常截面滚刀贯入试验中岩石破坏行为分析

doi:10.13722/j.cnki.jrme.2015.0532

摘要
图/表
参考文献(25)
相关文章 (15)

全文: PDF (923 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要为研究滚刀贯入过程中不同强度岩石的破坏行为，采用泥岩、花岗岩、砂岩和水泥砂浆制作立方体试样，结合岩石贯入试验加载系统和声发射监测系统，进行无侧向约束条件和有侧向约束条件下TBM常截面盘形滚刀贯入试验，获得完整荷载–贯入度曲线和声发射参数信息，分析不同岩石试样的破坏过程、破坏类型和破坏模式。结果表明：(1) 软岩试样荷载–贯入度曲线跌落现象不明显，呈现延性破坏特征，而硬岩试样荷载–贯入度曲线跌落现象显著，具有脆性断裂特征。(2) 无侧向约束条件下试样破坏类型属于劈裂破坏模式，有侧向约束条件下试样破坏过程由中间劈裂裂纹和侧向裂纹共同控制。(3) 声发射参数曲线和荷载–贯入度曲线之间具有良好的对应关系，可以反映贯入过程中岩石试样内部损伤劣化和宏观裂纹形成过程。(4) 类岩石材料滚刀贯入试验在一定程度上有助于更好地理解岩石贯入破坏过程和破坏模式，但类岩石材料与自然岩石材料在强度和变形性质上并不能完全吻合，因此相似材料模拟试验的结果需要进一步的验证。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	刘泉声1
	潘玉丛1
	刘建平1
	孔晓璇2
	时凯3
	刘琪2

关键词 ：岩石力学, 隧道掘进机, 常截面滚刀, 贯入试验, 声发射

Abstract：The rock loading system and acoustic emission monitoring system were employed to conduct the indentation tests on four rocks with different strengths，namely mudstone，granite，sandstone and cement mortar specimens with cubic dimensions，with or without lateral confinement. The complete load-penetration curves and acoustic emission parameters were analysed together，and the process，form and mode of the rock fragmentation by TBM constant cross section(CCS) disc cutter were studied. The load drop of the load-penetration curve for soft rock is not obvious and the rock fragmentation presents the failure characteristic of elastoplasticity，while the load drop is remarkable in accordance with the brittle rupture for hard rock indentation test. The rock fragmentation without lateral confinement can be regarded as obvious splitting fracture mode and the failure process of the confined specimen is controlled by the combined effect of both splitting fractures and lateral fractures. The curves of acoustic emission parameters are in good agreement with the load-penetration curves and can generally reflect the damage，degradation and fracture formation of the indented rock specimens. The indentation tests conducted on the rock-like material can reproduce the fragmentation process and failure mode of the natural rock at some extent，but due to the discordances of the strength and deformation properties between rock-like material and natural rock，the results obtained from similar material simulations should be further investigated.

Key words： rock mechanics tunnel boring machine(TBM) constant cross section(CCS) disc cutter indentation test acoustic emission(AE)

引用本文:

刘泉声1，潘玉丛1，刘建平1，孔晓璇2，时凯3，刘琪2. 常截面滚刀贯入试验中岩石破坏行为分析[J]. 岩石力学与工程学报, 2016, 35(S2): 3516-3525.
LIU Quansheng1，PAN Yucong1，LIU Jianping1，KONG Xiaoxuan2，SHI Kai3，LIU Qi2. Analysis on fragmentation behavior of rocks in indentation tests by disc cutter. , 2016, 35(S2): 3516-3525.

链接本文:

https://rockmech.whrsm.ac.cn/CN/10.13722/j.cnki.jrme.2015.0532 或 https://rockmech.whrsm.ac.cn/CN/Y2016/V35/IS2/3516

[1]	YINL J，GONGQ M，MAH S，et al. Use of indentation tests to study the influence of confining stress on rock fragmentation by a TBM cutter[J]. International Journal of Rock Mechanics and Mining Sciences，2014，72：261-276.
[2]	莫振泽，李海波，周青春，等. 楔刀作用下岩石微观劣化的试验研究[J]. 岩土力学，2012，33(5)：1333-1340.(MO Zhenze，LI Haibo，ZHOU Qingchun，et al.Experimental study of rock microscopic deterioration under wedge cutter[J].Rock and Soil Mechanics，2012，33(5)：1333-1340.(in Chinese))
[3]	邹飞，李海波，周青春，等. 岩石节理倾角和间距对隧道掘进机破岩特性影响的试验研究[J]. 岩土力学，2012，33(6)：1640-1646.(ZOU Fei，LI Haibo，ZHOU Qingchun，et al. Experimental study of influence of joint space and joint angle on rockfragmentation by TBM disc cutter[J].Rock and Soil Mechanics，2012，33(6)：1640-1646.(in Chinese))
[4]	马洪素，纪洪广. 节理倾向对 TBM 滚刀破岩模式及掘进速率影响的试验研究[J]. 岩石力学与工程学报，2011，30(1)：155-163.(MA Hongsu，JI Hongguang. Experimental study of the effect of joint orientation on fragmentation modes and penetration rate under TBMdisc cutters[J]. Chinese Journal of Rock Mechanics and Engineering，2011，30(1)：155-163.(in Chinese))
[5]	陈立宪，黄国忠，陈尧中. 岩体贯切破坏在不同侧向自由边界的声发射演化[J]. 岩石力学与工程学报，2009，28(12)：2411-2420. (CHENLixian，HUANGGuozhong，CHENYaozhong. Acoustic emission evolution in indentation fracture of rocks under different lateral stress-free boundaries[J]. Chinese Journal of Rock Mechanics and Engineering，2009，28(12)：2411-2420.(in Chinese))
[6]	CHENL H，LABUZJ F. Indentation of rock by wedge-shaped tools[J]. International Journal of Rock Mechanics and Mining Sciences，2006，43(7)：1023-1033.
[7]	ZHANGH，HUANGG，SONGH，et al. Experimental investigation of deformation and failure mechanisms in rock under indentation by digital image correlation[J]. Engineering Fracture Mechanics，2012，96：667-675.
[8]	LIUH Y，KOUS Q，LINDQVISTP A，et al. Numerical simulation of the rock fragmentation process induced by indenters[J]. International Journalof Rock Mechanics and Mining Sciences，2002，39(4)：491-505.
[9]	MAHS，YINLJ，JIHG. Numerical study of the effect of confining stress on rock fragmentation by TBM cutters[J]. International Journal of Rock Mechanics and Mining Sciences，2011，48(6)：1021-1033.
[10]	GERTSCHR，GERTSCHL，ROSTAMIJ. Disc cutting tests in Colorado Red Granite：implications for TBM performance prediction[J]. International Journal of Rock Mechanics and Mining Sciences，2007，44(2)：238-246.
[11]	CHOJ W，JEONS，JEONGH Y，et al. Evaluation of cutting efficiency during TBM disc cutter excavation within a Korean granitic rock using linear-cutting-machine testing and photogrammetric measurement[J]. Tunnelling and Underground Space Technology，2013，35(4)：37-54.
[12]	BALCIC，TUMACD. Investigation into the effects of different rocks on rock cuttability by a V-type disc cutter[J]. Tunnelling and Underground Space Technology，2012，30(4)：183-193.
[13]	朱逸. TBM多滚刀组合破岩特性的数值模拟及实验研究[硕士学位论文][D]. 长沙：中南大学，2013.(ZHU Yi.Numerical simulation and experimental study of rockfragmentation characteristic by TBM disc cutters[M. S.Thesis][D]. Changsha：Central SouthUniversity，2013.(in Chinese))
[14]	徐孜军. 盾构刀具破岩特性的数值模拟及实验研究[硕士学位论文][D]. 长沙：中南大学，2012.(XU Zijun.Numerical simulation and experimental study of rockbreaking mechanism by shield machine cutters[M. S.Thesis][D]. Changsha：Central SouthUniversity，2012.(in Chinese))
[15]	谭青，易念恩，夏毅敏，等. TBM 滚刀破岩动态特性与最优刀间距研究[J]. 岩石力学与工程学报，2012，31(12)：2453-2464.(TAN Qing，YI Nian¢en，XIA Yimin，et al.Research on rock dynamic fragmentationcharacteristics by TBMcutters and cutter spacingoptimization[J].Chinese Journal of Rock Mechanics and Engineering，2012，31(12)：2453-2464.(in Chinese))
[16]	谭青，徐孜军，夏毅敏，等. 2 种切削顺序下TBM刀具破岩机制的数值研究[J]. 中南大学学报：自然科学版，2012，43(3)：940-946.(TAN Qing，XU Zijun，XIA Yimin，et al. Numerical study on mode of breaking rock by TBM cutter intwo cutting orders[J]. Journal of Central South University：Science and Technology，2012，43(3)：940-946.(in Chinese))
[17]	孙金山，陈明，陈保国，等. TBM 滚刀破岩过程影响因素数值模拟研究[J]. 岩土力学，2011，32(6)：1891-1897.(SUN Jinshan，CHEN Ming，CHEN Baoguo，et al.Numerical simulaiton of influence factors for rock fragmentation by TBM cutters[J].Rock and Soil Mechanics，2011，32(6)：1891-1897.(in Chinese))
[18]	张魁，夏毅敏，谭青，等. 不同围压条件下TBM刀具破岩模式的数值研究[J]. 岩土工程学报，2010，32(11)：1780-1787.(ZHANG Kui，XIA Yimin，TAN Qing，et al. Numerical study on modes of breaking rock by TBM cutter under differentconfining pressures[J]. Chinese journal of GeotechnicalEngineering，2010，32(11)：1780-1787.(in Chinese))
[19]	TEALER. The concept of specific energy in rock drilling[J]. International Journal of Rock Mechanics and Mining Sciences andGeomechanics Abstracts，1965，2(1)：57-73.
[20]	TUMACD，BALCIC. Investigations into the cutting characteristics of CCS type disc cutters and the comparison between experimental，theoretical and empirical force estimations[J]. Tunnelling and Underground Space Technology，2015，45：84-98.
[21]	DOLLINGERG L. Choosing cutters for best boreability[J]. Compressed Air，1977，82(9)：15-19.
[22]	GOKTANR M. Brittleness and micro-scale rock cutting efficiency[J]. Mining Science and Technology，1991，13(3)：237-241.
[23]	BLINDHEIMO T，BRULANDA. Boreability testing，Norwegian TBM tunneling 30 years of experience with TBMs in Norwegian Tunneling[J].Norwegian Soil and Rock Engineering Association，1998，(1)：29-34.
[24]	赵兴东，唐春安，李元辉，等. 花岗岩破裂全过程的声发射特性研究[J]. 岩石力学与工程学报，2006，25(增2)：3 673-3 678.(ZHAO Xingdong，TANG Chun¢an，LI Yuanhui，et al.Study on AEactivity characteristics under uniaxialcompression loading[J]. Chinese Journal of Rock Mechanics and Engineering，2006，25(Supp.2)：3 673- 3 678.(in Chinese))
[25]	蒋宇. 周期荷载作用下岩石疲劳破坏及变形发展规律[硕士学位论文][D]. 上海：上海交通大学，2003.(JIANG Yu.Fatigue failure and deformation developmentlaw of rock under cyclic load[M. S.Thesis][D]. Shanghai：Shanghai Jiaotong University，2003.(in Chinese))