parallel cutting model test

收稿日期: 2011-07-12

引用本文:

单仁亮，黄宝龙，蔚振廷，孔祥松. 岩巷掘进准直眼掏槽爆破模型试验研究[J]. 岩石力学与工程学报, 2012, 31(2): 256-264.
SHAN Renliang，HUANG Baolong，WEI Zhenting，KONG Xiangsong. MODEL TEST OF QUASI-PARALLEL CUT BLASTING IN ROCK DRIVAGE. , 2012, 31(2): 256-264.

链接本文:

http://www.rockmech.org/CN/Y2012/V31/I2/256

[2]	单仁亮，高文蛟. 准直眼强力掏槽的方法：中国，CN101261103[P]，2008-09-10.(SHAN Renliang，GAO Wenjiao. Method of quasi- parallel strong cutting：China，CN101261103[P]，2008-09-10.(in Chinese)) " target="_blank">
[5]	汪学清，单仁亮，黄宝龙. 光面爆破技术在破碎的软岩巷道掘进中的应用研究[J]. 爆破，2008，25(3)：12-16.(WANG Xueqing，SHAN Renliang，HUANG Baolong. Application research on smooth blasting for cracked soft rock tunneling[J]. Blasting，2008，25(3)：12-16.(in Chinese)) " target="_blank">
[7]	单仁亮，黄宝龙，高文蛟，等. 岩巷掘进准直眼掏槽爆破新技术应用实例分析[J]. 岩石力学与工程学报，2011，30(2)：224-232.(SHAN Renliang，HUANG Baolong，GAO Wenjiao，et al. Case studies of new technology application of quasi-parallel cut blasting in rock roadway drivage[J]. Chinese Journal of Rock Mechanics and Engineering，2011，30(2)：224-232.(in Chinese))
[9]	许连坡. 关于爆破相似律的一些问题[J]. 爆炸与冲击，1985，5(4)：1-9.(XU Lianpo. Some problems about the law of similitude in blasting[J]. Explosion and Shock Waves，1985，5(4)：1-9.(in Chinese)) " target="_blank">
[13]	马建军，段卫东，钟冬望，等. 地采爆破模型模拟试验与数据处理[J]. 爆破，2001，18(增1)：16-20.(MA Jianjun，DUAN Weidong，ZHONG Dongwang，et al. Model simulation test and data analysis of underground blasting[J]. Blasting，2001，18(Supp.1)：16-20.(in Chinese)) " target="_blank">
[17]	马建军，黄宝，江兵，等. 地下深孔爆破模拟相似律与模型制作[J]. 中国矿业，2011，10(4)：38-41.(MA Jianjun，HUANG Bao，JIANG Bing，et al. Manufacturing of model for simulating underground deep hole blasting based on the theory of similarity law[J]. China Mining，2011，10(4)：38-41.(in Chinese)) " target="_blank">
[1]	王文龙. 钻眼爆破[M]. 北京：煤炭工业出版社，1984：222-226. (WANG Wenlong. Drilling and blasting[M]. Beijing：China Coal Industry Publishing House，1984：222-226.(in Chinese)) " target="_blank">
[3]	单仁亮，汪学清，高文蛟，等. 人工神经网络在巷道爆破中的应用研究[J]. 岩石力学与工程学报，2007，26(增1)：3 322-3 328.(SHAN Renliang，WANG Xueqing，GAO Wenjiao，et al. Application research of artificial neural networks to tunnel blasting[J]. Chinese Journal of Rock Mechanics and Engineering，2007，26(Supp.1)：3 322-3 328. (in Chinese)) " target="_blank">
[4]	单仁亮，黄宝龙，张怀文. 厚软弱夹层岩巷中深孔爆破试验研究[J]. 煤炭科学技术，2009，37(6)：39-41.(SHAN Renliang，HUANG Baolong，ZHANG Huaiwen. Experiment and research on deep borehole blasting in mine rock roadway with thick soft and weak parting[J]. Coal Science and Technology，2009，37(6)：39-41.(in Chinese)) " target="_blank">
[6]	朱永. 中深孔准直眼掏槽爆破技术与应用研究[硕士学位论文][D]. 北京：中国矿业大学，2008.(ZHU Yong. Medium-deep hole quasi-parallel cut blasting technology and application[M. S. Thesis][D]. Beijing：China University of Mining and Technology，2008.(in Chinese)) " target="_blank">
[10]	张志呈. 爆破中量纲分析及相似原理[J]. 四川建材学院学报，1992，7(2)：63-69.(ZHANG Zhicheng. Dimensional analysis and principle of similitude on blasting engineering[J]. Journal of Sichuan Institute of Building Materials，1992，7(2)：63-69.(in Chinese)) " target="_blank">
[14]	秦绍兵. 模型试验在井下中深孔爆破参数优化研究中的应用[J]. 金属矿山，2001，(3)：15-18.(QIN Shaobing. Application of model test in the optimization study of underground deep-hole blasting parameters[J]. Metal Mine，2001，(3)：15-18.(in Chinese)) " target="_blank">
[8]	李之光. 相似与模化(理论及应用)[M]. 北京：国防工业出版社，1982：4-7.(LI Zhiguang. Similarity and modeling(theory and application)[M]. Beijing：National Defense Industry Press，1982：4-7.(in Chinese)) " target="_blank">
[11]	杨振声. 工程爆破的模型试验与模型律[J]. 工程爆破，1995，1(2)：1-15.(YANG Zhensheng. Modeling experiment of engineering blasting and model theory[J]. Engineering Blasting，1995，1(2)：1-15.(in Chinese)) " target="_blank">
[12]	CHAKRABORTY A K，JETHWA J L. Tunnel blasting techniques in difficult ground conditions[J]. Geotechnical and Geological Engineering，1994，(12)：219-239. " target="_blank">
[15]	梁为民，王以贤，楮怀保，等. 楔形掏槽炮孔角度对称性对掏槽效果影响研究[J]. 金属矿山，2009，(11)：21-24.(LIANG Weimin，WANG Yixian，CHU Huaibao，et al. Study on effect of symmetry of wedge-shaped cutting hole angle on cut blasting[J]. Metal Mine，2009，(11)：21-24.(in Chinese)) " target="_blank">
[16]	周传波. 深孔爆破一次成井模拟优化与应用研究[博士学位论文][D]. 武汉：中国地质大学，2004：13-67.(ZHOU Chuangbo. Study of simulation optimization and application of shaft formation by one deep-hole blasting[Ph. D. Thesis][D]. Wuhan：China University of Geosciences，2004：13-67.(in Chinese)) " target="_blank">