基于DIC方法与声发射的花岗岩断裂过程区范围研究

doi:10.13722/j.cnki.jrme.2022.0156

摘要
图/表
参考文献
相关文章 (15)

全文: PDF (1597 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要岩石在断裂过程中容易在裂纹尖端产生断裂过程区(fracture process zone，FPZ)，断裂过程区的几何特征决定了岩石材料断裂特征和宏观力学行为，直接影响工程岩体的安全性和稳定性。为研究花岗岩断裂过程区的孕育特征及演化过程，在MTS液压伺服试验机上对带切口半圆盘试样进行三点弯I型加载试验。借助数字图像相关方法(digital image correlation，DIC) 和声发射(acoustic emission，AE)定位技术对宏微观尺度下I型裂纹尖端的断裂过程区孕育过程进行研究。采用自编程的声发射信号识别与定位方法，得到微裂纹事件空间分布密度阈值和能量分布，确定微观尺度上断裂过程区的范围和外边界，结合宏观DIC方法得到岩石的断裂过程区的临界应变值εFPZ。同时，使用Irwin-Bazant模型确定试样完全发育的断裂过程区长度，并与试验结果进行对比。结合试样波速，进一步得到裂纹端部临界张开度解析解。结果表明：(1) 试验所用岩石断裂过程区临界应变值为1.8‰左右；(2) 断裂过程区长度理论值与试验值吻合良好，对于试验所用岩石，断裂过程区的理论长度为5.2～8.7 mm，试验结果为5.0～8.0 mm；(3) 断裂过程区的边界可认为是沿裂纹扩展方向声发射能量由高能量突变并维持在低能量的位置。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	傅帅旸1
	2
	李海波1
	2
	李晓锋3

关键词 ：岩石力学, 声发射, 数字图像相关方法, 断裂过程区, 裂纹张开度, 花岗岩

Abstract：Fracture process zone(FPZ) is easily generated at the crack tip during the fracture process of rock. The geometry feature of FPZ determines the fracture properties and macro-mechanical behavior of rock. It significantly influences the safety and stability of the rock mass in practical engineering. Mode I three-point bending tests using notched semi-circular bend specimens were performed on MTS testing machine to study the nucleation characteristics and evolution process of the FPZ in granites. To understand the FPZ nucleation process at the tip of the mode I crack，the digital image correlation method(DIC) and the acoustic emission(AE) localization were employed. Micro and macro failure behaviors in rocks were obtained. According to the self-programmed acoustic emission signal identification and localization method，the spatial distribution density of AE events and AE energy were obtained. Then the zone and boundary of the micro-scale FPZ were determined. After which the critical strain value εFPZ of the FPZ was obtained in cooperation with the DIC method. The Irwin-Bazant model was utilized to determine the fully developed FPZ length of the sample，and the experimental value was compared with the theoretical one. Combining the wave velocity of the sample，the theoretical solution of the critical crack opening displacement(COD) at the crack end is obtained and compared with the experimental results. The results indicated that：(1) the critical strain value of FPZ of the rocks used in the experiment is about 1.8‰. (2) The theoretical value of the length of FPZ is in good agreement with the experimental value. For the rocks used in the experiment，the theoretical length of the FPZ is 5.2–8.7 mm，and the experimental result is 5–8 mm. (3) The boundary of FPZ can be regarded as the position where the AE energy suddenly changes from high to low along the crack propagation direction and remains at low energy.

Key words： rock mechanics acoustic emission digital image correlation fracture process zone crack opening displacement granite

引用本文:

傅帅旸1，2，李海波1，2，李晓锋3. 基于DIC方法与声发射的花岗岩断裂过程区范围研究[J]. 岩石力学与工程学报, 2022, 41(12): 2497-2508.
FU Shuaiyang1，2，LI Haibo1，2，LI Xiaofeng3. Research on the range of fracture process zone of granite based on DIC and acoustic emission . , 2022, 41(12): 2497-2508.

链接本文:

http://rockmech.whrsm.ac.cn/CN/10.13722/j.cnki.jrme.2022.0156 或 http://rockmech.whrsm.ac.cn/CN/Y2022/V41/I12/2497

[17]	KEERTHANA K，KISHEN J M C. Micromechanics of fracture and failure in concrete under monotonic and fatigue loadings[J]. Mechanics of Materials，2020，148：103490.
[2]	BA?ANT Z P，PLANAS J. Fracture and size effect in concrete and other quasibrittle materials[M]. Boca Raton，Florida，USA：CRC Press，1998：9–10.
[21]	GE M. Analysis of source location algorithms：Part II. Iterative methods[J]. Journal of Acoustic Emission，2003，21(1)：29–51.
[3]	INGRAFFEA A R. Theory of crack initiation and propagation in rock[C]// ATKINSON B K. ed. Fracture Mechanics of Rock. London：Academic Press，1987：71–110.
[14]	GUO T Y，WONG L N Y. Microcracking behavior of three granites under mode I loading：Insights from acoustic emission[J]. Engineering Geology，2020，278：105823.
[4]	GRIFFITH A A. The phenomena of rupture and flow in solids[J]. Philosophical Transactions of the Royal Society of London. Series A，Containing Papers of a Mathematical or Physical Character，1921，221：163–198.
[6]	IRWIN G R. Plastic zone near a crack and fracture toughness[C]// Proceedings of the Seventh Sagamore Ordnance Materials Conference. New York：Syracuse University，1960：63–78.
[9]	纪维伟，潘鹏志，苗书婷，等. 基于数字图像相关法的两类岩石断裂特征研究[J]. 岩土力学，2016，37(8)：2 299–2 305.(JI Weiwei，PAN Pengzhi，MIAO Shuting，et al. Fracture characteristics of two types of rocks based on digital image correlation[J]. Rock and soil Mechanics，2016，37(8)：2 299–2 305.(in Chinese))
[11]	DUTLER N，NEJATI M，VALLEY B，et al. On the link between fracture toughness，tensile strength，and fracture process zone in anisotropic rocks[J]. Engineering Fracture Mechanics，2018，201(August)：56–79.
[13]	OTSUKA K，DATE H. Fracture process zone in concrete tension specimen[J]. Engineering Fracture Mechanics，2000，65(2/3)：111–131.
[15]	LIN Q，WANG S，WAN B，et al. Characterization of fracture process in sandstone：a linear correspondence between acoustic emission energy density and opening displacement gradient[J]. Rock Mechanics and Rock Engineering，2020，53(2)：975–981.
[20]	王笑然，李楠，王恩元，等. 岩石裂纹扩展微观机制声发射定量反演[J]. 地球物理学报，2020，63(7)：2 627–2 643.(WANG XiaoRan，LI Nan，WANG EnYuan，et al. Microcracking mechanisms of sandstone from acoustic emission source inversion[J]. Chinese Journal of Geophysics，2020，63(7)：2 627–2 643.(in Chinese))
[5]	IRWIN G R. Fracture[M]. [S. l.]：Springer，1958：551–590.
[7]	COX B N，MARSHALL D B. Concepts for bridged cracks in fracture and fatigue[J]. Acta Metallurgica et Materialia，1994，42(2)：341–363.
[16]	LIN Q，WAN B，WANG Y，et al. Unifying acoustic emission and digital imaging observations of quasi-brittle fracture[J]. Theoretical and Applied Fracture Mechanics，2019，103：102301.
[18]	DAI S H，LIU X L，NAWNIT K. Experimental study on the fracture process zone characteristics in concrete utilizing DIC and AE methods[J]. Applied Sciences，2019，9(7)：1–12.
[22]	王笑然，王恩元，刘晓斐，等. 煤样三点弯曲裂纹扩展及断裂力学参数研究[J]. 岩石力学与工程学报，2021，40(4)：690–702.(WANG Xiaoran，WANG Enyuan，LIU Xiaofei，et al. Three-point-bending test of crack propagation and fracture parameters of coal specimens[J]. Chinese Journal of Rock Mechanics and Engineering，2021，40(4)：690–702.(in Chinese))
[24]	LIN Q，MAO D，WANG S，et al. The influences of mode II loading on fracture process in rock using acoustic emission energy[J]. Engineering Fracture Mechanics，2018，194：136–144.
[1]	HILLERBORG A，MODéER M，PETERSSON P E. Analysis of crack formation and crack growth in concrete by means of fracture mechanics and finite elements[J]. Cement and Concrete Research，1976，6(6)：773–781.
[8]	DUGDALE D S. Yielding of steel sheets containing slits[J]. Journal of the Mechanics and Physics of Solids，1960，8(2)：100–104.
[10]	安定超，张盛，张旭龙，等. 岩石断裂过程区孕育规律与声发射特征实验研究[J]. 岩石力学与工程学报，2021，40(2)：290–301.(AN Dingchao，ZHANG Sheng，ZHANG Xulong，et al. Experimental study on incubation and acoustic emission characteristics of rock fracture process zones[J]. Chinese Journal of Rock Mechanics and Engineering，2021，40(2)：290–301.(in Chinese))
[12]	ZIETLOW WK，LABUZ JF. Measurement of the intrinsic process zone in rock using acoustic emission[J]. International Journal of Rock Mechanics and Mining Sciences，1998，35(3)：291–299.
[19]	白添羊，吴顺川，王进进，等. 岩石破裂声发射压缩波到时拾取方法及其优化改进研究[J]. 岩石力学与工程学报，2016，35(9)：1 754–1 766.(BAI Tianyang，WU Shunchuan，WANG Jinjin，et al. Methods of P-onset picking of acoustic emission compression waves and optimized improvement[J]. Chinese Journal of Rock Mechanics and Engineering，2016，35(9)：1 754–1 766.(in Chinese))
[23]	ZANG A，WAGNER F C，STANCHITS S，et al. Fracture process zone in granite[J]. Journal of Geophysical Research：Solid Earth，2000，105(B10)：23 651–23 661.
[25]	ZHANG S，WANG H，LI X，et al. Experimental study on development characteristics and size effect of rock fracture process zone[J]. Engineering Fracture Mechanics，2021，241：107377.