冲击载荷作用下含孔洞大理岩动态力学破坏特性试验研究

doi:10.13722/j.cnki.jrme.2015.02.004

摘要
图/表
参考文献
相关文章 (15)

全文: PDF (14265 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要利用一种大理岩试件加工制备含圆形和椭圆形孔洞的板状试样，试样尺寸为60 mm×60 mm×15 mm，使用75 mm杆径的分离式霍普金森压杆(SHPB)进行冲击压缩试验，通过超动态应变仪监测入射杆和透射杆的应变信号，利用高速摄像仪记录试样完整的裂纹萌生、扩展、贯通直至试样破坏的全过程，分析冲击载荷作用下预制孔洞试样的动态抗压强度、破坏模式和裂纹扩展特性。研究发现，孔洞大小、形状和空间位置对岩石的动态抗压强度都有一定影响，孔洞的存在降低了大理岩试样的动态抗压强度。在冲击载荷作用下，预制中心孔洞的大理岩试样在孔洞周边产生平行于轴向加载方向的初始拉伸裂纹和类X型初始剪切裂纹，在试件破坏中起主导作用。圆形孔洞试样中，随着孔径增大，剪切裂纹扩展速度随之增大，而拉伸裂纹扩展速度则减小；椭圆形孔洞的长短轴比、长轴与加载方向的夹角均是影响裂纹扩展速度和动态抗压强度的因素。在30～45 s－1的加载应变率范围内，大理岩孔洞试样的平均裂纹扩展速度为100～450 m/s。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章

关键词 ：岩石力学, 大理岩, 冲击载荷, 孔洞试样, 裂纹扩展

Abstract：The dynamic compressive tests were carried out with ?75 mm split Hopkinson pressure bar(SHPB) on the plate-shape marble specimens(size of 60 mm×60 mm×15 mm) with a single circular or an elliptical hole in the center of the specimen. The dynamic strain signals in the incident bar and the transmitted bar were monitored with the ultra-dynamic strain indicator. The process of crack initiation，propagation and coalescence in the marble specimens was recorded with a high speed video camera. The dynamic strength，failure mode and crack propagation characteristics of the specimens were analyzed and discussed. It is found that the rock dynamic strength is influenced by the size，the shape and the spatial location of the water jet cut hole. The strength of the holed specimen is obviously smaller than that of the intact marble specimen. Axial tensile cracks parallel to the loading direction and X-type shear cracks surrounding the hole are the dominant factors for the failure of the specimens. With the increase of the diameter of the round hole，the speed of shear crack propagation increases while the speed of tensile crack propagation decreases. For the specimens containing an elliptical hole，the eccentricity and the angle between the loading direction and the long axes influence the cracking behavior and dynamic strength under impact loading. The average speed of dynamic crack propagation of the marble specimens is in the range of 100–450 m/s at the loading rate of 30–45 s－1.

Key words： rock mechanics marble impact load single hole specimen crack propagation

收稿日期: 2014-03-24

引用本文:

李地元，成腾蛟，周韬，李夕兵. 冲击载荷作用下含孔洞大理岩动态力学破坏特性试验研究[J]. 岩石力学与工程学报, 2015, 34(02): 249-260.
LI Diyuan，CHENG Tengjiao，ZHOU Tao，LI Xibing. EXPERIMENTAL STUDY OF THE DYNAMIC STRENGTH AND FRACTURING CHARACTERISTICS OF MARBLE SPECIMENS WITH A SINGLE HOLE UNDER IMPACT LOADING. , 2015, 34(02): 249-260.

链接本文:

http://www.rockmech.org/CN/10.13722/j.cnki.jrme.2015.02.004 或 http://www.rockmech.org/CN/Y2015/V34/I02/249

[4]	TANG C A，WONG R H C，CHAU K T，et al. Modeling of compression-induced splitting failure in heterogeneous brittle porous solids[J]. Engineering Fracture Mechanics，2005，72(4)：597-615.
[5]	WONG R H C，LIN P，TANG C A. Experimental and numerical study on splitting failure of brittle solids containing single pore under uniaxial compression[J]. Mechanics of Materials，2006，38(1)：142-159. " target="_blank">
[7]	YANG S Q，JIANG Y Z，XU W Y，et al. Experimental investigation on strength and failure behavior of pre-cracked marble under conventional triaxial compression[J]. International Journal of Solids and Structures，2008，45(17)：4 796-4 819. " target="_blank">
[13]	杨圣奇，刘相如，李玉寿. 单轴压缩下含孔洞裂隙砂岩力学特性试验分析[J]. 岩石力学与工程学报，2012，31(增2)：3 539-3 546. (YANG Shengqi，LIU Xiangru，LI Yushou. Experiment analysis of mechanical behavior of sandstone containing hole and fissure under uniaxial compression[J]. Chinese Journal of Rock Mechanics and Engineering，2012，31(Supp.2)：3 539-3 546.(in Chinese)) " target="_blank">
[17]	刘招伟，李元海. 含孔洞岩石单轴压缩下变形破裂规律的试验研究[J]. 工程力学，2010，8(8)：133-139.(LIU Zhaowei，LI Yuanhai. Experimental investigation on the deformation and crack behavior of rock specimen with a hole undergoing uniaxial compression load[J]. Engineering Mechanics，2010，8(8)：133-139.(in Chinese)) " target="_blank">
[21]	ZHOU Z，LI X，YE Z，et al. Obtaining constitutive relationship for rate-dependent rock in SHPB tests[J]. Rock Mechanics and Rock Engineering，2010，43(6)：697-706.
[25]	陈静曦. 裂纹扩展速度监测分析[J]. 岩石力学与工程学报，1998，17(4)：425-428.(CHEN Jingxi. Monitoring analysis for the velocity of crack propagation[J]. Chinese Journal of Rock Mechanics and Engineering，1998，17(4)：425-428.(in Chinese))
[1]	WONG R H C，CHAU K T，TANG C A，et al. Analysis of crack coalescence in rock-like materials containing three flaws—part I：experimental approach[J]. International Journal of Rock Mechanics and Mining Sciences，2001，38(7)：909-924. " target="_blank">
[8]	WONG L N Y，EINSTEIN H H. Systematic evaluation of cracking behavior in specimens containing single flaws under uniaxial compression[J]. International Journal of Rock Mechanics and Mining Sciences，2009，46(2)：239-249.
[27]	MARTIN C D. Seventeenth Canadian geotechnical colloquium：the effect of cohesion loss and stress path on brittle rock strength[J]. Canadian Geotechnical Journal，1997，34(5)：698-725. " target="_blank">
[6]	DYSKIN A V，SAHOURYEH E，JEWELL R J，et al. Influence of shape and locations of initial 3D cracks on their growth in uniaxial compression[J]. Engineering Fracture Mechanics，2003，70(15)：2 115-2 136. " target="_blank">
[2]	TANG C A，LIN P，WONG R H C，et al. Analysis of crack coalescence in rock-like materials containing three flaws—part II：numerical approach[J]. International Journal of Rock Mechanics and Mining Sciences，2001，38(7)：925-939. " target="_blank">
[3]	WONG R H C，TANG C A，CHAU K T，et al. Splitting failure in brittle rocks containing pre-existing flaws under uniaxial compression[J]. Engineering Fracture Mechanics，2002，69(17)：1 853-1 871. " target="_blank">
[9]	ZHANG X P，WONG L N Y. Cracking processes in rock-like material containing a single flaw under uniaxial compression：a numerical study based on parallel bonded-particle model approach[J]. Rock Mechanics and Rock Engineering，2012，45(5)：711-737.
[10]	PARK C H，BOBET A. Crack initiation，propagation and coalescence from frictional flaws in uniaxial compression[J]. Engineering Fracture Mechanics，2010，77(14)：2 727-2 748. " target="_blank">
[11]	张哲，唐春安，于庆磊，等. 侧压系数对圆孔周边松动区破坏模式影响的数值试验研究[J]. 岩土力学，2009，30(2)：413-418.(ZHANG Zhe，TANG Chun?an，YU Qinglei，et al. Numerical simulation on influence coefficient of lateral pressure on broken zone of circular aperture[J]. Rock and Soil Mechanics，2009，30(2)：413-418.(in Chinese)) " target="_blank">
[14]	马少鹏，王来贵，赵永红. 岩石圆孔结构破坏过程应变场演化的试验研究[J]. 岩土力学，2006，27(7)：1 082-1 086.(MA Shaopeng，WANG Laigui，ZHAO Yonghong. Experimental study on deformation field evolution during failure procedure of a rock borehole structure[J]. Rock and Soil Mechanics，2006，27(7)：1 082-1 086.(in Chinese)) " target="_blank">
[18]	张平，李宁，贺若兰，等. 动载下两条断续预制裂隙贯通机制研究[J]. 岩石力学与工程学报，2006，25(6)：1 210-1 217.(ZHANG Ping，LI Ning，HE Ruolan，et al. Mechanism of fracture coalescence between two pre-existing flaws under dynamic loading[J]. Chinese Journal of Rock Mechanics and Engineering，2006，25(6)：1 210-1 217. (in Chinese)) " target="_blank">
[19]	张平，李宁，贺若兰，等. 动载下3条断续预制裂隙岩样的裂缝贯通机制[J]. 岩土力学，2006，25(9)：1 457-1 464.(ZHANG Ping，LI Ning，HE Ruolan，et al. Fracture coalescence mechanism of three-intermittent-flaws rock specimen under dynamic loading[J]. Rock and Soil Mechanics，2006，25(9)：1 457-1 464.(in Chinese)) " target="_blank">
[22]	ZHANG Q B，ZHAO J. A review of dynamic experimental techniques and mechanical behaviour of rock materials[J]. Rock Mechanics and Rock Engineering，2014，47(4)：1 411-1 478. " target="_blank">
[23]	DAI F，CHEN R，XIA K. A semi-circular bend technique for determining dynamic fracture toughness[J]. Experimental Mechanics，2010，50(6)：783-791.
[26]	李夕兵，古德生. 岩石冲击动力学[M]. 长沙：中南工业大学出版社，1994：11-12.(LI Xibing，GU Desheng. Rock impact dynamics[M]. Changsha：Central South University of Technology Press，1994：11-12.(in Chinese)) " target="_blank">
[12]	杨圣奇，吕朝辉，渠涛. 含单个孔洞大理岩裂纹扩展细观试验和模拟[J]. 中国矿业大学学报，2009，38(6)：774-781.(YANG Shengqi，LU Chaohui，QU Tao. Investigations of crack expansion in marble having a single pre-existing hole：experiment and simulations[J]. Journal of China University of Mining and Technology，2009，38(6)：774-781.(in Chinese)) " target="_blank">
[15]	李英杰，潘一山，张顶立. 岩石孔洞试件变形破坏的电测法试验[J]. 北京交通大学学报，2011，35(4)：78-82.(LI Yinjie，PAN Yishan，ZHANG Dingli. Electrometric experimental study on the deformation and failure of the rock with borehole[J]. Journal of Beijing Jiaotong University，2011，35(4)：78-82.(in Chinese)) " target="_blank">
[16]	李地元，李夕兵，李春林，等. 单轴压缩下含预制孔洞板状花岗岩试样力学响应的试验和数值研究[J]. 岩石力学与工程学报，2011，30(6)：1 198-1 206(LI Diyuan，LI Xibing，LI C Charlie，et al. Experimental and numerical studies of mechanical response of plate-shape granite samples containing prefabricated holes under uniaxial compression[J]. Chinese Journal of Rock Mechanics and Engineering，2011，30(6)：1 198-1 206.(in Chinese)) " target="_blank">
[20]	ZHANG X P，WONG L N Y. Loading rate effects on cracking behavior of flaw-contained specimens under uniaxial compression[J]. International Journal of Fracture，2013，180(1)：93-110.
[24]	倪敏，苟小平，王启智. 霍普金森杆冲击压缩单裂纹圆孔板的岩石动态断裂韧度试验方法[J]. 工程力学，2013，30(1)：365-372.(NI Ming，GE Xiaoping，WANG Qizhi. Test method for rock dynamic fracture toughness using single cleavage drilled compression specimen impacted by Split Hopkinson Pressure Bar[J]. Engineering Mechanics，2013，30(1)：365-372.(in Chinese))