全长黏结式锚杆锚固段荷载传递机制非线性分析

doi:10.13722/j.cnki.jrme.2014.s2.076

Abstract
Figure/Table
References (16)
Related Citation (15)

Download: PDF (799 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract A novel nonlinear shear-slipping model of anchor rod according to load-displacement curve in the pullout test was established. Based on this model，the nonlinear differential equation of load transfer was established and the analytical solutions of axial force and shear stress were developed. The features of this model as well as the axial force and shear stress distributions along the anchor rod were analyzed. Results indicate that this model gives a peak value in its curve. With the slip increases，the shear stress initially goes up to the peak value then decreases，that is，this model characterizes the softening behaviors of anchorage interface reasonably. Under the pulling load，the anchorage interface undergoes three stages including elastic bonding stage，elastic-plastic deformation stage and rapidly softening stage. With the increase of pulling load，the shear stress distribution evolves from a monotone decay curve into a single peak curve and the influencing zone of the shear stress expands into far end gradually. Under the ultimate limited state，the whole anchorage interface softens rapidly into failure. The developed solutions are suitable for analyzing axial force and shear stress along anchor rod undergoing various stages，which provides theoretical reference for researches on the load transfer mechanism of wholly grouted anchor rod.

Key words： geotechnical engineering wholly grouted anchor rod shear-slipping model load transfer mechanism nonlinear analysis

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	HUANG Minghua1
	ZHOU Zhi2
	OU Jinping1
	2

Cite this article:

HUANG Minghua1,ZHOU Zhi2,OU Jinping1, et al. NONLINEAR ANALYSIS ON LOAD TRANSFER MECHANISM OF WHOLLY GROUTED ANCHOR ROD ALONG ANCHORING SECTION[J]. , 2014, 33(S2): 3992-3997.

URL:

https://rockmech.whrsm.ac.cn/EN/10.13722/j.cnki.jrme.2014.s2.076 OR https://rockmech.whrsm.ac.cn/EN/Y2014/V33/IS2/3992

[1]	叶根飞. 岩土锚固荷载传递规律与锚固特性试验研究[博士学位论文][D]. 西安：西安科技大学，2012.(YE Genfei.Law of anchorage load transfer and experimental study on anchoring characteristics[Ph.D.Thesis][D]. Xi¢an：Xi¢an University of Science and Technology，2012.(in Chinese))
[2]	何思明. 预应力锚索作用机理[博士学位论文][D]. 成都：西南交通大学，2004.(HE Siming.Study on mechanism of prestressed anchoring cable[Ph.D.Thesis][D]. Chengdu：Southwest Jiaotong University，2004.(in Chinese))
[3]	张季如，唐保付. 锚杆荷载传递机理分析的双曲函数模型[J]. 岩土工程学报，2002，24(2)：188-192.(ZHANG Jiru，TANG Baofu. Hyperbolic function model to analyze load transfer mechanism on bolts[J]. Chinese Journal of Geotechnical Engineering，2002，24(2)：188-192.(in Chinese))
[4]	KIM NK，PARK JS，KIM SK. Numerical simulation of ground anchors[J]. Computers and Geotechnics，2007，34(6)：498-507.
[5]	REN FF，YANG ZJ，CHEN JF，et al. An analytical analysis of the full-range behaviour of grouted rockbolts based on a tri-linear bond-slip model[J]. Construction and Building Materials，2010，24(3)：361-370.
[6]	ELIGEHAUSEN R，POPOV EP，BERTERO VV. Local bond stress-slip relationships of deformed bars under generalized excitations[R].Berkeley：Earthquake Engineering Research Center(EERC)，University of California，1983：162-165.
[7]	COSENZA E，MANFREDI G，REALFONZO R. Behavior and modeling of bond of FRPrebars to concrete[J]. Journal of Compositesfor Construction，1997，1(2)：40-51.
[8]	BENMOKRANET B，CHENNOUF A，MITRI HS. Laboratory evaluation of cement-based grouts and grouted rock anchors[J]. International Journal of Rock Mechanics and Mining Sciences andGeomechanics Abstracts，1995，32(7)：633-642.
[9]	MALVAR LJ. Tensile and bond properties of GFRP reinforcedbars[J]. ACI Materials Journal，1995，92(3)：276-285.
[10]	高丹盈，朱海堂，谢晶晶. 纤维增强塑料筋混凝土粘结滑移本构模型[J]. 工业建筑，2003，33(7)：41-43.(GAO Danying，ZHU Haitang，XIE Jingjing. The constitutive models for bond slip relation between FRPrebars and concrete[J]. Industrial Construction，2003，33(7)：41-43.(in Chinese))
[11]	LI CV，WARD RJ.A novel testing technique for post-peak tensile behavior of cementtious materials[C]// Proceedings of Fracture Toughness and Fracture Energy. Balkema：[s. n.]，1989：183-195.
[12]	DAI JG，UEDA T，SATOY. Unified analytical approaches for determining shear bond characteristics of FRP-concrete interfaces through pullout tests[J]. Journal of Advanced Concrete Technology，2006，4(1)：133-145.
[13]	CHIN F K. Estimation of the ultimateload of pipes from tests not carried to failure[C]// Proceedings of the 2nd SoutheastAsia Conference on Soil Engineering. Singapore：[s. n.]，1970：81-92.
[14]	龙照，张恩祥，魏永孝. 锚杆极限承载力预测模型及方法研究[J]. 勘察科学技术，2008，(5)：3-6.(LONG Zhao，ZHANG Enxiang，WEI Yongxiao. Study on prediction model of anchor rod¢s ultimate bearing capacity and its method[J]. Site Investigation Science and Technology，2008，(5)：3-6.(in Chinese))
[15]	应志民，张洁，尚岳全. 锚杆荷载-位移曲线的指数函数模型研究[J]. 岩土力学，2005，26(8)：1 331-1 334.(YING Zhimin，ZHANG Jie，SHANG Yuequan. Exponential model for simulating load-displacement curve of anchor rod[J]. Rock and Soil Mechanics，2005，26(8)：1 331-1 334.(in Chinese))
[16]	朱训国. 地下工程中注浆岩石锚杆锚固机理研究[博士学位论文][D]. 大连：大连理工大学，2006.(ZHU Xunguo.Thereinforcementmechanicsoffullygroutedrock boltinundergroundengineering[Ph.D.Thesis][D]. Dalian：DalianUniversity of Technology，2006.(in Chinese))