切顶留巷矸石帮围岩–支护体承压变形特征及控制技术

doi:10.13722/j.cnki.jrme.2023.0386

Abstract
Figure/Table
References (0)
Related Citation (15)

Download: PDF (1744 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract Studies show that the stability of gangue side surrounding rock in gob side entry retaining by roof cutting affects the formation effectiveness and reusability of roadways. In this regard，various methods such as on-site investigations，theoretical analysis，and engineering experiments are widely employed to study the pressure bearing and deformation of the gangue side surrounding rock and support body. According to on-site investigations on the test section，the load formed on the gangue side support during the process of gangue collapse can be divided into dynamic load caused by the initial gangue collapse，analogous static load caused by slow compaction of gangue in the middle stage during the formation of roadway，and quasi static load originating from the stability in the later stage during the formation of roadway. A model was established to calculate the lateral pressure of the gangue side. The obtained results revealed that the lateral pressure of the gangue side increases from the roof to the floor. Then a correlation between the lateral pressure of the gangue side with the overlying rock pressure，internal friction angle of the gangue，gangue broken bulk coefficient，roof cutting height，and roof cutting angle was developed. A mechanical model was established to simulate interaction between the roof and floor of the roadway，the gangue side support，and the surrounding rock of the gangue side. The present study focuses on the influencing factors on the deformation of gangue side support and demonstrates that the lateral pressure on gangue side support was the internal cause of instability. Based on the obtained results，the construction of gangue side support was optimized and the linkage coupling support effect of single hydraulic prop and composite U-shaped steel was enhanced. The theoretical results were verified through on-site monitoring. The performance of the gangue side control demonstrated that the proposed optimized scheme effectively controls the surrounding rock deformation.

Key words： mining engineering gob side entry retaining by roof cutting gangue side surrounding rock-support body lateral pressure deformation of gangue side support linkage coupling support

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	XU Xuhui1
	HE Fulian1
	ZHAI Wenli1
	WANG Deqiu1
	LI Xiaobin2
	SONG Jiayu1
	ZHANG Yajiang1

Cite this article:

XU Xuhui1,HE Fulian1,ZHAI Wenli1, et al. Pressure bearing and deformation of the surrounding rock-support body and control technology on the gangue side in gob side entry retaining #br# by roof cutting[J]. , 2024, 43(2): 439-453.

URL:

http://rockmech.whrsm.ac.cn/EN/10.13722/j.cnki.jrme.2023.0386 OR http://rockmech.whrsm.ac.cn/EN/Y2024/V43/I2/439

[3]	张礼，赵晶，王栓林. 大倾角煤层切顶成巷顶板结构演化及控制技术[J]. 矿业科学学报，2020，5(2)：169-178.(ZHANG Li，ZHAO Jing，WANG Shuanlin. Research on the roof structure evolution and control technology of gob-side entry retaining with cutting the roof in steeply dipping seam[J]. Journal of Mining Science and Technology，2020，5(2)：169-178.(in Chinese))
[1]	康红普，张晓，王东攀，等. 无煤柱开采围岩控制技术及应用[J]. 煤炭学报，2022，47(1)：16-44.(KANG Hongpu，ZHANG Xiao，WANG Dongpan，et al. Strata control technology and applications of non-pillar coal mining[J]. Journal of the China Coal Society，2022，47(1)：16-44.(in Chinese))
[13]	郭志飚，王琼，王昊昊，等. 切顶成巷碎石帮泥岩碎胀特性及侧压力分析[J]. 中国矿业大学学报，2018，47(5)：987-994.(GUO Zhibiao，WANG Qiong，WANG Haohao，et al. Broken expand properties and lateral pressure analysis of mud rock of gangue rib in gob-side entry retaining formed by roof-cutting and pressure- releasing[J]. Journal of China University of Mining and Technology，2018，47(5)：987-994.(in Chinese))
[7]	盛奉天，张勇，魏文胜，等. 切顶参数对沿空留巷围岩稳定性的影响研究[J]. 矿业科学学报，2022，7(3)：322-332.(SHENG Fengtian，ZHANG Yong，WEI Wensheng，et al. Influence of roof cutting parameters on stability of surrounding rock of gob-side entry retaining[J]. Journal of Mining Science and Technology，2022，7(3)：322-332.(in Chinese))
[9]	何满潮，郭鹏飞，张晓虎，等. 基于双向聚能拉张爆破理论的巷道顶板定向预裂[J]. 爆炸与冲击，2018，38(4)：795-803.(HE Manchao，GUO Pengfei，ZHANG Xiaohu，et al. Directional pre-splitting of roadway roof based on the theory of bilateral cumulative tensile explosion[J]. Explosion and Shock Waves，2018，38(4)：795-803.(in Chinese))
[11]	胡涛，侯公羽，李子祥，等. 深孔爆破切顶对沿空留巷围岩稳定性影响的研究[J]. 矿业科学学报，2019，4(4)：299-307.(HU Tao，HOU Gongyu，LI Zixiang，et al. Study on influence of advanced deep-hole blasting pre-splitting roof on stability of gob side entry retaining[J]. Journal of Mining Science and Technology，2019，4(4)：299-307.(in Chinese))
[17]	陈上元，何满潮，郭志飚，等. 深部沿空切顶成巷围岩稳定性控制对策[J]. 工程科学与技术，2019，51(5)：107-116.(CHEN Shangyuan，HE Manchao，GUO Zhibiao，et al. Control countermeasures of surrounding rock in deep gob-side entry retaining by cutting roof[J]. Advanced Engineering Sciences，2019，51(5)：107-116.(in Chinese))
[19]	杨军，魏庆龙，王亚军，等. 切顶卸压无煤柱自成巷顶板变形机制及控制对策研究[J]. 岩土力学，2020，41(3)：989-998.(YANG Jun，WEI Qinglong，WANG Yajun，et al. Roof deformation mechanism and control measures of pillarless mining with gob-side entry retaining by roof cutting and pressure relief[J]. Rock and Soil Mechanics，2020，41(3)：989-998.(in Chinese))
[21]	蒋力帅. 工程岩体劣化与大采高沿空巷道围岩控制原理研究[博士学位论文][D]. 北京：中国矿业大学(北京)，2016.(JIANG Lishuai. Study on weakening of engineering rockmass and control principle of gob-side entry in large height mining condition[Ph. D. Thesis][D]. Beijing：China University of Mining and Technology(Beijing)，2016.(in Chinese))
[2]	马立强，张东升，王红胜，等. 厚煤层巷内预置充填带无煤柱开采技术[J]. 岩石力学与工程学报，2010，29(4)：674-680.(MA Liqiang，ZHANG Dongsheng，WANG Hongsheng，et al. Mining technique with preset packing body in roadway for thick coal seam without coal pillars[J]. Chinese Journal of Rock Mechanics and Engineering，2010，29(4)：674-680.(in Chinese))
[4]	何满潮，王亚军，杨军，等. 切顶卸压无煤柱自成巷开采与常规开采应力场分布特征对比分析[J]. 煤炭学报，2018，43(3)：626- 637.(HE Manchao，WANG Yajun，YANG Jun，et al. Comparative analysis on stress field distributions in roof cutting non-pillar mining method and conventional mining method[J]. Journal of China Coal Society，2018，43(3)：626-637.(in Chinese))
[6]	郭志飚，王将，曹天培，等. 薄煤层切顶卸压自动成巷关键参数研究[J]. 中国矿业大学学报，2016，45(5)：879-885.(GUO Zhibiao，WANG Jiang，CAO Tianpei，et al. Research on key parameters of gob-side entry retaining automatically formed by roof cutting and pressure release in thin coal seam mining[J]. Journal of China University of Mining and Technology，2016，45(5)：879-885.(in Chinese))
[12]	马新根，何满潮，张良，等. 切顶成巷采空区冒落矸石碎胀系数及侧向压力测定研究[J]. 煤炭工程，2019，51(2)：37-41.(MA Xingen，HE Manchao，ZHANG Liang，et al. Determination about bulk increase coefficient and lateral pressure of caving gangue in gob-side entry retaining formed by roof cutting[J]. Coal Engineering，2019，51(2)：37-41.(in Chinese))
[14]	王琼. 切顶卸压自成巷碎石帮承压变形机制研究[博士学位论文][D]. 北京：中国矿业大学(北京)，2019.(WANG Qiong. The pressure-bearing characteristics and deformation mechanism of gangue rib in gob-side entry retaining by roof-fracturing and pressure-releasing[Ph. D. Thesis][D]. Beijing：China University of Mining and Technology(Beijing)，2019.(in Chinese))
[16]	陈上元，何满潮，王洪建，等. 深井沿空切顶巷道围岩协同控制及应力演化规律[J]. 采矿与安全工程学报，2019，36(4)：660- 669.(CHEN Shangyuan，HE Manchao，WANG Hongjian，et al. Coordination control and stress evolution of surrounding rock of gob-side entry retaining cutting roof in deep mine[J]. Journal of Mining and Safety Engineering，2019，36(4)：660-669.(in Chinese))
[22]	钱鸣高，石平五，许家林. 矿山压力与岩层控制[M]. 徐州：中国矿业大学出版社，2010：106-110.(QIAN Minggao，SHI Pingwu，XU Jialin. Mine pressure and rock formation control[M]. Xuzhou：China University of Mining and Technology Press，2010：106-110.(in Chinese))
[5]	何满潮，马新根，王炯，等. 中厚煤层复合顶板切顶卸压自动成巷工作面矿压显现特征分析[J]. 岩石力学与工程学报，2018，37(11)：2 425-2 434.(HE Manchao，MA Xingen，WANG Jiong，et al. Feature analysis of working face strata pressure with roof cutting pressure releasing in medium-thick seam and compound roof condition[J]. Chinese Journal of Rock Mechanics and Engineering，2018，37(11)：2 425-2 434.(in Chinese))
[8]	陈上元，赵菲，王洪建，等. 深部切顶沿空成巷关键参数研究及工程应用[J]. 岩土力学，2019，40(1)：332-342.(CHEN Shangyuan，ZHAO Fei，WANG Hongjian，et al. Determination of key parameters of gob-side entry retaining by cutting roof and its application to a deep mine[J]. Rock and Soil Mechanics，2019，40(1)：332-342.(in Chinese))
[10]	马新根，何满潮，李钊，等. 复合顶板无煤柱自成巷切顶爆破设计关键参数研究[J]. 中国矿业大学学报，2019，48(2)：236- 246.(MA Xingen，HE Manchao，LI Zhao，et al. Key parameters of gob-side entry retaining automatically formed by roof cutting and blasting in compound roof condition[J]. Journal of China University of Mining and Technology，2019，48(2)：236-246.(in Chinese))
[15]	高玉兵，杨军，何满潮，等. 厚煤层无煤柱切顶成巷碎石帮变形机制及控制技术研究[J]. 岩石力学与工程学报，2017，36(10)：2 492- 2 502.(GAO Yubing，YANG Jun，HE Manchao，et al. Mechanism and control techniques for gangue rib deformations in gob-side entry retaining formed by roof fracturing in thick coal seams[J]. Chinese Journal of Rock Mechanics and Engineering，2017，36(10)：2 492- 2 502.(in Chinese))
[18]	朱珍，张科学，袁红平. 切顶卸压沿空留巷碎石巷帮控制技术及应用[J]. 煤炭科学技术，2018，46(3)：25-32.(ZHU Zhen，ZHANG Kexue，YUAN Hongping. Control technology and its application of roadway side wall formed by gangue in gob-side entry retaining formed by roof cutting and pressure releasing[J]. Coal Science and Technology，2018，46(3)：25-32.(in Chinese))
[20]	张强，杨康，张吉雄，等. 固体充填开采直接顶位态控制机制及工程案例[J]. 中国矿业大学学报，2022，51(1)：35-45.(ZHANG Qiang，YANG Kang，ZHANG Jixiong，et al. Immediate roof control mechanism in solid backfill mining method and its engineering case[J]. Journal of China University of Mining and Technology，2022，51(1)：35-45.(in Chinese))