基于平节理模型的花岗岩固有微裂纹对裂纹演化影响分析

doi:10.13722/j.cnki.jrme.2021.0510

摘要
图/表
参考文献
相关文章 (15)

全文: PDF (37766 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要模拟脆性岩石破坏时，现有的平节理模型没有考虑固有微裂纹导致的应力‐应变曲线非线性特征，也没有将起裂强度作为细观参数的标定基准。以花岗岩单轴抗压强度、弹性模量、泊松比、应力‐应变曲线特征、起裂强度、巴西劈裂抗拉强度、库仑摩擦角以及黏聚力作为基准，标定平节理模型细观参数，并分析宏细观参数间的趋势关系。以标定后的参数建立精确平节理模型试样，与不考虑固有微裂纹的常规平节理模型试样一起进行30°单裂纹岩石压缩数值试验，以室内试验数字图像相关方法得到的应变场为基础，对拉剪微裂纹萌生规律、数量以及分布特征进行分析，验证了提出的平节理模型参数标定方法，并表明固有微裂纹在宏观层面上改变了单轴压缩应力‐应变曲线特征，而在细观层面上对预制裂隙尖端初始裂纹的起裂模式、拉剪微裂纹的扩展分布规律均有较大影响。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	张睿1
	赵程1
	2
	幸金权1
	潘昊宇1

关键词 ：岩石力学, 花岗岩, 平节理模型, 参数标定, 裂纹扩展, 固有微裂纹

Abstract：When simulating the failure of brittle rock，existing studies based on the flat joint model neither consider the nonlinear characteristics of stress-strain curve caused by inherent microcracks，nor take the crack initiation stress，an important indicator of damage evaluation，as the calibration benchmark for micro parameters. Therefore，this study used uniaxial compressive strength，elastic modulus，Poisson's ratio，stress-strain curve characteristics，crack initiation stress，Brazilian splitting tensile strength，Coulomb friction angle and cohesive force as the benchmark to calibrate the micro parameters of the flat joint model for simulating granite failure. The trend relationships between the macro mechanical behaviors and micro parameters were analyzed. The calibrated parameters were used to establish an accurate flat joint model sample，which was compared with a conventional flat joint model sample that does not consider inherent microcracks. Numerical tests of fractured rock compression were carried out. Based on the strain field obtained by the digital image correlation method of the indoor test，the initiation，quantity and distribution characteristics of tensile/shear microcracks were analyzed to verify the calibration process of the flat joint model proposed in this paper. The results show that inherent microcracks influence the characteristics of the stress-strain curve at the macro level，and have a great impact on the crack initiation mode at the tip of the prefabricated flaw and the propagation and distribution law of tensile-shear microcracks at the meso level.

Key words： rock mechanics granite flat joint model parameter calibration crack development inherent microcracks

引用本文:

张睿1，赵程1，2，幸金权1，潘昊宇1. 基于平节理模型的花岗岩固有微裂纹对裂纹演化影响分析[J]. 岩石力学与工程学报, 2021, 40(9): 1857-1867.
ZHANG Rui1，ZHAO Cheng1，2，XING Jinquan1，PAN Haoyu1. Influence of granite inherent microcracks on crack evolution based on the flat-joint contact model. , 2021, 40(9): 1857-1867.

链接本文:

http://rockmech.whrsm.ac.cn/CN/10.13722/j.cnki.jrme.2021.0510 或 http://rockmech.whrsm.ac.cn/CN/Y2021/V40/I9/1857

[25]	PATEL S，MARTIN C D. Impact of the initial crack volume on the intact behavior of a bonded particle model[J]. Computers and Geotechnics，2020，127：103 764-103 774.
[2]	CUNDALL P A，STRACK O. A discrete numerical model for granular assemblies[J]. Géotechnique，2008，30(3)：331-336.
[4]	POTYONDY D O，CUNDALL P A. A bonded-particle model for rock[J]. International Journal of Rock Mechanics and Mining Sciences，2004，41(8)：1 329-1 364.
[6]	YANG S，HUANG Y. Particle flow study on strength and meso-mechanism of Brazilian splitting test for jointed rock mass[J]. Acta Mechanica Sinica，2014，30(4)：547-558.
[9]	倪小东，赵帅龙，王媛，等. 岩体水力劈裂的细观PFC-CFD联合分析[J]. 岩石力学与工程学报，2015，34(增2)：3 862-3 870.(NI Xiaodong，ZHAO Shuailong，WANG Yuan，et al. Numerical analysis of hydraulic fracturing of rock mass on mesoscopic level by coupled PFC-CFD method[J]. Chinese Journal of Rock Mechanics and Engineering，2015，34(supp. 2)：3 862-3 870.(in Chinese))
[3]	陈鹏宇. PFC2D模拟裂隙岩石裂纹扩展特征的研究现状[J]. 工程地质学报，2018，26(2)：528-539.(CHEN Pengyu. Research progress on PFC2D simulation of crack propagation characteristics of cracked rock[J]. Journal of Engineering Geology，2018，26(2)：528-539.(in Chinses))
[5]	YIN P，YANG S. Discrete element modeling of strength and failure behavior of transversely isotropic rock under uniaxial compression[J]. Journal of the Geological Society of India，2019，93(2)：235-246.
[7]	彭霞，饶秋华，李卓，等. 基于球面对称设计的离散元细观参数定量确定方法[J]. 中南大学学报：自然科学版，2019，50(11)： 2 801-2 812.(PENG Xia，RAO Qiuhua，LI Zhuo，et al. Quantitative determination method of mesoscopic parameters of discrete elements based on spherical symmetric design[J]. Journal of Central South University：Science and Technology，2019，50(11)：2 801-2 812.(in Chinese))
[10]	WU S，XU X. A Study of three intrinsic problems of the classic discrete element method using flat-joint model[J]. Rock Mechanics and Rock Engineering，2016，49(5)：1 813-1 830.
[13]	POTYONDY D O. A flat-jointed bonded-particle model for rock[C]// 52nd U.S. Rock Mechanics/Geomechanics Symposium. Seattle，Washington，USA：[s. n. ]，2018：ARMA-2018-1208.
[15]	刘富有，陈鹏宇，余宏明. 基于Flatjoint接触模型的岩石单轴压缩和巴西劈裂颗粒流模拟研究[J]. 长江科学院院报，2016，33(9)：60-65.(LIU Fuyou，CHEN Pengyu，YU Hongming. PFC simulation of uniaxial compression and Brazilian splitting test of rock based on flat-jointed bonded-particle material[J]. Journal of Yangtze River Scientific Research Institute，2016，33(9)：60-65.(in Chinese))
[17]	LI K，CHENG Y，FAN X. Roles of model size and particle size distribution on macro-mechanical properties of Lac du Bonnet granite using flat-joint model[J]. Computers and Geotechnics，2018，103：43-60.
[19]	张宝玉，张昌锁，王晨龙，等. PFC2D平节理模型细观参数标定方法[J]. 计算力学学报，2021，https：//kns.cnki.net/kcms/detail/ 21.1373.o3.20201221.1447.012.html.(ZHANG Baoyu，ZHANG Changsuo，WANG Chenlong，et al. Calibration method of meso- parameters of PFC2D flat-joint model[J]. Chinese Journal of Computational Mechanics，2021，https：//kns.cnki.net/kcms/detail/21.1373.o3. 20201221.1447.012.html.(in Chinese))
[20]	YOON J. Application of experimental design and optimization to PFC model calibration in uniaxial compression simulation[J]. International Journal of Rock Mechanics and Mining Sciences，2007，44(6)：871-889.
[1]	LISJAK A，GRASSELLI G. A review of discrete modeling techniques for fracturing processes in discontinuous rock masses[J]. Journal of Rock Mechanics and Geotechnical Engineering，2014，6(4)：301-314.
[11]	SHU B，LIANG M，ZHANG S，et al. Numerical modeling of the relationship between mechanical properties of granite and microparameters of the flat-joint model considering particle size distribution[J]. Mathematical Geosciences，2019，51(3)：319-336.
[21]	GHAZVINIAN A，SARFARAZI V，Schubert W，et al. A Study of the failure mechanism of planar non-persistent open joints using PFC2D[J]. Rock Mechanics and Rock Engineering，2012，45(5)：677-693.
[23]	WONG L N Y，ZHANG X. Size effects on cracking behavior of flaw-containing specimens under compressive loading[J]. Rock Mechanics and Rock Engineering，2014，47(5)：1 921-1 930.
[27]	张骞，李术才，李利平，等. 岩石三轴压缩峰后曲线与抗剪强度参数关系探讨[J]. 地下空间与工程学报，2015，11(3)：642-646. (ZHANG Qian，LI Shucai，LI Liping，et al. Discussion on relationship between post-peak curves and shear strength parameters of rock subjected to triaxial compression[J]. Chinese Journal of Underground Space and Engineering，2015，11(3)：642-646.(in Chinese))
[30]	WONG L N Y，EINSTEIN H H. Systematic evaluation of cracking behavior in specimens containing single flaws under uniaxial compression[J]. International Journal of Rock Mechanics and Mining Sciences，2009，46(2)：239-249.
[31]	ZHAO C，NIU J，ZHANG Q，et al. Failure characteristics of rock-like materials with single flaws under uniaxial compression[J]. Bulletin of Engineering Geology and the Environment，2019，78(1)：593-603.
[8]	ZHANG X，WONG L N Y. Cracking processes in rock-like material containing a single flaw under uniaxial compression：a numerical study based on parallel bonded-particle model approach[J]. Rock Mechanics and Rock Engineering，2012，45：711-737.
[12]	POTYONDY D O. A flat-jointed bonded-particle material for hard rock[C]// 46th U.S. Rock Mechanics/Geomechanics Symposium. Chicago，Illinois，USA：[s. n. ]，2012：ARMA-2012-501.
[14]	陈鹏宇，余宏明. 平直节理黏结颗粒材料宏细观参数关系及细观参数的标定[J]. 土木建筑与环境工程，2016，38(5)：74-84.(CHEN Pengyu，YU Hongming. Relationship between macroparameters and microparameters of flat-jointed bonded-particle material and calibration of microparameters[J]. Journal of Civil，Architectural and Environmental Engineering，2016，38(5)：74-84.(in Chinese))
[16]	VALLEJOS J A，SALINAS J M，DELONCA A，et al. Calibration and verification of two bonded-particle models for simulation of intact rock behavior[J]. International Journal of Geomechanics，2017，17(4)：6016030.
[18]	BAHAADDINI M，SHEIKHPOURKHANI A M，MANSOURI H. Flat-joint model to reproduce the mechanical behaviour of intact rocks[J]. European Journal of Environmental and Civil Engineering，2019，25(8)：1-22.
[22]	SARFARAZI V，GHAZVINIAN A，SCHUBERT W，et al. Numerical simulation of the process of fracture of echelon rock joints[J]. Rock Mechanics and Rock Engineering，2014，47(4)：1 355-1 371.
[24]	CHENG Y，WONG L N Y. A study on mechanical properties and fracturing behavior of Carrara marble with the flat‐jointed model[J]. International Journal for Numerical and Analytical Methods in Geomechanics，2020，44(6)：803-822.
[26]	HOEK E，MARTIN C D. Fracture initiation and propagation in intact rock-a review[J]. Journal of Rock Mechanics and Geotechnical Engineering，2014，6(4)：287-300.
[28]	李鹏飞，赵星光，郭政，等. 北山花岗岩在三轴压缩条件下的强度参数演化[J]. 岩石力学与工程学报，2017，36(7)：1 599-1 610. (LI Pengfei，ZHAO Xingguang，GUO Zheng，et al. Variation of strength parameters of Beishan granite under triaxial compression[J]. Chinese Journal of Rock Mechanics and Engineering，2017，36(7)：1 599-1 610.(in Chinese))
[32]	WONG L N Y，XIONG Q. A method for multiscale interpretation of fracture processes in carrara marble specimen containing a single flaw under uniaxial compression[J]. Journal of Geophysical Research：Solid Earth，2018，123(80)：6 459-6 490.
[29]	ZHAO C，XING J，ZHOU Y，et al. Experimental investigation on hydraulic fracturing of granite specimens with double flaws based on DIC[J]. Engineering Geology，2020，267：105 510-105 523.