厚煤层无煤柱切顶成巷碎石帮变形机制及控制技术研究

doi:10.13722/j.cnki.jrme.2017.0949

Abstract
Figure/Table
References (0)
Related Citation (15)

Download: PDF (860 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract Gangue rib control is one of the biggest challenges for gob-side entry retaining formed by roof fracturing in thick coal seams. In this paper，the mechanism and control techniques for gangue rib deformations were systematically investigated using theoretical analysis，numerical simulation and field experimental methods. First，mechanical and numerical models were developed respectively to explore the dynamic impact behaviors of the gangue body for different mining heights. Based upon the obtained results，a multi-level control approach was proposed to address the instability problem of the gangue rib in thick coal seams. The results indicate that as the mining height increased，the impact force acted on the gangue prevention structure increased accordingly. The intense impact of the gangue body initiated the deformation of the conventional gangue prevention structure，and the roof sagging accelerated further its failure process. The severe impact area was within 6 m from the active mining panel，and an impact prevention device was designed to dissipate the impact energy. The variation of the lateral pressure was gentler within the compression area of the gangue rib. An individual support structure of sliding-type characterized by pressure release was designed and tested. Laboratory tests showed that the sliding-type structure coordinated effectively with the roof deformation，and thus improved massively its recycling utilization ratio. The anchor bolt of wave-type with multi-resistances was invented to further improve the monolithic stability of the gangue rib. Field pullout tests proved that the reinforcement effects of the structure were remarkable，especially when the structures were 60 m or far behind the active mining panel. The monitored results showed that the rib deformation decreased by appropriately 72% and the damage rate of the gangue prevention structures reduced by appropriately 85% after adopting the new approach. The proposed approach not only solved the rib control problems，but also brought about remarkable economic benefits.

Key words： mining engineering non-pillar mining thick coal seams roof fracture and pressure release gangue rib deformation surrounding rock control

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	GAO Yubing1
	2
	YANG Jun1
	2
	HE Manchao1
	WANG Yajun1
	2
	GAO Qing1
	2

Cite this article:

GAO Yubing1,2,YANG Jun1, et al. Mechanism and control techniques for gangue rib deformations in gob-side entry retaining formed by roof fracturing in thick coal seams[J]. , 2017, 36(10): 2492-2502.

URL:

http://www.rockmech.org/EN/10.13722/j.cnki.jrme.2017.0949 OR http://www.rockmech.org/EN/Y2017/V36/I10/2492

[20]	石少卿，康建功，汪敏，等. ANSYS/LS-DYNA 在爆炸与冲击领域中的工程应用[M]. 北京：中国建筑工业出版社，2011：5-8.(SHI Shaoqing，KANG Jiangong，WANG Min，et al. Engineering application of ANSYS/LS-DYNA in explosion and impact fields[M]. Beijing：China Architecture and Building Press，2011：5-8.(in Chinese)) " target="_blank">
[7]	康红普，范明建，高富强，等. 超千米深井巷道围岩变形特征与支护技术[J]. 岩石力学与工程学报，2015，34(11)：2 227-2 241. (KANG Hongpu，FAN Mingjian，GAO Fuqiang，et al. Deformation and support of rock roadway at depth more than 1 000 meters[J]. Chinese Journal of Rock Mechanics and Engineering，2015，34(11)：2 227-2 241.(in Chinese))
[12]	陈勇，柏建彪，王襄禹，等. 沿空留巷巷内支护技术研究与应用[J]. 煤炭学报，2012，37(6)：903-910.(CHEN Yong，BAI Jianbiao，WANG Xiangyu，et al. Support technology research and application inside roadway of gob-side entry retaining[J]. Journal of China Coal Society，2012，37(6)：903-910.(in Chinese))
[2]	张国锋，何满潮，俞学平，等. 白皎矿保护层沿空切顶成巷无煤柱开采技术研究[J]. 采矿与安全工程学报，2011，28(4)：511-516.(ZHANG Guofeng，HE Manchao，YU Xueping，et al. Research on the technique of no-pillar mining with gob-side entry formed by advanced roof caving in the protective seam in Baijiao coal mine[J]. Journal of Mining and Safety Engineering，2011，28(4)：511-516.(in Chinese))
[3]	孙晓明，刘鑫，梁广峰，等. 薄煤层切顶卸压沿空留巷关键参数研究[J]. 岩石力学与工程学报，2014，33(7)：1 449-1 456.(SUN Xiaoming，LIU Xin，LIANG Guangfeng，et al. Key parameters of gob-side entry retaining formed by roof cut and pressure releasing in thin coal seams[J]. Chinese Journal of Rock Mechanics and Engineering，2014，33(7)：1 449-1 456.(in Chinese))
[21]	朱彦鹏，罗晓辉，周勇. 支挡结构设计[M]. 北京：高等教育出版社，2008：1-6.(ZHU Yanpeng，LUO Xiaohui，ZHOU Yong. Retaining structure design[M]. Beijing：Higher Education Press，2008：1-6.(in Chinese)) " target="_blank">
[9]	张农，韩昌良，阚甲广，等. 沿空留巷围岩控制理论与实践[J]. 煤炭学报，2014，39(8)：1 635-1 641.(ZHANG Nong，HAN Changliang，KAN Jiaguang，et al. Theory and practice of surrounding rock control for pillarless god-side entry retaining[J]. Journal of China Coal Society，2014，39(8)：1 635-1 641.(in Chinese))
[10]	赵一鸣，张农，郑西贵，等. 千米深井厚硬顶板直覆沿空留巷围岩结构优化[J]. 采矿与安全工程学报，2015，32(5)：714-720.(ZHAO Yiming，ZHANG Nong，ZHENG Xigui，et al. Structural optimization of overlying strata for gob-side entry retaining in 1 000 m deep mine with direct thick and hard roof[J]. Journal of Mining and Safety Engineering，2015，32(5)：714-720.(in Chinese))
[13]	黄庆享，赵萌烨，张强峰，等. 含软弱夹层厚煤层巷帮外错滑移机制与支护研究[J]. 岩土力学，2016，37(8)：2 353-2 358.(HUANG Qingxiang，ZHAO Mengye，ZHANG Qiangfeng，et al. Mechanisms of outward dislocation sliding of roadway sides and its support in a thick coal seam with a soft mudstone interlayer[J]. Rock and Soil Mechanics，2016，37(8)：2 353-2 358.(in Chinese)) " target="_blank">
[14]	何满潮. 深部软岩工程的研究进展与挑战[J]. 煤炭学报，2014，39(8)：1 409-1 417.(HE Manchao. Progress and challenges of soft rock engineering in depth[J]. Journal of China Coal Society，2014，39(8)：1 409-1 417.(in Chinese))
[18]	赵旭，刘汉东. 水电站高边坡滚石防护计算研究[J]. 岩石力学与工程学报，2005，24(20)：144-150.(ZHAO Xu，LIU Handong. Research on protective structures for high slopes rockfall around a hydropower station[J]. Chinese Journal of Rock Mechanics and Engineering，2005，24(20)：144-150.(in Chinese))
[19]	Livermore Software Technology Corporation. LS-DYNA Keyword User?s Manual[R]. Livermore：Livermore Software Technology Corporation，2006：5-16. " target="_blank">
[22]	朱彦鹏，杨校辉，马孝瑞，等. 柔性加固失稳重力式挡土墙的动静力稳定性分析[J]. 工程力学，2005，32(11)：1-8.(ZHU Yanpeng，YANG Xiaohui，MA Xiaorui，et al. Statics and dynamic stability of unstability gravity retaining wall reinforced with frame-anchors[J]. Engineering Mechanics，2005，32(11)：1-8.(in Chinese))
[6]	康红普，牛多龙，张镇，等. 深部沿空留巷围岩变形特征与支护技术[J]. 岩石力学与工程学报，2010，29(10)：1 977-1 987.(KANG Hongpu，NIU Duolong，ZHANG Zhen，et al. Deformation characteristics of surrounding rock and supporting technology of gob-side entry retaining in deep coal mine[J]. Chinese Journal of Rock Mechanics and Engineering，2010，29(10)：1 977-1 987.(in Chinese)) " target="_blank">
[11]	华心祝，赵少华，朱昊，等. 沿空留巷综合支护技术研究[J]. 岩土力学，2006，27(12)：2 225-2 228.(HUA Xinzhu，ZHAO Shaohua，ZHU Hao，et al. Research on combined support technique of gob-side entry retaining[J]. Rock and Soil Mechanics，2006，27(12)：2 225-2 228.(in Chinese))
[1]	何满潮，高玉兵，杨军，等. 无煤柱自成巷聚能切缝技术及其对围岩应力演化的影响研究[J]. 岩石力学与工程学报，2017，36(6)：1 314-1 325.(HE Manchao，GAO Yubing，YANG Jun，et al. The energy-gathered roof cutting technique in non-pillar mining and its impact on stress evolution of surrounding rocks[J]. Chinese Journal of Rock Mechanics and Engineering，2017，36(6)：1 314-1 325.(in Chinese))
[5]	郭志飚，王将，曹天培，等. 薄煤层切顶卸压自动成巷关键参数研究[J]. 中国矿业大学学报，2016，45(5)：879-885.(GUO Zhibiao，WANG Jiang，CAO Tianpei，et al. Research on key parameters of gob-side entry retaining automatically formed by roof cutting and pressure release in thin coal seam mining[J]. Journal of China University of Mining and Technology，2016，45(5)：879-885.(in Chinese))
[16]	何满潮，张国锋，王桂莲，等. 深部煤巷底臌控制机制及应用研究[J]. 岩石力学与工程学报，2009，28(增1)：2 593-2 598.(HE Manchao，ZHANG Guofeng，WANG Guilian，et al. Research on mechanism and application to floor heave control of deep gateway[J]. Chinese Journal of Rock Mechanics and Engineering，2009，28(Supp.1)：2 593-2 598.(in Chinese))
[4]	宋立兵. 神东矿区切顶卸压成巷技术研究[J]. 煤炭科学技术，2016，44(8)：80-85.(SONG Libing. Study on roof cutting，pressure released and gateway driving technology in Shendong mining area[J]. Coal Science and Technology，2016，44(8)：80-85.(in Chinese))
[15]	何满潮，袁越，王晓雷，等. 新疆中生代复合型软岩大变形控制技术及其应用[J]. 岩石力学与工程学报，2013，32(3)：433-441.(HE Manchao，YUAN Yue，WANG Xiaolei，et al. Control technology for large deformation of mesozoic compound soft rock in Xinjiang and its application[J]. Chinese Journal of Rock Mechanics and Engineering，2013，32(3)：433-441.(in Chinese))
[8]	单仁亮，孔祥松，蔚振廷，等. 煤巷强帮支护理论与应用[J]. 岩石力学与工程学报，2013，32(7)：1 304-1 314.(SHAN Renliang，KONG Xiangsong，WEI Zhenting，et al. Theory and application of strong support for coal roadway sidewall[J]. Chinese Journal of Rock Mechanics and Engineering，2013，32(7)：1 304-1 314.(in Chinese))
[17]	孙晓明，何满潮，杨晓杰. 深部软岩巷道锚网索耦合支护非线性设计方法研究[J]. 岩土力学，2006，27(7)：1 061-1 065.(SUN Xiaoming，HE Manchao，YANG Xiaojie. Research on nonlinear mechanics design method of bolt-net-anchor coupling support for deep soft rock tunnel[J]. Rock and Soil Mechanics，2006，27(7)：1 061-1 065.(in Chinese))