复采工作面过冒顶区顶板断裂特征及控制研究

doi:10.13722/j.cnki.jrme.2015.0526

摘要
图/表
参考文献
相关文章 (15)

全文: PDF (935 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要针对复采工作面过冒顶区时工作面易发生煤壁滑帮、端面冒漏以及顶板来压强度大等特点，以晋煤集团圣华煤业3101复采工作面为工程背景，运用相似模拟对复采工作面过冒顶区时顶板破断特征、支承压力分布特征以及支架受力状态进行研究，依据相似模拟结果建立复采采场力学模型，推导液压支架支护强度的计算公式，提出复采工作面过冒顶区时的围岩控制技术。研究结果表明：(1) 工作面过冒顶区时采场顶板易形成大厚度、长跨距的超前大断裂；(2) 冒顶区弱化了顶板岩梁的应力传递，加剧了支承压力的荷重集度；(3) 液压支架受顶板超前大断裂的影响，支架工作阻力在通过冒顶区前呈突变性增加，模拟结果支架支护阻力最大值为16 200 kN，理论计算支架支护阻力为16 110.5 kN；(4) 复采工作面在通过冒顶区前必须对冒顶区进行注浆充填，同时给出支架工作阻力随充填体强度变化的关系式，为复采采场顶板控制提供理论依据。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	王开
	弓培林
	张小强
	连清旺
	李建忠
	段东

关键词 ：采矿工程, 复采, 冒顶区, 顶板断裂特征, 支架阻力, 围岩控制

Abstract：The residual coal mining face #3101 at Shenghua Coal Industry of Jincheng Anthracite Mining Group was studied to investigate the roof fracture characteristics，surrounding rock stress distribution and support stress state in the caving zone for residual coal mining face using the analog simulation considering the coal face sloughing，tip-to-face flaking and larger roof weighting strength features. On the basis of the simulation results，a mechanical model of residual coal mining field was established，a formula calculating the hydraulic support strength was derived，and further surrounding rock control technology in the caving zone for residual coal mining face was proposed. The roof of residual coal mining field was found to form easily thicker and long-span advanced fractures. The caving zone weakened the stress transfer of roof strata and aggravated the loading intensity of the support pressure. The working resistance of the hydraulic support suddenly increased due to the effect of advanced large fracture，its maximum value from numerical simulation is 16 200 kN，and the theoretically calculated value is 16 110.5 kN. The residual coal mining face must be grouted before passing through the caving zone. The relationship between the support working resistance and filling body strength was determined.

Key words： minning engineering residual coal mining caving zone roof fracture characteristics support resistance surrounding rock control

引用本文:

王开，弓培林，张小强，连清旺，李建忠，段东. 复采工作面过冒顶区顶板断裂特征及控制研究[J]. 岩石力学与工程学报, 2016, 35(10): 2080-2088.
WANG Kai，GONG Peilin，ZHANG Xiaoqiang，LIAN Qingwang，LI Jianzhong，DUAN Dong. Characteristics and control of roof fracture in caving zone for residual coal mining face. , 2016, 35(10): 2080-2088.

链接本文:

http://www.rockmech.org/CN/10.13722/j.cnki.jrme.2015.0526 或 http://www.rockmech.org/CN/Y2016/V35/I10/2080

[4]	冯国瑞，郑婧，任亚峰，等. 垮落法残采区上行综采技术条件判定理论及方法[J]. 煤炭学报，2010，35(11)：1 863-1 867.(FENG Guorui，ZHENG Jing，REN Yafeng，et al. Decision theory and method on feasibility on the upward fully mechanized mining of the left-over coal above gob area mined with caving method[J]. Journal of China Coal Society，2010，35(11)：1 863-1 867.(in Chinese))
[6]	许孟和. 旧采残煤长壁综采围岩控制及安全保障技术研究[硕士学位论文][D]. 太原：太原理工大学，2012.(XU Menghe. Surrounding rock control and security technology research on old residual coal mining longwall mining[M. S. Thesis][D]. Taiyuan：Taiyuan University of Technology，2012.(in Chinese)) " target="_blank">
[9]	何满潮，李国峰，王炯，等. 兴安矿深部软岩巷道大面积高冒落支护设计研究[J]. 岩石力学与工程学报，2007，26(5)：959-964.(HE Manchao，LI Guofeng，WANG Jiong，et al. Study on supporting design for large area serious roof caving of deep soft rock roadway in Xing?an coal mine[J]. Chinese Journal of Rock Mechanics and Engineering，2007，26(5)：959-964.(in Chinese))
[11]	汪锋，许家林，王晓振. 祁东煤矿7131工作面局部冒顶原因及机理分析[J]. 煤炭科学技术，2013，41(2)：24-27.(WANG Feng，XU Jialin，WANG Xiaozhen. Analysis on partial roof falling causes and mechanism of no. 7131 coal mining face in Qidong Mine[J]. Coal Science and Technology，2013，41(2)：24-27.(in Chinese))
[1]	王文学，隋旺华，董青红. 应力恢复对采动裂隙岩体渗透性演化的影响[J]. 煤炭学报，2014，39(6)：1 031-1 038.(WANG Wenxue，SUI Wanghua，DONG Qinghong. Influence of cover stress re- establishment on the permeability evolution of the mining-induced fractures[J]. Journal of China Coal Society，2014，39(6)：1 031- 1 038.(in Chinese))
[5]	张小强. 厚煤层残采后资源再回收的试验与研究[硕士学位论文][D]. 太原：太原理工大学，2011.(ZHANG Xiaoqiang. Test and study on resource recycle in left-over areas of thick coal seams[M. S. Thesis][D]. Taiyuan：Taiyuan University of Technology，2011.(in Chinese)) " target="_blank">
[7]	宋保胜. 刀柱式老采空区下遗留煤体复采可行性分析与实践[J]. 煤矿开采，2007，12(5)：18-20.(SONG Baosheng. Recovery mining feasibility analysis and practice of residual coal under gob mined with wedge pillar method[J]. Coal Mining Technology，2007，12(5)：18-20.(in Chinese))
[13]	康天合，柴肇云，李义宝，等. 底层大采高综放全厚开采20 m特厚中硬煤层的物理模拟研究[J]. 岩石力学与工程学报，2007，26(5)：1 065-1 072.(KANG Tianhe，CHAI Zhaoyun，LI Yibao，et al. Study on physical simulation of full-seam mining for 20 m very thick and medium hard seam by sub-level caving mining with high bottom cutting height[J]. Chinese Journal of Rock Mechanics and Engineering，2007，26(5)：1 065-1 072.(in Chinese))
[3]	陆刚. 衰老矿井残煤可采性评价与复采技术研究[博士学位论文][D]. 北京：中国矿业大学，2010.(LU Gang. Research on residual coal workability evaluation and remining technology of aged coal mine[Ph. D. Thesis][D]. Beijing：China University of Mining and Technology，2010.(in Chinese)) " target="_blank">
[12]	林韵梅. 实验岩石力学模拟研究[M]. 北京：煤炭工业出版社，1984：34-54.(LIN Yunmei. Experimental rock mechanics[M]. Beijing：China Coal Industry Publishing House，1984：34-54.(in Chinese)) " target="_blank">
[15]	弓培林，胡耀青，赵阳升，等. 带压开采底板变形破坏规律的三维相似模拟研究[J]. 岩石力学与工程学报，2005，24(23)：4 396-4 402. (GONG Peilin，HU Yaoqing，ZHAO Yangsheng，et al. Three- dimensional simulation study on law of deformation and breakage of coal floor on mining above aquifer[J]. Chinese Journal of Rock Mechanics and Engineering，2005，24(23)：4 396-4 402.(in Chinese))
[17]	王开，康天合，李海，等. 坚硬顶板控制放顶方式及合理悬顶长度的研究[J]. 岩石力学与工程学报，2009，28(11)：2 320-2 327. (WANG Kai，KANG Tianhe，LI Hai，et al. Study of control caving methods and reasonable hanging roof length on hard roof[J]. Chinese Journal of Rock Mechanics and Engineering，2009，28(11)：2 320-2 327.(in Chinese))
[2]	王文学，隋旺华，董青红，等. 松散层下覆岩裂隙采后闭合效应及重复开采覆岩破坏预测[J]. 煤炭学报，2013，38(10)：1 728-1 734. (WANG Wenxue，SUI Wanghua，DONG Qinghong，et al. Closure effect of mining-induced fractures under sand aquifers and prediction of overburden failure due to re-mining[J]. Journal of China Coal Society，2013，38(10)：1 728-1 734.(in Chinese))
[8]	张俊文，赵景礼，王志强. 近距残煤综放复采顶煤损伤与冒放性控制[J]. 煤炭学报，2010，35(11)：1 854-1 858.(ZHANG Junwen，ZHAO Jingli，WANG Zhiqiang. Top coal damage and caving characterizes control of residual coal repeated mining adopted longwall top-coal caving in contiguous seams[J]. Journal of China Coal Society，2010，35(11)：1 854-1 858.(in Chinese))
[10]	方新秋，郭敏江，吕志强. 近距离煤层群回采巷道失稳机制及其防治[J]. 岩石力学与工程学报，2009，28(10)：2 059-2 067.(FANG Xinqiu，GUO Minjiang，LU Zhiqiang. Instability mechanism and prevention of roadway under close-distance seam group mining[J]. Chinese Journal of Rock Mechanics and Engineering，2009，28(10)：2 059-2 067.(in Chinese))
[14]	柴敬. 浅埋煤层开采的大比例立体模拟研究[J]. 煤炭学报，1998，23(4)：391-396.(CHAI Jing. Study on large scale stereo scopic simulation for shallow seam mining[J]. Journal of China Coal Society，1998，23(4)：391-396.(in Chinese))
[20]	刘畅，弓培林，王开，等. 复采工作面过空巷顶板稳定性[J]. 煤炭学报，2015，40(2)：314-322.(LIU Chang，GONG Peilin，WANG Kai，et al. Roof stability for repeated mining workface passing through abandoned parallel gateway[J]. Journal of China Coal Society，2015，40(2)：314-322.(in Chinese))
[16]	刘正和，赵阳升，弓培林，等. 回采巷道顶板大深度切缝后煤柱应力分布特征[J]. 煤炭学报，2011，36(1)：18-23.(LIU Zhenghe，ZHAO Yangsheng，GONG Peilin，et al. Distribution characteristics of coal pillar stress after the roadway roof being large depth cutting seam[J]. Journal of China Coal Society，2011，36(1)：18-23.(in Chinese))
[18]	孔令海，姜福兴，王存文. 特厚煤层综放采场支架合理工作阻力研究[J]. 岩石力学与工程学报，2010，29(11)：2 312-2 318.(KONG Linghai，JIANG Fuxing，WANG Cunwen. Study of reasonable working resistance of support in fully-mechanized sublevel caving face in extra-thick coal seam[J]. Chinese Journal of Rock Mechanics and Engineering，2010，29(11)：2 312-2 318.(in Chinese))
[19]	贾喜荣. 岩石力学与岩层控制[M]. 北京：中国矿业大学出版社，2010：273-291.(JIA Xirong. Rock mechanics and ground control[M]. Beijing：China University of Mining and Technology Press，2010：273-291.(in Chinese)) " target="_blank">
[21]	张自政，柏建彪，韩志婷，等. 空巷顶板稳定性力学分析及充填技术研究[J]. 采矿与安全工程学报，2013，30(2)：194-198.(ZHANG Zizheng，BAI Jianbiao，HAN Zhiting，et al. Roof mechanics analysis and backfill technology for abandoned roadway[J]. Journal of Mining and Safety Engineering，2013，30(2)：194-198.(in Chinese))