桩端型式对嵌岩随钻跟管桩承载性能的影响

doi:10.13722/j.cnki.jrme.2021.0625

Abstract
Figure/Table
References (0)
Related Citation (15)

Download: PDF (2796 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract The drilling with pre-stressed concrete pile cased(DPC) pile is a new type of pre-drilled large-diameter PHC pipe pile，and its pile toe can be embedded in the moderately weathered rock. In order to reveal the influence of pile toe type on the bearing capacity of rock-socketed DPC piles，an ABAQUS finite element numerical analysis model was established by combining concrete damage plasticity model，interface bonding model and Mohr Coulomb model of equivalent Hoek Brown criterion. The influence factors such as hole bottom shape，pile shoe size and plugging concrete at the pile toe were emphatically analyzed. Numerical results show that，under the condition of no plugging concrete at the pile toe，the toe resistance ratio can reach more than 50% for the cylindrical cone groove at the bottom of the pile hole，and the influence of groove depth(15–30 cm) is limited. However，for the trapezoidal cone groove at the bottom，the end bearing capacity is obviously weakened，which is only 61% of that of cylindrical cone groove. The open-ended steel pile shoe can lead to the progressive destruction of the bedrock; the toe resistance ratio increases from 54% to 60%–76% when the thickness of pile shoe increases from 24 mm to 40–130 mm. Considering that increasing the thickness of pile shoe will affect soil discharge，the reasonable thickness of pile shoe should be determined by field tests. For the rock-socketed DPC pile with pile shoe，plugging concrete at the pile toe is an effective measure to improve the bearing capacity. However，the end bearing capacity will be weaken when there is sediment in the lower part of the plugging concrete. Finally，the improvement measures for the construction technology of DPC pile were put forward.

Key words： pile foundation rock-socketed pile DPC pile bearing performance numerical analysis pile toe type

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	TANG Mengxiong1
	LING Zao1
	2
	3
	LIU Chunlin3
	4
	HU Hesong3
	4

Cite this article:

TANG Mengxiong1,LING Zao1,2, et al. Influence of pile toe type on bearing capacity of rock-socketed DPC piles[J]. , 2022, 41(S1): 3053-3062.

URL:

http://rockmech.whrsm.ac.cn/EN/10.13722/j.cnki.jrme.2021.0625 OR http://rockmech.whrsm.ac.cn/EN/Y2022/V41/IS1/3053

[4]	唐孟雄，胡贺松，刘春林，等. 砂土中不同管桩桩型承载性能的对比试验研究[J]. 岩土力学，2020，41(增2)：1-9.(TANG Mengxiong， HU Hesong，LIU Chunlin，et al. Experimental study on the bearing capacity of different pipe piles in sandy soils[J]. Rock and Soil Mechanics，2020，41(Supp. 2)：1-9.(in Chinese))
[6]	侯振坤，唐孟雄，胡贺松，等. 随钻跟管桩竖向承载性能原位试验与室内物理模拟试验对比研究[J]. 岩土力学，2021，42(2)：419-429.(HOU Zhenkun，TANG Mengxiong，HU Hesong，et al. Comparative research on the vertical load-bearing properties of the drilling with pre-stressed concrete pile cased pile based on in-situ tests and physical simulation tests[J]. Rock and Soil Mechanics，2021，42(2)：419-429.(in Chinese))
[16]	中华人民共和国行业标准编写组. JGJ106—2014 建筑基桩检测技术规范[S]. 北京：中国建筑工业出版社，2014.(The Professional Standards Compilation Group of People?s Republic of China. JGJ106—2014 Technical Code for Testing of Building Foundation Piles[S]. Beijing：China Architecture and Building Press，2014.(in Chinese))
[10]	XING H F，ZHANG Z，MENG M H，et al. Centrifuge tests of superlarge-diameter rock-socketed piles and their bearing characteristics[J]. Journal of Bridge Engineering，2014，19(6)：04014010.
[14]	SERRANO A，OLALLA C，GALINDO R A. Ultimate bearing capacity at the tip of a pile in rock based on the modified Hoek-Brown criterion[J]. International Journal of Rock Mechanics and Mining Sciences，2014，71：83-90.
[18]	RANDOLPH M F，WROTH C P. Application of the failure state in undrained simple shear to the shaft capacity of driven piles[J]. Geotechnique，1981，31(1)：143-157.
[20]	HOEK E，BROWN E T. The Hoek-Brown failure criterion and GSI-2018 edition[J]. Journal of Rock Mechanics and Geotechnical Engineering，2019，11(3)：445-463.
[17]	Dassault Systèmes. Abaqus analysis user's guide[M]. Version 6.14. [S. l.]：[s. n.]，2014.
[1]	唐孟雄. 大直径随钻跟管桩的研制及工程化[J]. 广州建筑，2009，37(5)：3-7.(TANG Mengxiong. The development and engineering of drilling with PHC pipe cased pile[J]. Guangzhou Architecture，2009，37(5)：3-7.(in Chinese))
[3]	TANG M X，HU H S，CUI J，et al. The vertical bearing mechanism of hybrid bored pre-stressed concrete cased piles[J]. International Journal of Civil Engineering，2020，18：293-302.
[5]	刘春林，唐孟雄，胡贺松，等. 考虑桩底沉渣的随钻跟管桩竖向承载特性模型试验研究[J]. 岩土力学，2021，42(1)：177-185.(LIU Chunlin，TANG Mengxiong，HU Hesong，et al. An experimental study of vertical bearing capacity of DPC piles considering sediment effect at pile bottom[J]. Rock and Soil Mechanics，2021，42(1)：177-185.(in Chinese))
[9]	赵明华，夏润炎，尹平保，等. 考虑软岩剪胀效应的嵌岩桩荷载传递机制分析[J]. 岩土工程学报，2014，36(6)：1 005-1 011.(ZHAO Minghua，XIA Runyan，YIN Pingbao，et al. Load transfer mechanism of socketed piles considering shear dilation effects of soft rock[J]. Chinese Journal of Geotechnical Engineering，2014，36(6)：1 005-1 011.(in Chinese))
[19]	中华人民共和国国家标准编写组. GB50010—2010 混凝土结构设计规范[S]. 北京：中国建筑工业出版社，2015.(The National Standards Compilation Group of People?s Republic of China. GB50010—2010 Code for design of concrete structures[S]. Beijing：China Architecture and Building Press，2015.(in Chinese))
[7]	中华人民共和国行业标准编写组. JGJ/T 344—2014随钻跟管桩技术规程[S]. 北京：中国建筑工业出版社，2014.(The Professional Standards Compilation Group of People?s Republic of China. JGJ/T 344—2014 Technical specification for drilling with prestressed high strength concrete pipe cased pile[S]. Beijing：China Architecture and Building Press，2014.(in Chinese))
[8]	赵明华，雷勇，刘晓明. 基于桩-岩结构面特性的嵌岩桩荷载传递分析[J]. 岩石力学与工程学报，2009，28(1)：103-110.(ZHAO Minghua，LEI Yong，LIU Xiaoming. Analysis of load transfer of rock-socketed piles based on characteristics of pile-rock structural plane[J]. Chinese Journal of Rock Mechanics and Engineering，2009. 28(1)：103-110.(in Chinese))
[11]	王卫东，吴江斌，聂书博. 武汉中心大厦超长软岩嵌岩桩承载特性试验研究[J]. 建筑结构学报，2016，37(6)：196-203.(WANG Weidong，WU Jiangbin，NIE Shubo. Field loading tests on large-diameter super-long rock-socketed bored piles of the Wuhan Center Tower[J]. Journal of Building Structures，2016，37(6)：196- 203.(in Chinese))
[15]	JAFARI M，GHARSALLAOUI H，VICTOR K H，et al. End bearing response of open-ended pipe piles embedded in rock[J]. International Journal of Rock Mechanics and Mining Sciences，2019，119：46-57.
[21]	HOEK E，CARRANZA-TORRES C，CORKUM B. Hoek-Brown failure criterion-2002 edition[C]// HAMMAH R，BAWDEN W，CURRAN J，et al ed. Proceedings of the 5th North American Rock Mechanics Symposium and 17th Tunnelling Association of Canada Conference. Toronto：University of Toronto，2002：267-273.
[13]	XU J，DAI G L，GONG W M，et al. A review of research on the shaft resistance of rock-socketed piles[J]. Acta Geotechnica，2021，16： 653-677.
[2]	胡贺松，陈晓斌，唐孟雄，等. 随钻跟管桩桩-土接触面作用机制大型直剪试验研究[J]. 岩土力学，2018，39(12)：4 325-4 334.(HU Hesong，CHEN Xiaobin，TANG Mengxiong，et al. Investigation on shearing failure mechanism for DPC pile-soil interface in large-scale direct shear tests[J]. Rock and Soil Mechanics，2018，39(12)：4 325- 4 334.(in Chinese))
[12]	ZHANG Q Q，MA B，LIU S W，et al. Behaviour analysis on the vertically loaded bored pile socketed into weak rocks using slip-line theory arc failure surface[J]. Computers and Geotechnics，2020，128：103852.
[22]	HOEK E，DIEDERICHS M S. Empirical estimation of rock mass modulus[J]. International Journal of Rock Mechanics and Mining Sciences，2006，43(2)：203-215.