双轴加载下断续预置裂纹贯通机制的研究*

摘要
图/表
参考文献(23)
相关文章 (6)

全文: PDF (878 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要通过物理实验和数值模拟，研究双轴作用下不同几何分布和不同围压的断续预置三裂纹的萌生、扩展和贯通机制。结果清楚显示裂纹贯通机制主要受加载条件与预置裂纹几何分布的影响。在双轴加载条件下，裂纹贯通的模式包括拉贯通、剪贯通、压贯通和混合贯通。拉裂纹在双轴加载下，其扩展速度减慢或停止，且在岩桥间出现剪裂纹，从而形成混合贯通或剪贯通。压裂纹是在侧压下产生的次生裂纹，其贯通受制于两非共线的重叠裂纹间的岩距。当1＜b/c＜1.8(岩距与裂纹长度的比值为b/c)时，则压裂纹最为活跃，否则压裂纹较难生长。双轴作用下，三裂纹在峰值附近有两组贯通裂纹，在单轴情况则通常只发生一组贯通裂纹。此外，随着压力增加，预置裂纹间更加闭合，导致预置裂纹的内摩擦力增加，使裂纹的扩展方向改变并趋向于最大主剪应力方向。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章

关键词 ：断续预置裂纹, 裂纹贯通, 贯通模式, 裂纹类型

Abstract：The mechanism of the fracture coalescence between three flaws is studied using rock-like modelling material under confining pressure condition. The specimens contain three pre-existing flaws with different geometry distribution and different confining condition. Experimental and numerical results show that the mechanisms of crack coalescence is controlled by the geometric setting of the flaws and the confining pressure. Under the confining condition，there are four modes of coalescence between the rock bridge：tensile mode，shear mode，compression mode and mix mode(shear and tensile). The growth of tensile crack slows down with the increasing of confining pressure. Compressive crack is active when the flaws are overlapping and with a distance between two flaws 1＜b/c＜2. Under the confining pressure，the opening of flaws becomes more close，and leads to increase the friction between flaws. It also causes the growth of crack more close to the axial direction.

Key words： non-persistent pre-existing flaw crack coalescence coalescence mode types of initiated crack

引用本文:

黄凯珠1 林鹏2 唐春安2 周锦添1. 双轴加载下断续预置裂纹贯通机制的研究*[J]. 岩石力学与工程学报, 2002, 21(06): 808-816.
Wong Robina H C 1， Lin Peng 2， Tang Chunan 2， Chau1 K T. mechanisms of crack coalescence of PRE- EXISTING flaws under biaxial compression. , 2002, 21(06): 808-816.

链接本文:

https://rockmech.whrsm.ac.cn/CN/Y2002/V21/I06/808

1R	eyesO，EinsteinHH.Fracture mechanism of fractured rock—a fracture coalescence model[A]. In：Proc. 7th Int. Conf. On Rock Mech.[C]. Germany：A. A. Balkema，1991，1：333～340
2S	henB，StephanssonO，EinsteinHH，et al. Coalescence of fractures under shear stress experiments[J]. Journal of Geophysical Research，1995，100(B4)：5975～5990
3B	obetA，EinsteinHH.Fracture coalescence in rock-type material under uniaxial and biaxial compression[J]. Int. J. Rock Mech.Min.Sci.，1998，35(7)：836～888
4H	oriiH，Nemat-NasserS.Brittle failure in compression：splitting and brittle-ductile transition[J]. Philosophical Transactions of the Royal Society of London，Series A，1986，319：337～374
5H	oriiH，Nemat-NasserS.Elastic fields of intersecting inhomo-
	geneities[J]. International Journal of Solids Structures，1985，21(7)：731～745
6A	shbyMF，HallamSD.The failure of brittle solids containing small cracks under compressive stress states[J]. Acta Metall.，1986，34(3)：497～510
7王	庚荪. 多裂纹材料的单轴压缩破坏机制与强度[J]. 岩土力学，1992，13(4)：1～13
8李	术才，朱维申.复杂应力状态下断续节理岩体断裂损伤机理研究及其应用[J]. 岩石力学与工程学报，1999，18(2)：142～146
9W	ongRHC，ChauKT，WangP.Microcracking and grain size effect in Yuenlong marbles[J]. Int. J. Rock Mech. Min. Sci. & Geomech. Abstr.，1996，33(5)：479～485
10	Wong R H C. Failure mechanisms and peak strengths of natural rocks and rock-like solids containing frictional cracks[Ph.D.thesis][D]. Hong Kong：Civil and Structural Eng. Dept.，Hong Kong Polytechnic University，1997
11	WongRHC，ChauKT.The coalescence of frictional cracks and the shear zone formation in brittle solids under compressive stresses[J].Int. J. of Rock Mech. & Min. Sci.，1997，34(3/4)：335～366
12	WongRHC，ChauKT.Crack coalescence in a rock-like material containing two cracks[J]. Int. J. Rock Mech. Min. Sci.，1998，35(2)：147～164
13	Wong RHC，ChauKT.Peak strength of replicated and real rocks containing cracks[J]. Key Engineering Materials，1998，(145～149)：953～958
14	WongRHC，TangCA，ChauKT，et al.Analysis of crack coalescence in rock-like materials containing three flaws ¾part I：experimental approach[J]. Int. J. Rock Mech. Min. Sci.，(in press)
15	TangCA，WongRHC，ChauKT，et al. Analysis of crack coalescence in rock-like materials containing three flaws ¾part II：numerical approach[J].Int. J. Rock Mech. min. Sci.，(in press)
16	Wong R H C，Chau K T，Tsoi P M，et al. Pattern of coalescence of rock bridge between two joints under shear testing[A]. In：Voaille Berest ed. Proc. 9th In. Congress on Rock Mech.[C]. Rotterdam：A. A. Balkema，1999，1：735～738
17	Wong RHC，Leung WL，Wnag S W.Shear strength studies on rock-like models containing arrayed open joints[A]. In：Elsworth Tinucci ed. Proc. 38th U. S. Rock Mechanics Symposium，Rock Mechanics in the National Interest[C]. Washington D C：A. A. Balkema，2001
18	唐春安. 岩石破裂过程分析的数值试验方法[A]. 见：曹洪，陈晓文，廖建三编. 第五界全国青年岩石力学与工程学术会议论文集[C]. 广州：华南理工大学出版社，1999，73～81
19	TangCA.Numerical simulation of progressive rock failure and associated seismicity[J]. Int. J. Rock Mech. Min. Sci.，1997，34(2)：249～262
20	唐春安，赵文. 岩石破裂全过程分析软件系统RFPA2D[J]. 岩石力学与工程学报，1997，16(5)：507～508
21	黄明利，唐春安，朱万成. 岩石破裂全过程的数值模拟研究[J]. 岩石力学与工程学报，2000，19(4)：468～471
22	刘红元，唐春安，芮勇勤. 多煤层开采时岩层垮落过程的数值模拟[J]. 岩石力学与工程学报，2001，20(2)：190～196
23	FarmerI W. Engineering behaviour of rocks[M]. Second Edition，London：Chapman & Hall，1983