层状岩体各向异性声学和力学参数计算方法研究

doi:10.13722/j.cnki.jrme.2019.1174

Abstract
Figure/Table
References (0)
Related Citation (15)

Download: PDF (882 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract The distribution of the bedding weak plane directly affects the acoustic and mechanical characteristics of bedding rock mass, and also directly affects the rationality of the value of the rock mass mechanical parameters. Sandstone samples with 7 bedding dip angles，such as 0°，15°，30°，45°，60°，75° and 90°，were prepared for longitudinal wave velocity test and uniaxial compression test. The results show that：(1) With the increase of bedding dip angle，the longitudinal wave velocity and elastic modulus of bedding sandstone gradually increase，and the peak compressive strength shows a U-shaped trend of first decreasing and then increasing，and the anisotropic characteristics are obvious. The elliptic curves of longitudinal wave velocity，elastic modulus and cosine value of bedding dip angle of bedding sandstone are established respectively. Only by testing the longitudinal wave velocity and elastic modulus of bedding rock mass in two directions of parallel bedding and vertical bedding，the longitudinal wave velocity and elastic modulus of rock samples with arbitrary dip angle can be determined，which provides a practical and convenient method for determining the acoustic parameters and elastic parameters of bedding rock mass in different directions；(2) The main direction of stress of the bedding rock mass determines its bearing capacity and deformation and failure characteristics. When determining the relevant basic parameters of engineering rock mass quality evaluation，we should pay attention to the influence of bedding angle, and the testing direction should be consistent with the main stress direction，or the acoustic parameters and mechanical parameters of parallel bedding and vertical bedding should be tested respectively，and then converted to the corresponding bedding dip angle according to the established empirical formula for analysis，so as to obtain more accurate rock mass quality evaluation indexes. Relevant research results can provide a good reference for testing and analyzing anisotropic acoustic and mechanical properties of bedding rock mass.

Key words： rock mechanics bedding sandstone anisotropy longitudinal wave velocity elliptical curve rock mass quality evaluation calculation method

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	DENG Huafeng1
	LI Tao1
	LI Jianlin1
	XIONG Yu1
	QI Yu1
	WAN Liangpeng2

Cite this article:

DENG Huafeng1,LI Tao1,LI Jianlin1, et al. Study on calculation method of anisotropic acoustic and mechanical parameters of layered rock[J]. , 2020, 39(S1): 2725-2732.

URL:

http://rockmech.whrsm.ac.cn/EN/10.13722/j.cnki.jrme.2019.1174 OR http://rockmech.whrsm.ac.cn/EN/Y2020/V39/IS1/2725

[26]	席道瑛，陈林. 岩石各向异性参数研究[J]. 物探化探计算技术，1994，16(1)：16–21.(XI Daoying，CHEN Lin. On anisotropism of rock in geophysics[J]. Computing Techniques for Geophysical and Geochemical Exploration，1994，16(1)：16–21.(in Chinese))
[3]	孙广忠. 岩体结构力学[M]. 北京：科学出版社，1988：204–221. (SUN Guangzhong. The rock mass structure mechanics[M]. Beijing：Science Press，1988：204–221.(in Chinese))
[23]	JAEGER J C. Shear failure of anisotropic rocks[J]. Geological Magazine，1960，97(1)：65–72.
[1]	LEKHNITSKII S G. Theory of Elastcity of an anisotropic elastic body[M]. San Franicesco：Holdenn-Daty Inc.，1963：58–73.
[4]	鲜学福，谭学术. 层状岩体破坏机理[M]. 重庆：重庆大学出版社，1989：40–43.(XIAN Xuefu，TAN Xueshu. The failure mechanism of layered rock mass[M]. Chongqing：Chongqing University Press，1989：40–43.(in Chinese))
[6]	SAYERS C. Inversion of ultrasonic wave velocity measurements to obtain the microcrack orientation distribution function in rocks[J]. Ultrasonics，1988，26(2)：73–77.
[8]	SAYERS C M. Stress-dependent elastic wave velocities in shales[J]. International Journal of Rock Mechanics and Mining Sciences and Geomechanics Abstracts，2015，32(3)：263–267.
[11]	衡帅，杨春和，张保平，等. 页岩各向异性特征的试验研究[J]. 岩土力学，2015，36(3)：609–616.(HENG Shuai，YANG Chunhe，ZHANG Baoping，et al. Experimental research on anisotropic properties of shale[J]. Rock and Soil Mechanics，2015，36(3)：609–616.(in Chinese))
[14]	张萍，杨春和，汪虎，等. 页岩单轴压缩应力–应变特征及能量各向异性[J]. 岩土力学，2018，39(6)：2 106–2 114.(ZHANG Ping，YANG Chunhe，WANG Hu，et al. Stress-strain characteristics and anisotropy energy of shale under uniaxial compression[J]. Rock and Soil Mechanics，2018，39(6)：2 106–2 114.(in Chinese))
[16]	叶海旺，蔡俊，雷涛，等. 板岩渐进剪切破坏各向异性及其数值模型研究[J]. 地下空间与工程学报，2018，14(4)：945–954.(YE Haiwang，CAI Jun，LEI Tao，et al. Anisotropic progressive shear failure of slate and its numerical model[J]. Chinese Journal of Underground Space and Engineering，2018，14(4)：945–954.(in Chinese))
[28]	SINGH J，RAMAMURTHY T，RAO G V. Strength anisotropies in rocks[J]. Indian Geotechnical Journal，1989，19(2)：147–166.
[9]	HU S C，TAN Y L，ZHOU H，et al. Impact of Bedding Planes on Mechanical Properties of Sandstone[J]. Rock Mechanics and Rock Engineering，2017，50(8)：2 243–2 251.
[13]	陈一，赫建明，林冲，等. 不同应变率单轴加载条件下页岩的各向异性力学行为[J]. 工程地质学报，2018，26(2)：510–519.(CHEN YI，HAO Jianming，LIN Chong，et al. Anisotropic mechanical behavior of shale under different strain rates under uniaxial loading[J]. Journal of Engineering Geology，2018，26(2)：510–519.(in Chinese))
[19]	CHO J W，KIM H，JEON S，et al. Deformation and strength anisotropy of Asan gneiss，Boryeong shale and Yeoncheon schist[J]. International Journal of Rock Mechanics and Mining Sciences，2012，50(2)：158–169.
[21]	张春生，刘宁，褚卫江，等. 石英云母片岩各向异性特征多尺度精细化描述[J]. 岩石力学与工程学报，2018，37(3)：573–582.(ZHANG Chunsheng，LIU Ning，CHU Weijiang，et al. Anisotropic characteristics analysis of deformation of layered rock mass[J]. Chinese Journal of Rock Mechanics and Engineering，2018，37(3)：573–582.(in Chinese))
[24]	DONATH F A. Experimental study of shear failure in anisotropic rocks[J]. Geological Society of America Bulletin，1961，72(6)：985–989.
[29]	中华人民共和国国家标准编写组. GB/T 50218—2014 工程岩体分级标准[S]. 北京：中国计划出版社，2015.(The National Standards Compilation Group of People?s Republic of China. GB/T 50218—2014 Standard for engineering classification of rock mass[S]. Beijing：China Planning Press，2015.(in Chinese))
[2]	RABINOVICH N R. The state of stress around an arbitrarily oriented mine working driven in an anisotropic rock mass[J]. Soviet Mining Science，1976，11(6)：622–626.
[5]	THILL R E，BUR T R，STECKLEY R C. Velocity anisotropy in dry and saturated rock spheres and its relation to rock fabric[J]. International Journal of Rock Mechanics and Mining Sciences and Geomechanics Abstracts，1973，10(6)：535–557.
[7]	ODA M，YAMABE T，KAMEMURA K. A crack tensor and its relation to wave velocity anisotropy in jointed rock masses[J]. International Journal of Rock Mechanics and Mining Sciences and Geomechanics Abstracts，1986，23(6)：387–397.
[10]	TAVALLALI A，VERVOORT A. Effect of layer orientation on the failure of layered sandstone under Brazilian test conditions[J]. International Journal of Rock Mechanics and Mining Sciences，2010，47(2)：313–322.
[12]	张永泽，刘俊新，冒海军，等. 单轴压缩下页岩力学特性的各向异性试验研究[J]. 金属矿山，2015，(12)：33–37.(ZHANG Yongze，LIU Junxin，MAO Haijun，et al. Anisotropic experimental study on mechanical properties of shale under uniaxial compression[J]. Metal Mine，2015，(12)：33–37.(in Chinese))
[15]	李志刚，徐光黎，黄鹏，等. 粉砂质板岩力学特性及各向异性特性[J]. 岩土力学，2018，39(5)：1 737–1 746.(LI Zhigang，XU Guangli，HUANG Peng，et al. Mechanical and anisotropic properties of silty slates[J]. Rock and Soil Mechanics，2018，39(5)：1 737–1 746.(in Chinese))
[17]	王聪聪，李江腾，林杭，等. 板岩单轴压缩各向异性力学特征[J]. 中南大学学报：自然科学版，2016，47(11)：3 759–3 764.(WANG Congcong，LI Jiangteng，LIN Hang，et al. Anisotropic mechanical characteristics of slate in uniaxial compression[J]. Journal of Central South University：Science and Technology，2016，47(11)：3 759–3 764.(in Chinese))
[20]	李深圳，沙鹏，伍法权，等. 层状结构岩体变形的各向异性特征分析[J]. 岩土力学，2018，39(增2)：366–373.(LI Shenzhen，SHA Peng，WU Faquan，et al. Anisotropic characteristics analysis of deformation of layered rock mass[J]. Rock and Soil Mechanics，2018， 39(Supp.2)：366–373.(in Chinese))
[22]	CHEN C S，PANE E，AMADEI B. Determination of deformability and tensile strength of anisotropic rock using Brazilian tests[J]. International Journal of Rock Mechanics and Mining Sciences，1998，35(1)：43–61.
[25]	MCLAMORE R，GRAY K E. The mechanical behavior of anisotropic sedimentary rocks[J]. Journal of Engineering for Industry，1967，89(1)：62–73.
[27]	中华人民共和国国家标准编写组. GB/T 50266－2013工程岩体试验方法标准[S]. 北京：中国计划出版社，2013.(The National Standards Compilation Group of People?s Republic of China. GB/T 50266－2013 Standard for tests method of engineering rock masses[S]. Beijing：China Planning Press，2013.(in Chinese))
[18]	黄旻鹏，李江腾，张建，等. 板岩各向异性蠕变特性试验研究[J]. 中南大学学报：自然科学版，2017，48(8)：2 210–2 216.(HUANG Yupeng，LI Jiangteng，ZHANG Jian，et al. Experimental study on creep characteristics of anisotropic slate[J]. Journal of Central University：Scienceand Technology，2017，48(8)：2 210–2 216.(in Chinese))