中空注浆锚索周边剪应力分布规律研究

doi:10.13722/j.cnki.jrme.2014.s2.059

Abstract
Figure/Table
References (18)
Related Citation (15)

Download: PDF (1272 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract Hollow grouting anchor cables(HGAC) integrates tail resin anchorage and full-size grouting anchorage. The shear stress between anchor agent and borehole surface in HGAC possesses distinct pattern compared with that of traditional tension concentrated anchor cables. By simplifying the mechanical model around the grouts and using the analytical solutions of Kelvin problem and Boussinesq problem，theoretical formulas of shear stress of the grouts between anchor agent and borehole surface was derived based on the theory of elasticity. FLAC3D was also used to simulate shear stress distribution around anchor cables pre- and post- grouting. The results showed that the shear stress curve present bimodal distribution along the axial direction of anchor cable. Drawing force has limited effect on the shear stress distribution of the cable tail part. It has been found that shear stress and its concentration of the end anchored segment and the grouting anchored segment were respectively proportional to the pretightening force and the drawing force，while the shear stress and its concentration of the whole anchor cable was inversely proportional to the pore diameter within certain ranges.

Key words： mining engineering hollow grouted anchor cable(HGAC) peripheral shear stress distribution law anchoring

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	LI Guichen1
	2
	3
	SUN Hui1
	2
	ZHANG Nong1
	2
	WEI Yinghao1
	2
	ZHANG Lei1
	2

Cite this article:

LI Guichen1,2,3, et al. AN INVESTIGATION INTO SHEAR STRESS DISTRIBUTION AROUND HOLLOW GROUTING ANCHOR CABLES[J]. , 2014, 33(S2): 3856-3864.

URL:

https://rockmech.whrsm.ac.cn/EN/10.13722/j.cnki.jrme.2014.s2.059 OR https://rockmech.whrsm.ac.cn/EN/Y2014/V33/IS2/3856

[1]	康红普，林健，张冰川.小孔径预应力锚索加固困难巷道的研究与实践[J].岩石力学与工程学报，2003，22(3)：387-390.(KANG Hongpu，LIN Jian，ZHANG Bingchuan. Study on small borehole pretension cable reinforcing complicated roadway[J].Chinese Journal of Rock Mechanics and Engineering，2003，22(3)：387-390.(in Chinese))
[2]	王金华.千米深井煤巷围岩变形特征及其控制技术研究[博士学位论文][D].北京：中国矿业大学，2007.(WANG Jinhua. Study on thedeformation characteristics of surrounding rock mass and supportingtechnology for 1 000 m depth coal roadway[Ph. D. Thesis][D]. Beijing：China University of Mining and Technology，2007.(in Chinese))
[3]	王泰恒，许文年，陈池，等.预应力锚固技术基本理论与实践[M]. 北京：中国水利水电出版社，2007：212-213.(WANG Taiheng，XU Wennian，CHEN Chi，et al. Prestressed anchor technology basic theory and practice[M]. Beijing：China Water Power Press，2007：212-213.(in Chinese))
[4]	肖世国，周德培.非全长黏结型锚索锚固段长度的一种确定方法[J].岩石力学与工程学报，2004，23(9)：1 530-1 538.(XIAO Shiguo，ZHOUDepei. Calculation method of length of anchoring segment for partial-cohesive cable[J]. Chinese Journal of Rock Mechanics and Engineering，2004，23(9)：1 530-1 538.(in Chinese))
[5]	PHILLIPS S H E.Factors affecting the design of anchorages in rock[R].London：Cementation Research Ltd.，1970.
[6]	HANNA TH.锚固技术在岩土工程中的应用[M]. 胡定译.北京：中国建筑工业出版社，1987：178-179.(HANNA TH. Foundations in tension[M]. Translated byHU Ding. Beijing：China Building Industry Press，1987：178-179.(in Chinese))
[7]	黄德福，赵彦辉，李宁.预应力锚固机制数值仿真分析研究[J].西北水电，1996，55(1)：8-17.(HUANG Defu，ZHAO Yanhui，LI Ning. Prestressed anchoring mechanism of the numerical simulationanalysis and research[J].Northwest Water Power，1996，55(1)：8-17.(in Chinese))
[8]	WEHR W，TEJCHMAN J，HERLE I，et al. Sand anchors—a shear zone problem[C]// Deformation and Progressive Failure in Geomechanics. Asaoka，Adachi，Oka：Elsevier Science，1997：787-792.
[9]	陆士良，汤雷，杨新安.锚杆锚固力与锚固技术[M].北京：煤炭工业出版社，1998：93-94.(LU Shiliang，TANG Lei，YANG Xin¢an. Anchoring force and anchoring techniques[M].Beijing：Coal Industry Press，1998：93-94.(in Chinese))
[10]	陆士良，付国彬，汤雷.采动巷道岩体变形与锚杆锚固力变化规律[J].中国矿业大学学报，1999，28(3)：1-3.(LU Shiliang，FU Guobin，TANG Lei.Regularity of deformation of rocks around roadway under mining influence and change of rock bolt resistance[J]. Journal of China University of Mining andTechnology，1999，28(3)：1-3.(in Chinese))
[11]	尤春安.全长黏结式锚杆的受力分析[J].岩石力学与工程学报，2000，19(3)：339-341.(YOU Chun¢an. Mechanical analysis on wholly grouted anchor[J].Chinese Journal of Rock Mechanics and Engineering，2000，19(3)：339-341.(in Chinese))
[12]	蒋忠信.拉力型锚索锚固段剪应力分布的高斯曲线模式[J].岩土工程学报，2001，23(6)：45-48.(JIANG Zhongxin. A Gauss curve model on shear stress along anchoring section of anchoring rope of extensional force type[J].Chinese Journal of Geotechnical Engineering，2001，23(6)：45-48.(in Chinese))
[13]	邓宗伟，冷伍明，邹金锋，等. 预应力锚索荷载传递与锚固效应计算[J]. 中南大学学报：自然科学版，2011，42(2)：501-507.(DENG Zongwei，LENG Wuming，ZOU Jinfeng，et al. Calculation of pre-stress cable transference of load and effect of anchor[J]. Journal of Central South University：Science and Technology，2011，42(2)：501-507.(in Chinese))
[14]	刘建庄，张农，韩昌良.弹性拉拔中锚杆轴力和剪力分布力学计算[J].中国矿业大学学报，2012，41(3)：10-14.(LIU Jianzhuang，ZHANG Nong，HAN Changliang.Elastic stress distributions：axial and shear stress distributions in anchor bolt during a pullout test[J]. Journal of China University of Mining andTechnology，2012，41(3)：10-14.(in Chinese))
[15]	沈俊，顾金才，张向阳，等.拉力型和压力型自由式锚索现场拉拔试验研究[J].岩土学报，2012，31(增)：708-714.(SHEN Jun，GU Jincai，ZHANG Xiangyang，et al. Field pull-out test research on tension and pressure unbonded anchor cables[J].Rock and Soil Mechanics，2012，31(Supp.)：708-714.(in Chinese))
[16]	文竞舟，张永兴，王成. 隧道围岩全长黏结式锚杆界面力学模型研究[J]. 岩土力学，2013，34(6)：1 645-1 651.(WEN Jingzhou，ZHANG Yongxing，WANG Cheng. Study of mechanical model of fully grouted rock bolt¢s anchorage interfacein tunnel surrounding rock[J].Rock and Soil Mechanics，2013，34(6)：1 645-1 651.(in Chinese))
[17]	张端良，董燕军，唐乐人，等.预应力锚索锚固段周边剪应力分布特性的弹性理论分析[J].岩石力学与工程学报，2004，23(增2)：4735-4738.(ZHANG Duanliang，DONG Yanjun，TANG Leren，et al.Elasticity analysis on distribution of shear stress along anchoring section of prestressed anchor cable[J]. Chinese Journal of Rock Mechanics and Engineering，2004，23(Supp.2)：4735-4738.(in Chinese))
[18]	孙书伟，林杭，任连伟.FLAC3D在岩土工程中的应用[M]. 北京：中国水利水电出版社，2011：3-4.(SUN Shuwei，LIN Hang，REN Lianwei.Application of FLAC3Din geotechnical engineering[M].Beijing：China Water Power Press，2011：3-4.(in Chinese))