单轴压缩分级松弛作用下煤样变形与强度特征分析

摘要
图/表
参考文献
相关文章 (15)

全文: PDF (741 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要利用RMT–150B岩石力学系统对煤样进行单轴压缩分级松弛试验，分析煤样常规单轴压缩与单轴分级松弛条件下煤样的变形、强度和破坏的时效特征。结果表明：2种加载方式下煤样峰值前的应力–应变曲线宏观没有明显区别，仍然表现出压密、弹性、屈服和破坏阶段；单轴压缩分级松弛试验的应力–应变曲线，在松弛期间出现局部应力跌落特征；常规单轴压缩得到的力学参数明显高于分级松弛试验值，表现出煤样的力学参数具有时效特征；当松弛应力比低于70%时，应力松弛特征不明显，当松弛应力比高于70%时，煤样内部强度较高材料积蓄的能量能够使低强度材料逐步损伤破坏，高强度材料将承载更高应力也逐渐趋于破坏，松弛应力比越高，持续破坏时间越短，反之则持续破坏时间越长；常规单轴压缩破坏具有明显张剪性破裂面，分级松弛试验时煤样破坏裂纹沿加载方向扩展后碎裂成许多相对较薄片状和片状碎屑，表现出明显的侧向膨胀特征。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章

关键词 ：岩石力学, 单轴压缩, 分级松弛, 时效特征, 变形特征, 强度特征

Abstract：The uniaxial compression with stepped relaxation was conducted on coal samples with the testing system of rock mechanics RMT–150B. The aging characteristics of deformation，strength and failure of coal samples under uniaxial compression and uniaxial compression with stepped relaxation were analyzed. The results show that the stress-strain curves ahead of the peak values of coal samples at two loading conditions have four conventional stages，i.e. densification，elastic，yielding and failure. The stress-strain curves of uniaxial compression with stepped relaxations have a local drop of stress during the relaxation. The values of mechanical parameters of uniaxial compression are higher than ones of that with stepped relaxation，showing that the mechanical parameters of coal samples have aging characteristics. When the ratio of stress relaxation is lower than 70%，the characteristics of stress relaxation is not obvious. When the ratio of stress relaxation is higher than 70%，materials of lower strengths were gradually damaged by the energy stored in the materials of higher strength inside coal samples and the materials of higher strength carried higher stresses and were also be damaged gradually. The higher the ratio of the stress relaxation was，the shorter the length of time of failure was. There were noticeable surfaces of tension-shear fracturing for failure samples under uniaxial compression；but the failure cracks of coal samples in the stepped relaxation tests were in loading directions and many chippings and fragments were formed，showing clearly a characteristic of lateral expansion.

Key words： rock mechanics uniaxial compression stepped relaxation aging characteristics deformation characteristics strength characteristics

收稿日期: 2013-09-17

引用本文:

苏承东，陈晓祥，袁瑞甫. 单轴压缩分级松弛作用下煤样变形与强度特征分析[J]. 岩石力学与工程学报, 2014, 33(6): 1135-1141.
SU Chengdong，CHEN Xiaoxiang，YUAN Ruifu. ANALYSIS OF DEFORMATION AND STRENGTH CHARACTERISTICS OF COAL SAMPLES UNDER UNIAXIAL COMPRESSION OF STEPPED RELAXATION. , 2014, 33(6): 1135-1141.

链接本文:

https://rockmech.whrsm.ac.cn/CN/Y2014/V33/I6/1135

[1]	宁宇. 大采高综采煤壁片帮冒顶机制与控制技术[J]. 煤炭学报，2009，34(1)：50-53.(NING Yu. Mechanism and control technique of the rib spalling in fully mechanized mining face with great mining height[J]. Journal of China Coal Society，2009，34(1)：50-53.(in Chinese))
[2]	尹希文，闫少宏，安宇. 用压杆理论分析大采高综采面煤壁片帮特征[J]. 采矿与安全工程学报，2008，25(2)：222-225.(YIN Xiwen，YAN Shaohong，AN Yu. Characters of the rib spalling in fully mechanized caving face with great mining height[J]. Journal of Mining and Safety Engineering，2008，25(2)：222-225.(in Chinese)) " target="_blank">
[3]	闫少宏，尹希文. 大采高综放开采几个理论问题的研究[J]. 煤炭学报，2008，33(5)：481-485.(YAN Shaohong，YIN Xiwen. Discussing about the main theoretical problems of long wall with top coal caving[J]. Journal of China Coal Society，2008，33(5)：481-485.(in Chinese))
[4]	方新秋，何杰，李海潮. 软煤综放面煤壁片帮机制及防治研究[J]. 中国矿业大学学报，2009，38(5)：640-644.(FANG Xinqiu，HE Jie，LI Haichao. Study of the rib fall mechanism in sofa coal and its control at a fully-mechanized top-coal caving face[J]. Journal of China University of Mining and Technology，2009，38(5)：640-644.(in Chinese)) " target="_blank">
[5]	刘长友，黄炳香，常兴民，等. 极软厚煤层大采高台阶式综采端面煤岩稳定性控制研究[J]. 中国矿业大学学报，2008，37(6)：734-738. (LIU Changyou，HUANG Bingxiang，CHANG Xingmin，et al. Study on tip-to-face coal and rock stability control of fully mechanized stepped large cutting height mining in extremely soft thick seam[J]. Journal of China University of Mining and Technology，2008，37(6)：734-738.(in Chinese)) " target="_blank">
[6]	方新秋，钱鸣高，曹胜根，等. 综放开采不同顶煤端面顶板稳定性及其控制[J]. 中国矿业大学学报，2002，31(1)：69-74.(FANG Xinqiu，QIAN Minggao，CAO Shenggen，et al. Research on tip-to-face roof stability and its control for different hardness coals in fully-mechanized top-coal caving mining[J]. Journal of China University of Mining and Technology，2002，31(1)：69-74.(in Chinese)) " target="_blank">
[7]	温运峰，高永格，蔡振禹. 厚煤层综采面煤壁片帮冒顶严重的原因分析[J]. 河北建筑科技学院学报，2004，21(12)：69-71.(WEN Yunfeng，GAO Yongge，CAI Zhenyu. Analyzing the causes of side fall roof in thick coal with fully-mechanized faces[J]. Journal of Hebei Institute of Architectural Science and Technology，2004，21(12)：69-71.(in Chinese)) " target="_blank">
[8]	王家臣. 极软厚煤层煤壁片帮与防治机制[J]. 煤炭学报，2007，32(8)：785-788.(WANG Jiachen. Mechanism of the rib palling and the controlling in the soft coal seam[J]. Journal of China Coal Society，2007，32(8)：785-788.(in Chinese))
[9]	杨艳霜，周辉，张传庆，等. 大理岩单轴压缩时滞性破坏的试验研究[J]. 岩土力学，2011，32(9)：2 714-2 720.(YANG Yanshuang，ZHOU Hui，ZHANG Chuanqing，et al. Experimental investigation on time-lag failure properties of marble under uniaxial compressive test[J]. Rock and Soil Mechanics，2011，32(9)：2 714-2 720.(in Chinese)) " target="_blank">
[10]	冯涛，王文星，潘长良. 岩石应力松弛试验及两类岩爆研究[J]. 湘潭矿业学院学报，2000，15(1)：27-31.(FENG Tao，WANG Wenxing，PAN Changliang. Load relaxation tests of rock and research on two types of rockburst[J]. Journal of Xiangtan Mining Industry，2000，15(1)：27-31.(in Chinese)) " target="_blank">
[11]	唐礼忠，潘长良. 岩石在峰值荷载变形条件下的松弛试验研究[J]. 岩土力学，2003，24(6)：940-942.(TANG Lizhong，PAN Changlang. Experiment study on properties of stress relaxation of rock under deformation at peak load[J]. Rock and Soil Mechanics，2003，24(6)：940-942.(in Chinese)) " target="_blank">
[12]	李永盛. 单轴压缩条件下四种岩石的蠕变和松弛试验研究[J]. 岩石力学与工程学报，1995，14(1)：39-47.(LI Yongsheng. Creep and relaxation of four kinds of rocks under uniaxial compression tests[J]. Chinese Journal of Rock Mechanics and Engineering，1995，14(1)：39-47.(in Chinese))
[13]	杨春和，白世伟，吴益民. 应力水平及加载路径对盐岩时效的影响[J]. 岩石力学与工程学报，2000，19(3)：270-275.(YANG Chunhe，BAI Shiwei，WU Yimin. Effect of stress level and loading path on time dependent properties of salt rock[J]. Chinese Journal of Rock Mechanics and Engineering，2000，19(3)：270-275.(in Chinese))
[14]	中华人民共和国行业标准编写组. GT/T223561.6—2009 煤与岩石物理力学性质测定方法[S]. 北京：中国标准出版社，2010.(The Professional Standards Compilation Group of People?s Republic of China. GT/T223561.6—2009 Methods for determining the physical and mechanical properties of coal and rock[S]. Beijing：Standards Press of China，2010.(in Chinese)) " target="_blank">