反倾岩质边坡多级破坏边界折断深度计算模型

doi:10.13722/j.cnki.jrme.2022.0321

摘要
图/表
参考文献
相关文章 (15)

全文: PDF (50067 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要目前对边坡多级破坏折断深度及演化过程的研究相对较少，针对这类问题，在已有破坏边界模型的基础上采用悬臂梁极限平衡理论，对边坡多级破坏边界折断深度进行理论推导，建立多级破坏边界折断深度的计算模型，并通过大型离心模拟试验及工程实例对模型的可靠性和适用性进行验证。结果表明：离心模拟试验展现的多级破坏边界演化过程与提出的岩质边坡破坏边界一致，经计算二级破坏边界的折断深度为215.35 mm，三级破坏边界的折断深度为87.39 mm，模型计算结果与离心机试验结果相吻合，验证了所建立模型的可靠性；利用计算模型对云南省澜沧江左岸一处反倾岩质边坡多级折断深度进行计算，其二级破坏边界折断深度为8.06 m，三级破坏边界折断深度为2.34 m，经现场测量其二级、三级破坏边界折断深度分别为6～10 m和0.5～2 m，计算结果与边坡实际相符。研究成果对反倾层状岩质边坡稳定性及破坏机制的分析具有理论指导意义。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	王洋1
	魏玉峰1
	贺琮栖1
	金磊磊2
	梁彭1

关键词 ：边坡工程, 反倾层状岩质边坡, 极限平衡法, 多级破坏边界, 折断深度, 离心模拟试验

Abstract：At present，there are relatively few studies on the fracture depth and evolution process of multi-level failure of slopes. In order to solve such problems，the limit equilibrium theory of the cantilever beam is used on the basis of the existing failure boundary model to deduce the fracture depth of the multi-level failure boundary of slopes，a calculation model of the fracture depth of the multi-level failure boundary is established，and the reliability and applicability of the model are verified through large-scale centrifugal simulation tests and engineering examples. The results show that the evolution process of the multi-level failure boundary shown by the centrifugal simulation test is consistent with the proposed calculation model. According to calculation results by the proposed model，the fracture depth of the secondary failure boundary is 215.35 mm，and the fracture depth of the third-level failure boundary is 87.39 mm，which are consistent with the centrifuge test results. Calculation results of an anti-dip rock slope on the left bank of the Lancang River in Yunnan Province buy using the calculation model show that the fracture depth of the first-level failure boundary is 8.06 m and the third-level failure boundary is 2.34 m. The field measurements of the second-level and third-level failure boundaries are 6–10 m and 0.5–2 m respectively. The calculated results are consistent with the actual measuring values. The research results have theoretical guiding significance for the analysis of the stability and failure mechanism of the anti-dip layered rock slope.

Key words： slope engineering anti-dip layered rock slope limit equilibrium method multi-level failure surface fracture depth centrifugal simulation test

引用本文:

王洋1，魏玉峰1，贺琮栖1，金磊磊2，梁彭1. 反倾岩质边坡多级破坏边界折断深度计算模型[J]. 岩石力学与工程学报, 2023, 42(3): 630-639.
WANG Yang1，WEI Yufeng1，HE Congxi1，JIN Leilei2，LIANG Peng1. A calculation model of boundary breaking depth for multilevel failure of anti-dip rock slopes. , 2023, 42(3): 630-639.

链接本文:

http://rockmech.whrsm.ac.cn/CN/10.13722/j.cnki.jrme.2022.0321 或 http://rockmech.whrsm.ac.cn/CN/Y2023/V42/I3/630

[5]	孙广忠. 岩体结构力学[M]. 北京：科学出版社，1988：151-155.(SUN Guangzhong. Structural mechanics of rock mass[M]. Beijing：Science Press，1988：151-155.(in Chinese))
[3]	SAGASETA C，SANCHEZ J M，CANIZAL J. A general analytical solution for the required anchor force in rock slopes with toppling failure-science direct[J]. International Journal of Rock Mechanics and Mining Sciences，2001，38(3)：421-435.
[14]	蒋良潍，黄润秋. 反倾层状岩体斜坡弯曲-拉裂两种失稳破坏之判据探讨[J]. 工程地质学报，2006，14(3)：289-294.(JIANG Liangwei，HUANG Runqiu. Discussion on the criteria for two destabilizing failures of slope bending and pulling cracking of anti-dip layered rock masses[J]. Chinese Journal of Engineering Geology，2006，14(3)：289-294.(in Chinese))
[16]	卢海峰. 巴东组软岩边坡岩体工程特性及破坏机制研究[博士学位论文][D]. 北京：中国科学院研究生院，2010.(LU Haifeng. Research on engineering characteristics and failure mechanism of Badong formation soft rock slope[Ph. D. Thesis][D]. Beijing：Graduate School of Chinese Academy of Sciences，2010.(in Chinese))
[8]	ADHIKARY D P，DYSKIN A V. Modelling of Progressive and instantaneous failures of foliated rock slopes[J]. Rock Mechanics and Rock Engineering，2007，40(4)：349-362.
[10]	赵维，王润清，年廷凯. 基于弯曲倾倒破坏模式的反倾岩质边坡稳定性解析方法[J]. 岩石力学与工程学报，2019，38(增2)：3 287-3 295. (ZHAO Wei，WANG Runqing，NIAN Yankai. Stability analysis method of anti-dip rock slope based on bending and tipping failure mode[J]. Chinese Journal of Rock Mechanics and Engineering，2019，38(Supp.2)：3 287-3 295.(in Chinese))
[19]	LI B，FENG Z ，WANG G，et al. Processes and behaviors of block topple avalanches resulting from carbonate slope failures due to underground mining[J]. Environmental Earth Sciences，2016，75(8)：694.1-694.26.
[1]	GOODMAN R E，BRAY J W. Toppling of rock slopes[C]// Proceedings of the Specialty Conference on Rock Engineering for Foundations and Slopes. Colorado：[s. n.]，1976：201-234.
[2]	WYLLIE D C. Toppling rock slope failures examples of analysis and stabilization[J]. Rock Mechanics，1980，13(2)：89-98.
[4]	LIU C H，JAKSA M B，MEYERS A G. A transfer coefficient method for rock slope toppling[J]. Canadian Geotechnical Journal，2009，46(1)：1-9.
[6]	AYDAN Ö，KAWAMOTO T. The stability of slopes and underground openings against flexural toppling and their stabilization[J]. Rock Mechanics and Rock Engineering，1992，25(3)：143-165.
[7]	ADHIKARY D P，DYSKIN A V，JEWELL R J，et al. A study of the mechanism of flexural toppling failure of rock slopes[J]. Rock Mechanics and Rock Engineering，1997，30(2)：75-93.
[9]	蔡静森，晏鄂川，王章琼，等. 反倾层状岩质边坡悬臂梁极限平衡模型研究[J]. 岩土力学，2014，35(增1)：15-28.(CAI Jingsen，YAN Echuan，WANG Zhangqiong，et al. Research on limit equilibrium model of cantilever beam in antidip layered rock slope[J]. Rock and Soil Mechanics，2014，35(Supp.1)：15-28.(in Chinese))
[11]	刘海军，赵建军，巨能攀. 岩质边坡倾倒破坏的力学分析[J]. 岩土力学，2016，37(增1)：289-294.(LIU Haijun，ZHAO Jianjun，JU Nengpan. Research on limit equilibrium model of cantilever beam in antidip layered rock slope[J]. Rock and Soil Mechanics，2016，37(Supp.1)：289-294.(in Chinese))
[12]	黄润秋. 岩石高边坡稳定性工程地质分析[M]. 北京：科学出版社，2012：343-353.(HUANG Runqiu. Engineering gedogy for high rock slopes[M]. Beijing：Science Press，2012：343-353.(in Chinese))
[13]	陈红旗，黄润秋. 反倾层状边坡弯曲折断的应力及挠度判据[J]. 工程地质学报，2004，12(3)：243-246.(CHEN Hongqi，HUANG Runqiu. Stress and deflection criteria for bending and fracture of reverse layered slope[J]. Chinese Journal of Engineering Geology，2004，12(3)：243-246.(in Chinese))
[15]	卢海峰，刘泉声，陈从新. 反倾岩质边坡悬臂梁极限平衡模型的改进[J]. 岩土力学，2012，33(2)：262-269.(LU Haifeng，LIU Quansheng，CHEN Congxin. Improvement of limit equilibrium model of cantilever beam in reverse rock slope[J]. Rock and Soil Mechanics，2012，33(2)：262-269.(in Chinese))
[17]	左保成，陈从新，刘小巍，等. 反倾岩质边坡破坏机制模型实验研究[J]. 岩石力学与工程学报，2005，24(19)：3 505-3 511.(ZUO Baocheng，CHEN Congxin，LIU Xiaowei，et al. Modeling experiment study on failure mechanism of counter-tilt rock slope[J]. Chinese Journal of Rock Mechanics and Engineering，2005，24(19)：3 505-3 511.(in Chinese))
[18]	杨豪，魏玉峰，裴向军，等. 含陡缓倾结构面反倾岩坡折断面演化特征的离心试验研究[J]. 岩土力学，2022，43(5)：1 215-1 225. (YANG Hao，WEI Yufeng，PEI Xiangjun，et al. Centrifugal test study of fracture evolution characteristics of anti-dip rock slope with steep and gently dipping structural plane[J]. Rock and Soil Mechanics，2022，43(5)：1 215-1 225.(in Chinese))
[20]	汪小刚，贾志欣，陈祖煜，等. 岩质边坡倾倒破坏的稳定分析方法[J]. 水利学报，1996，41(3)：7-12.(WANG Xiaogang，JIA Zhixin，CHEN Zuyu，et al. Stability analysis method for rock slope toppling failure[J]. Journal of Hydraulic Engineering，1996，41(3)：7-12.(in Chinese))