爆炸载荷作用下不同长度裂纹的动态扩展规律研究

doi:10.13722/j.cnki.jrme.2021.1010

Abstract
Figure/Table
References (0)
Related Citation (15)

Download: PDF (4222 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract In order to study the dynamic propagation law of cracks with different lengths in sandstone materials under blasting loads，the crack initiation law and crack propagation speed of sandstone are studied with the help of crack propagation gauge. The dynamic parameters of sandstone and crack propagation time measured in the test are imported into ABAQUS code，a finite element software，to establish a numerical calculation model. The crack propagation speed and dynamic stress intensity factor of mode I cracks and fracture toughness of sandstone with different crack lengths are obtained by experiment-numerical method. The test results show that：(1) In the blasting tests，the initiation time and delayed fracture time of pre-cracks with different lengths are different. When the lengths of pre-cracks vary between 60 and 80 mm，the change of initiation time and delayed fracture time is not obvious，and it basically increases linearly when the lengths vary between 80 and 120 mm，and then the change tends to be flat；(2) The dynamic propagation speed of crack in sandstone is not a not a constant value and fluctuates during crack propagation，when the lengths of pre-cracks vary between 60 and 140 mm，the pre-crack length has little effect on the average propagation speed of dynamic crack，and the variation range is within 10%；(3) With the increase of pre-crack length，the initiation toughness of sandstone increases gradually，that is，the difficulty of sandstone initiation increases，and its propagation toughness is inversely proportional to the propagation speed，which is still valid when the crack length changes.

Key words： rock mechanics blasting loads sandstone crack length propagation speed fracture toughness

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	LIU Ruifeng1
	ZHU Zheming2
	DU Yumei1
	LI Meng3
	LIU Bang4
	WAN Duanying2

Cite this article:

LIU Ruifeng1,ZHU Zheming2,DU Yumei1, et al. Study on dynamic propagation law of cracks with different lengths under blasting[J]. , 2022, 41(S2): 3114-3123.

URL:

http://rockmech.whrsm.ac.cn/EN/10.13722/j.cnki.jrme.2021.1010 OR http://rockmech.whrsm.ac.cn/EN/Y2022/V41/IS2/3114

[16]	YING P，ZHU Z M，WANG F，et al. The characteristics of dynamic fracture toughness and energy release rate of rock under impact[J]. Measurement，2019，147：1–11.
[34]	RAVI-CHANDAR K. Dynamic Fracture[M]. [S.l.]：Elsevier，2004：49–69.
[1]	朱哲明，李元鑫，周志荣，等. 爆炸荷载下缺陷岩体的动态响应[J]. 岩石力学与工程学报，2011，30(6)：1 157–1 167.(ZHU Zheming，LI Yuanxin，ZHOU Zhirong，et al. Dynamic response of defected rock under blasting load[J]. Chinese Journal of Rock Mechanics and Engineering，2011，30(6)：1 157–1 167.(in Chinese))
[33]	FREUND L B. Dynamic fracture mechanics[M]. Edinburgh：Cambridge University Press，1990：231–235.
[2]	刘瑞峰，朱哲明，刘邦，等. 爆炸载荷下砂岩动态断裂特性的试验研究[J]. 岩石力学与工程学报，2019，38(3)：445–454.(LIU Ruifeng，ZHU Zheming，LIU Bang，et al. Experimental study on dynamic fracture characteristics of sandstones under blasting[J]. Chinese Journal of Rock Mechanics and Engineering，2019，38(3)：445–454.(in Chinese))
[7]	OKODI A，LI Y，CHENG R，et al. Crack propagation and burst pressure of pipeline with restrained and unrestrained concentric dent-crack defects using extended finite element method[J]. Applied Sciences，2020，10(21)：2–18.
[9]	YI Y N，LIU G Y，LIN G，et al. Evaluating the dynamic fracture toughness of graphite via accurate determination of the dynamic crack propagation length[J]. Journal of Nuclear Materials，2021，543：1–9.
[13]	ZHU Z M，XIE H P，MOHANTY B. Numerical investigation of blasting-induced damage in cylindrical rocks[J]. International Journal of Rock Mechanics and Mining Sciences，2008，45(2)：111–121.
[18]	DING C X，YANG R S，YANG L Y. Experimental results of blast-induced cracking fractal characteristics and propagation behavior in deep rock mass[J]. International Journal of Rock Mechanics and Mining Sciences，2021，142：1–8.
[20]	WAN D Y，ZHU Z M，LIU R F，et al. Measuring method of dynamic fracture toughness of mode I crack under blasting using a rectangle specimen with a crack and edge notches[J]. International Journal of Rock Mechanics and Mining Sciences，2019，123：1–12.
[24]	ZHU Z M，XU W T，FENG R Q. A new method for measuring mode I dynamic fracture toughness of rock under blasting loads[J]. Experimental Techniques，2015，40(3)：899–905.
[4]	FAN X Q，HU S W. Influence of crack initiation length on fracture behaviors of reinforced concrete[J]. Applied Clay Science，2013，79(1)：25–29.
[6]	DATTA D，NADIMPALLI S P V，LI Y F，et al. Effect of crack length and orientation on the mixed-mode fracture behavior of graphene[J]. Extreme Mechanics Letters，2015，5(12)：10–17.
[8]	MURTHY A R，MUTHU K M，SARAVANAN M，et al. Effect of dissimilar metal SENB specimen width and crack length on stress intensity factor[J]. Nuclear Engineering and Technology，2020，52：1 579–1 586.
[11]	张盛，王启智，梁亚磊. 裂缝长度对岩石动态断裂韧度测试值影响的研究[J]. 岩石力学与工程学报，2009，28(8)：1 691–1 696. (ZHANG Sheng，WANG Qizhi，LIANG Yalei. Research on the influence of crack length on test values of rock dynamic fracture toughness[J]. Chinese Journal of Rock Mechanics and Engineering，2009，28(8)：1 691–1 696.(in Chinese))
[12]	ZHU Z M，MOHANTY B，XIE H P. Numerical investigation of blasting-induced crack initiation and propagation in rocks[J]. International Journal of Rock Mechanics and Mining Sciences，2007，44(3)：412–424.
[15]	LIU L Q，KATSABANIS P D. Development of a continuum damage model for blasting analysis[J]. International Journal of Rock Mechanics and Mining Sciences，1997，34(2)：217–231.
[17]	杨仁树，左进京，岳中文，等. 爆炸荷载作用下相向裂纹扩展行为的实验研究[J]. 煤炭学报，2017，42(5)：1 093–1 098.(YANG Renshu，ZUO Jinjing，YUE Zhongwen，et al. Experimental study on opposite cracks propagation behavior under blast loading [J]. Journal of China Coal Society，2017，42(5)：1 093–1 098.(in Chinese))
[19]	YANG R S，DING C X，LI Y L，et al. Crack propagation behavior in slit charge blasting under high static stress conditions[J]. International Journal of Rock Mechanics and Mining Sciences，2019，119：117–123.
[22]	QIU H，ZHU Z M，WANG F，et al. Dynamic behavior of a running crack crossing mortar-rock interface under impacting load[J]. Engineering Fracture Mechanics，2020，240(8)：177–202.
[23]	李盟，朱哲明，肖定军，等. 煤矿岩巷爆破掘进过程中周边眼对裂纹扩展止裂机理[J]. 煤炭学报，2017，42(7)：1 691–1 699.(LI Meng，ZHU Zheming，XIAO Dingjun，et al. Mechanism of crack arrest by peripheral holes during mine rock roadway excavation under blasting[J]. Journal of China Coal Society，2017，42(7)：1 691–1 699.(in Chinese))
[26]	夏开文，徐颖，姚伟，等. 静态预应力条件作用下岩板动态破坏行为试验研究[J]. 岩石力学与工程学报，2017，36(5)：1 122–1 132. (XIA Kaiwen，XU Ying，YAO Wei，et al. Experimental study of dynamic fracture behavior of brittle rock plate under static pre- loading[J]. Chinese Journal of Rock Mechanics and Engineering，2017，36(5)：1 122–1 132.(in Chinese))
[28]	LIU R F，ZHU Z M，LI Y X，et al. Study of rock dynamic fracture toughness and crack propagation parameters of four brittle materials under blasting[J]. Engineering Fracture Mechanics，2020，225：1–18.
[3]	JIA P，LI L，DONG J F，et al. Determination of the crack initiation stress，elastic modulus and ultimate crack length in TPBT concrete beams based on shear deformation theory[J]. Engineering Fracture Mechanics，2019，220：1–15.
[5]	HOOVER C G，BAZANT Z P. Comprehensive concrete fracture tests：size effects of types 1 and 2，crack length effect and postpeak[J]. Engineering Fracture Mechanics，2013，110(2)：281–289.
[14]	ZHU Z M. Numerical prediction of crater blasting and bench blasting[J]. International Journal of Rock Mechanics and Mining Sciences，2009，46(6)：1 088–1 096.
[25]	杨仁树，王雁冰. 切缝药包不耦合装药爆破爆生裂纹动态断裂效应的试验研究[J]. 岩石力学与工程学报，2013，32(7)：1 337–1 343. (YANG Renshu，WANG Yanbing. Experimental study of dynamic fracture effect of blasting crack in slotted cartridge decoupling charge blasting[J]. Chinese Journal of Rock Mechanics and Engineering，2013，32(7)：1 337–1 343.(in Chinese))
[10]	LOOCK F，THOULESS M D，FLECK N A. Tensile fracture of an adhesive joint：the role of crack length and of material mismatch[J]. Journal of the Mechanics and Physics of Solids，2019，130：330–347.
[21]	LI J F，YING P，ZHU Z M，et al. A new method for measuring the dynamic fracture toughness under blast loads using arc-edge rectangle with edge notches[J]. Theoretical and Applied Fracture Mechanics，2021，112(3)：1–11.
[27]	LI M，ZHU Z M，LIU R F，et al. Study of the effect of empty holes on propagating cracks under blasting loads[J]. International Journal of Rock Mechanics and Mining Sciences，2018，103：186–194.
[29]	徐文涛，朱哲明，曾利刚. 爆炸载荷下I型裂纹动态断裂韧度测试方法初探[J]. 岩石力学与工程学报，2015，34(增1)：2 767–2 772.(XU Wentao，ZHU Zheming，ZENG Ligang. Testing method study of mode-I dynamic fracture toughness under blasting loads[J]. Chinese Journal of Rock Mechanics and Engineering，2015，34(Supp.1)：2 767–2 772.(in Chinese))
[31]	ZHOU L，ZHU Z M，WANG M，et al. Dynamic propagation behavior of cracks emanating from tunnel edges under impact loads[J]. Soil Dynamics and Earthquake Engineering，2018，105：119–126.
[35]	ROSE L R F. Recent theoretical and experimental results on fast brittle fracture[J]. International Journal of Fracture，1976，12(6)：799–813.
[30]	刘瑞峰，朱哲明，李盟，等. 爆炸载荷下Ⅰ型裂纹的起裂及扩展规律研究[J]. 岩石力学与工程学报，2018，37(2)：392–402.(LIU Ruifeng，ZHU Zheming，LI Meng，et al. Initiation and propagation of mode I crack under blasting[J]. Chinese Journal of Rock Mechanics and Engineering，2018，37(2)：392–402.(in Chinese))
[32]	WANG X M，ZHU Z M，WANG M，et al. Study of rock dynamic fracture toughness by using VB-SCSC specimens under medium-low speed impacts[J]. Engineering Fracture Mechanics，2013，181：52–64.