辉绿岩裂隙注浆体力学特性试验研究

doi:10.13722/j.cnki.jrme.2019.0754

Abstract
Figure/Table
References (0)
Related Citation (15)

Download: PDF (2281 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract In order to analyze the influence of fracture geometry on the weakening of mechanical properties of rock mass after grouting，different crack inclination angle，crack penetration degree and number of cracks were prefabricated by cutting diabase. A simple grouting mold for fractured rock samples was designed and applied for indoor grouting test. The uniaxial and conventional triaxial compression tests of the diabase and its fracture-grouting mass and the indoor grouting test of the fractured rock samples were carried out. The stress-strain relationship and mechanical properties of diabase fracture-grouting mass under different fracture geometries were analyzed comprehensively. The main conclusions are：(1) Filling the cement slurry in the fracture and confining pressure significantly change the stress-strain relationship of the rock sample，from the typical brittleness of the original rock to the elastic-within a certain range plastic-brittle or ideal elastoplasticity. In addition to the occurrence of slippage along the fracture surface，the ductility of the post-peak zone is significantly improved；(2) The fracture significantly reduces the mechanical properties of the rock sample and the fracture-grouting mass exhibits obvious anisotropy. The mechanical properties are the worst at low confining pressure，full penetration，and 60°crack inclination angle in the most unfavorable state. Providing theoretical reference for selecting line orientation and strength parameters in rock mass tunnel engineering；(3) The rock sample failure under full penetration conditions is dominated by large shear-slip deformation along the fracture surface，and is supplemented by longitudinal-oblique tension-shear cracks；the rock sample failure under semi-through conditions firstly originates from the crack tip cracking，and then the crack tracks the direction of the maximum principal stress，which causes the penetration，or crack tracking shear surface to reach its shear strength and shear failure. It provides guidance for the design and construction of the corresponding fractured rock mass (rock) mechanical engineering，which has certain theoretical value and practical engineering significance.

Key words： rock mechanics fractured rock mass grouting consolidation triaxial compression test stress-strain relationship mechanical properties

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	SHEN Jun1
	LIU Baoguo2
	CHEN Jing1
	LI Yafei1
	CHENG Yin1
	SONG Yu2

Cite this article:

SHEN Jun1,LIU Baoguo2,CHEN Jing1, et al. Experimental study on mechanical properties of diabase fracture-grouting mass[J]. , 2020, 39(S1): 2804-2817.

URL:

http://rockmech.whrsm.ac.cn/EN/10.13722/j.cnki.jrme.2019.0754 OR http://rockmech.whrsm.ac.cn/EN/Y2020/V39/IS1/2804

[2]	佘诗刚，林鹏. 中国岩石工程若干进展与挑战[J]. 岩石力学与工程学报，2014，33(3)：433–457.(SHE Shigang，LIN Peng. Some developments and challenging issues in rock engineering field in china [J]. Chinese Journal of Rock Mechanics and Engineering，2014，33(3)：433–457.(in Chinese))
[5]	SINGH M，SINGH B. High lateral strain ratio in jointed rock masses[J]. Engineering Geology，2007，98(3)：75–85.
[4]	RAMAMURTHY T，ARON V K. Strength predictions for jointed rocks in confined and unconfined states[J]. International Journal of Rock Mechanics and Mining Sciences and Geomechanics Abstracts，1994，31(1)：9–22.
[15]	孙广忠. 岩体结构力学[M]. 北京：科学出版社，1988：182–212.(SUN Guangzhong. Rock mass structure mechanics[M]. Beijing：Science Press，1988：182–212.(in Chinese))
[6]	刘泉声，雷广峰，卢超波，等. 注浆加固对岩体裂隙力学性质影响的试验研究[J]. 岩石力学与工程学报，2017，36(增1)：3 140–3 147. (LIU Quansheng，LEI Guangfeng，LU Chaobo，et al. Experimental study of grouting reinforcement influence on mechanical properties of rock fracture[J]. Chinese Journal of Rock Mechanics and Engineering，2017，36(Supp.1)：3 140–3 147.(in Chinese))
[8]	张科，刘享华，杨红宣，等. 含孔洞裂隙岩体灌浆后力学特性的物理试验与数值模拟[J]. 水文地质工程地质，2019，46(1)：83–89.(ZHANG Ke，LIU Xianghua，YANG Hongxuan，et al. Experimental and numerical simulation of the mechanical characteristics of rocks containing hole and flaw after grouting[J]. Hydrogeology and Engineering Geology，2019，46(1)：83–89.(in Chinese))
[10]	王艳磊，唐建新，代张音，等. 裂隙数量和开度对低强度岩体力学特性及破坏模式的影响[J]. 煤炭学报，2018，43(12)：3 338–3 347.(WANG Yanlei，TANG Jianxin，DAI Zhangyin，et al. Effect of fracture number and aperture on mechanical properties and failure modes of low-strength rock mass[J]. Journal of China Coal Society，2018，43(12)：3 338–3 347.(in Chinese))
[11]	黄彦华，杨圣奇，鞠杨，等. 断续裂隙类岩石材料三轴压缩力学特性试验研究[J]. 岩土工程学报，2016，38(7)：1 212–1 220. (HUANG Yanhua，YANG Shengqi，JU Yang，et al. Experimental study on mechanical behavior of rock-like materials containing pre-existing intermittent fissures under triaxial compression[J]. Chinese Journal of Geotechnical Engineering，2016，38(7)：1 212–1 220.(in Chinese))
[12]	肖桃李，李新平，贾善坡. 含2条断续贯通预制裂隙岩样破坏特性的三轴压缩试验研究[J]. 岩石力学与工程学报，2015，34(12)：2 455–2 462.(XIAO Taoli，LI Xinping，JIA Shanpo. Failure characteristics of rock with two pre-existing transfixion cracks under triaxial compression [J]. Chinese Journal of Rock Mechanics and Engineering ，2015，34(12)：2 455–2 462.(in Chinese))
[14]	张志刚. 节理岩体强度确定方法及其各向异性特征研究[博士学位论文] [D]. 北京：北京交通大学，2007.(ZHANG Zhigang. Research on determination methods and anisotropic characters of strength of jointed rock mass[Ph. D. Thesis] [D]. Beijing：Beijing Jiaotong University，2007.(in Chinese))
[1]	蔡美峰. 岩石力学与工程[M]. 北京：科学出版社，2014：74–107.(CAI Meifeng. Rock mechanics and engineering[M]. Beijing：Science Press，2014：74–107.(in Chinese))
[3]	JAEGER J C，COOK N J W. Fundamentals of rock mechanics [M]. 3rd. London：Chapman and Hall，1979：251–252.
[9]	周喻，孙铮，王莉，等. 单侧限压缩下预制裂隙试样力学特性及板裂化机制细观研究[J]. 岩土力学，2018，39(12)：4 385–4 394. (ZHOU Yu，SUN Zheng，WANG Li，et al. Meso research on mechanical properties and slab failure mechanism of pre-fractured rock mass under the condition of one side restriction loading[J]. Rock and Soil Mechanics，2018，39(12)：4 385–4 394.(in Chinese))
[13]	YANG S Q，JIANG Y Z，XU W Y，et al. Experimental investigation on strength and failure behavior of pre-cracked marble under conventional triaxial compression[J]. International Journal of Solids and Structures，2008，45(17)：4 796–4 819.
[7]	唐建新，孔令锐，王艳磊，等. 裂隙倾角和长度对低强度岩体力学特性及破坏模式影响的试验研究[J]. 工业建筑，2019，49(2)：85–92.(TANG Jianxin，KONG Lingrui，WANG Yanlei，et al. Experiment on effects of fissure dip angle and length on mechanical properties and failure modes of low-strength rock mass[J]. Industrial Construction，2019，49(2)：85–92.(in Chinese))