水平井多段压裂多裂缝扩展形态计算方法

doi:10.13722/j.cnki.jrme.2015.1365

摘要
图/表
参考文献(28)
相关文章 (15)

全文: PDF (1810 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要为解决水平井多段压裂多裂缝扩展形态问题，基于位移不连续边界元法建立三维裂缝应力场计算模型，并结合裂缝的不同边界条件和亚临界裂缝扩展模型，给出多裂缝扩展形态计算方法。通过与UFM模型对比，验证方法可靠性。根据该算法，研究不同压裂方式、不同缝间距与缝高、不同净压力与主应力差的多裂缝扩展形态，结果表明：对于多段单簇压裂，后续压裂缝会靠近或远离已压开流体内压缝，而已压开支撑剂充填裂缝对后续压裂缝扩展轨迹影响较小；多簇压裂外侧裂缝为主扩展裂缝，中间裂缝扩展长度减小；对于早先压裂缝为流体内压缝的情况，缝间距与缝高的比值不仅影响裂缝偏转角度，还影响裂缝偏转方向；对于两簇同时扩展的情况，缝间距与缝高的比值越小，或净压力与主应力差的比值越大，裂缝发生偏转的角度越大；对于多簇压裂方式，增大缝间距与缝高的比值有利于多簇裂缝的均匀延伸，而改变净压力与主应力差的比值并不能改变各簇缝长的分布情况。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	陈铭1
	胥云2
	3
	翁定为2
	3

关键词 ：岩石力学, 多段压裂, 多裂缝, 位移不连续法, 应力干扰, 扩展形态, 计算模型

Abstract：For the issue of multi-fracture geometry by multi-stage fracturing in horizontal wells，a multi-fracture propagation-path algorithm was proposed，by incorporating a 3D-fracture stress field calculation model based on displacement discontinuity method，different fracture boundary conditions and subcritical fracture growth law. The algorithm was validated by UFM. Multi-fracture propagation paths for multi-stage fracturing in horizontal wells were investigated by the algorithm，and the results show that later fractures curve toward or away from previous pressurized fractures，while later fractures keep straight paths affected by sand-filled fractures. The exterior fractures propagate dominantly，but the inner fractures were suppressed due to stress shadow effect. Later fractures deviate toward the previous pressurized fracture when the ratio of fracture spacing to fracture height is less than one，and the smaller the ratio，the larger the deviation angle，otherwise they deviate away from the previous pressurized fracture or propagate straightly. The smaller the ratio of fracture spacing to fracture height，or the larger the ratio of net pressure to principle stress difference，the larger the deviation angle for two simultaneous- propagation fractures. Increasing the ratio of fracture spacing to fracture height promotes uniform fracture-length distribution，while changing the ratio of net pressure to principle stress difference can not change fracture-length distribution for multi-fractures by multi-cluster fracturing.

Key words： rock mechanics multi-stage fracturing multiple fractures displacement discontinuity method stress interference propagation path calculation model

引用本文:

陈铭1，胥云2，3，翁定为2，3. 水平井多段压裂多裂缝扩展形态计算方法[J]. 岩石力学与工程学报, 2016, 35(S2): 3906-3915.
CHEN Ming1，XU Yun2，3，WENG Dingwei2，3. Calculation method for multi-fracture propagation geometry of multi-stage fracturing in horizontal wells. , 2016, 35(S2): 3906-3915.

链接本文:

https://rockmech.whrsm.ac.cn/CN/10.13722/j.cnki.jrme.2015.1365 或 https://rockmech.whrsm.ac.cn/CN/Y2016/V35/IS2/3906

[1]	吴奇，胥云，王晓泉，等. 非常规油气藏体积改造技术——内涵、优化设计与实现[J]. 石油勘探与开发，2012，39(3)：252-258.(WU Qi，XU Yun，WANG Xiaoquan，et al. Volume fracturing technology of unconventional reservoirs：connotation，optimization design and implementation[J]. Petroleum Exploration and Development，2012，39(3)：252-258.(in Chinese))
[2]	吴奇，胥云，王腾飞，等. 增产改造理念的重大变革——体积改造技术概论[J]. 天然气工业，2011，31(4)：7-12.(WU Qi，XU Yun，WANG Tengfei，et al. The resolution of reservoir stimulation：an introduction of volume fracturing[J]. Natural Gas Industry，2011，31(4)：7-12.(in Chinese))
[3]	FISHERM K，HEINZEJ R，HARRISC D，et al. Optimizing horizontal completion techniques in the Barnett shale using microseismic fracture mapping[C]//SPE Annual Technical Conference and Exhibition. Houston：Society of Petroleum Engineers，2004：1-11.
[4]	NAGELN B，Sanchez-NagelM. Stress shadowing and microseismic event：a numerical evaluation[C]//SPE Annual Technical Conference and Exhibition. Denver：Society of Petroleum Engineers，2011：1-21.
[5]	LI G，ALLISON D，SOLIMAN M Y. Geomechanical study of the multistage fracturing process for horizontal wells[C]//45th US Rock Mechanics/Geomechanics Symposium. San Francisco：American Rock Mechanics Association，2011：1-11.
[6]	SOLIMAN M Y，EASTL，AdamsD. Geomechanics aspects of multiple fracturing of horizontal and vertical wells[C]//SPE International Thermal Operations and Heavy Oil Symposium and Western Regional Meeting. California：Society of Petroleum Engineers，2004：1-15.
[7]	尹陈，刘鸿，李亚林，等. 微地震监测定位精度分析[J]. 地球物理学进展，2013，28(2)：800-807.(YIN Chen，LIU Hong，LI Yalin，et al. The precision analysis of the microseismic location[J]. Progress in geophysics，2013，28(2)：800-807.(in Chinese))
[8]	CIPOLLAC L，WRIGHTC A. Diagnostic techniques to understand hydraulic fracturing：what?why? and how?[C]//SPE/CERI Gas Technology Symposium. Calgary：Society of Petroleum Engineers，2000：1-14.
[9]	李健，吴顺川，高永涛，等. 露天矿边坡微地震监测研究综述[J]. 岩石力学与工程学报，2014，33(增2)：3998-4013.(LI Jian，WU Shunchuan，GAO Yongtao，et al. Review of slope micro-seismic monitoring in open-pit mine[J]. Chinese Journal of Rock Mechanics and Engineering，2014，33(Supp.2)：3998-4013.(in Chinese))
[10]	RabaaWE. Experimental study of hydraulic fracture geometry initiated from horizontal wells[C]//SPE Annual Technical Conference and Exhibition. Texas：Society of Petroleum Engineers，1989：189-214.
[11]	YEWC H，MEARM E，CHANGC C，et al. On perforating and fracturing of deviated cased wellbores[C]//SPE Annual Technical Conference and Exhibition. Houston：Society of Petroleum Engineers，1993：75-86.
[12]	ADAVHIJ，SIEBRITSE，PEIRCEA，et al. Computer simulation of hydraulic fractures[J]. International Journal of Rock Mechanics and Mining Sciences，2007，44(5)：739-757.
[13]	OLSONJ E. Multi-fracture propagation modeling：Applications to hydraulic fracturing in shales and tight gas sands[C]//The 42nd US rock mechanics symposium(USRMS). San Francisco：American Rock Mechanics Association，2008：1-8.
[14]	WUR，KRESSEO，WENGX，et al. Modeling of interaction of hydraulic fractures in complex fracture networks[C]//SPE Hydraulic Fracturing Technology Conference. Woodlands：Society of Petroleum Engineers，2012：1-14.
[15]	BUNGERA P，ZHANGX，JEFFREYR G. Parameters affecting the interaction among closely spaced hydraulic fractures[J]. SPE Journal，2012，17(1)：292-306.
[16]	JOH. Optimizing fracture spacing to induce complex fractures in a hydraulically fractured horizontalwellbore[C]//SPE Americas Unconventional Resources Conference. Pittsburgh：Society of Petroleum Engineers，2012：1-14.
[17]	SESETTY V，GHASSEMI. A numerical study of sequential and simultaneous hydraulic fracturing in single and multi-lateral horizontal wells[J]. Journal of Petroleum Science and Engineering，2015：65-76.
[18]	RousselN P，SharmaM M. Strategies to minimize frac spacing and stimulate natural fractures in horizontal completions[C]//SPE Annual Technical Conference and Exhibition. Denver：Society of Petroleum Engineers，2011：1-17.
[19]	王理想，唐德泓，李世海，等. 基于混合方法的二维水力压裂数值模拟[J]. 力学学报，2015，47(6)：973-983.(WANG Lixiang，TANG dehong，LI Shihai，et al. Numerical simulation of hydraulic fracturing by a mixed method in two dimensions[J]. Chinese Journal of Theoretical and Applied Mechanics，2015，47(6)：973-983.(in Chinese))
[20]	郭建春，尹建，赵志红. 裂缝干扰下页岩储层压裂形成复杂裂缝可能性[J]. 岩石力学与工程学报，2014，33(8)：1589-1596.(GUO Jianchun，YIN Jian，ZHAO Zhihong. Feasibility of formation of complex fractures under cracks interference in shale reservoir fracturing[J]. Chinese Journal of Rock Mechanics and Engineering，2014，33(8)：1589-1596.(in Chinese))
[21]	赵金洲，陈曦宇，刘长宇，等. 水平井分段多簇压裂缝间干扰影响分析[J]. 天然气地球科学，2015，26(3)：533-538.(ZHAO Jinzhou，CHEN Xiyu，LIU Changyu，et al. The analysis of crack interaction in multi-stage horizontal fracturing[J]. Natural Gas Geoscience，2015，26(3)：533-538.(in Chinese))
[22]	CROUCHS L. Solution of plane elasticity problems by the displacement discontinuity method. I. Infinite body solution[J]. International Journal for Numerical Methods in Engineering，1976，10(2)：301-343.
[23]	OLSON J E. Predicting fracture swarms—The influence of subcritical crack growth and the crack-tip process zone on joint spacing in rock[J]. Geological Society，London，Special Publications，2004，231(1)：73-88.
[24]	吴奇，胥云，张守良，等. 非常规油气藏体积改造技术核心理论与优化设计关键[J]. 石油学报，2014，35(4)：706-714.(WU Qi，XU Yun，ZHANG Shouliang，et al. The core theories and key optimization designs of volume stimulation technology for unconventional reservoirs[J]. Acta Petrolei Sinica，2014，35(4)：706-714.(in Chinese))
[25]	李世愚，和泰名，尹祥础，等. 岩石断裂力学导论[M]. 合肥：中国科学技术大学出版社，2010：45-46.(LI Shiyu，HE Taiming，YIN Xiangchu，et al. Introduction of rock fracture mechanics[M].Hefei：Press of University of Science and Technology of China，2010：45-46.(in Chinese))
[26]	SHEIBANI F，OLSON J E. Stress intensity factor determination for three-dimensional crack using the displacement discontinuity method with applications to hydraulic fracture height growth and non-planar propagation paths[C]//ISRM International Conference for Effective and Sustainable Hydraulic Fracturing. Brisbane：International Society for Rock Mechanics，2013：741-770.
[27]	BROEK D. Elementary engineering fracture mechanics[M]. London：Springer Science andBusiness Media，1982：18-21.
[28]	DONGC Y，DEPATERC J. Numerical implementation of displacement discontinuity method and its application in hydraulic fracturing[J]. Computer Methodsin Applied Mechanics and Engineering，2001，191(8)：745-760.