石灰岩孔道试样压缩条件下变形与强度特征的试验研究

doi:10.13722/j.cnki.jrme.2015.0308

摘要
图/表
参考文献(22)
相关文章 (15)

全文: PDF (2528 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要为了分析非均匀应力分布对石灰岩孔道试样变形、强度及破坏特征的影响，利用孔径为6～25 mm的石灰岩孔道试样，在RMT–150B岩石力学试验系统进行单轴和内孔压为0的常规三轴压缩试验。结果表明：(1) 单轴压缩时，孔道试样的峰值强度、弹性模量与孔径没有明显关系，破坏特征以张剪性破坏为主，孔道没有出现坍塌迹象。(2) 三轴压缩时，孔径对试样在屈服阶段以前变形特性的影响不明显，对峰值后的变形特征影响显著，孔道试样的弹性模量与孔道尺寸、围压的关系不大。(3) 利用修正的Coulomb预测材料强度高出单轴压缩峰值强度11%左右，与完整试样试验回归结果大致相等，其值与孔径和围压没有直接关系；而以修正的双剪切强度准则预测材料强度受试样孔径、围压的影响较为复杂，孔径小于11 mm预测材料强度与孔径、围压的关系不明显，而孔径大于16 mm时预测材料强度随孔径、围压增加而降低。(4) 三轴压缩时孔道试样的破坏特征受孔径、围压的双重影响，孔径较大时更有利于屈服破坏承载能力降低。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	苏承东1
	2
	李冰洋1
	吴秋红3

关键词 ：岩石力学, 孔道试样, 尺寸效应, 强度准则, 变形与强度

Abstract：A series of uniaxial and pseudo-triaxial compression tests on hollow cylinder specimens with 50 mm in outer diameter and 6–25 mm in inner diameter were carried out to study the effects of nonuniform stresses on the deformation，strength and failure characteristics. The test results show that：(1) There is no significant difference among peak strength，elastic modulus and hole diameter under uniaxial compression，failure patterns of specimens are tensile-shear failure，the hole remain hasn’t occur to collapse；(2) The effect of inner diameter on deformation characteristic isnt obvious before yield stage under the triaxial compression，but it has significant effect on the deformation characteristics of post-peak strength. There is no obvious difference between elastic modulus，inner diameter and and confining pressure；(3) The material strength of modified Coulomb prediction is more about 11% than uniaxial compression peak strength，which equals to regression results of intact specimen and has no direct connection to inner diameter and confining pressure. The effect of inner diameter and confining pressure is complex，when material strengths are predicted by modified twin-shear strength criterion. The predictive value of material strength is no significant difference between hole diameter and confining pressure when the inner diameter is less than 11 mm，it decreases as the inner diameter or confining pressure increase when hole diameter is more than 16 mm；(4) The failure characteristic of hollow specimens are affected by hole diameter and confining pressure under triaxial compression，the bearing capacity will decrease when the inner diameter is bigger.

Key words： rock mechanics hollow specimen scale effect strength criterion deformation and strength

引用本文:

苏承东1，2，李冰洋1，吴秋红3. 石灰岩孔道试样压缩条件下变形与强度特征的试验研究[J]. 岩石力学与工程学报, 2016, 35(S1): 2739-2748.
SU Chengdong1，2，LI Bingyang1，WU Qiuhong3. Experimental study on deformation and strength properties of hollow cylindrical specimens of limestone under compression. , 2016, 35(S1): 2739-2748.

链接本文:

https://rockmech.whrsm.ac.cn/CN/10.13722/j.cnki.jrme.2015.0308 或 https://rockmech.whrsm.ac.cn/CN/Y2016/V35/IS1/2739

[1]	王在泉，张黎明，孙辉，等. 不同卸荷速度条件下灰岩力学特性的试验研究[J].岩土力学，2011，32(4)：1045-1050.(WANG Zaiquan，ZHANG Liming，SUN Hui，et al. Experimental study of mechanical properties of limestone under different unloading velocities[J].Rock and Soil Mechanics，2011，32(4)：1045-1050. (in Chinese))
[2]	包春燕，姜谙男，唐春安，等.单轴加卸载扰动下石灰岩声发射特性研究[J].岩石力学与工程学报，2011，30(增2)：3872-3877.(BAO Chunyan，JIANG Annan，TANG Chun¢an，et al. Study of acoustic emission characteristics of limestone under cycle uniaxial loading-unloading perturbation[J]. Chinese Journal of Rock Mechanics and Engineering，2011，30(Supp.2)：3872-3877.(in Chinese))
[3]	苏承东，吴秋红. 含天然贯通弱面石灰岩试样的力学性质研究[J]. 岩石力学与工程学报，2011，30(增2)：3944-3952.(SU Chengdong，WU Qiuhong.Study of mechanical property of limestone specimens with natural continuous weak plane[J]. Chinese Journal of Rock Mechanics and Engineering，2011，30(Supp.2)：3944-3952.(in Chinese))
[4]	杨仕教，曾晟，王和龙. 加载速率对石灰岩力学效应的试验研究[J].岩土工程学报，2005，27(7)：786-788.(YANG Shijiao，ZENG Sheng，WANG Helong.Experimental analysis on mechanical effects of loading rates on limestone[J]. Chinese Journal of Geotechnical Engineering，2005，27(7)：786-788.(in Chinese))
[5]	吴刚，滕念管，王宇. 高温后石灰岩的物理力学特性研究[J].岩土工程学报，2011，33(2)：259-264.(WU Gang，TENG Nianguan，WANG Yu. Physical and mechanical characteristics of limestone after high temperature[J]. Chinese Journal of Geotechnical Engineering，2011，33(2)：259-264.(in Chinese))
[6]	王德咏，吴刚，葛修润.高温作用后石灰岩受压破裂过程的声发射试验研究[J]. 上海交通大学学报，2011，45(5)：744-748.(WANG Deyong，WU Gang，GE Xiurun. Acoustic emission characteristics of limestone during compression and fracture after high temperature[J]. Journal of Shanghai Jiaotong University，2011，45(5)：744-748.(in Chinese))
[7]	中华人民共和国行业标准编写组. SL264—2001水利水电工程岩石试验规程[S]. 北京：中国水利水电出版社，2001.(TheProfessional Standards Compilation Group of People¢s Republic of China. SL264 —2001 Specifications for rock tests in water conservancy and hydroelectric engineering[S]. Beijing：China Water Power Press，2001.(in Chinese))
[8]	LABIOUSE V，VIETOR T.Laboratory and in situ simulation tests of the excavation damaged zone around galleries in Opalinus clay[J]. Rock Mechanicsand Rock Engineering，2014，47(1)：57-70.
[9]	LABIOUSE V，SAUTHIER C，YOU S.Hollow cylinder simulation experiments of galleries in boom clay formation[J]. Rock Mechanics and Rock Engineering，2014，47(1)：53-56.
[10]	SANTARELLI F J，BROWN E T. Failure of three sedimentary rocks in triaxial and hollow cylinder compression tests[J]. International Journal of Rock Mechanics and Mining Sciences and Geomechanics Abstracts，1989，26(5)：401-413.
[11]	EWY R T，COOK N G W. Deformation and fracture around cylindrical openings in rock—I. Observations and analysis of deformations[J]. International Journal of Rock Mechanics and Mining Sciences and Geomechanics Abstracts，1990，27(5)：387-407.
[12]	ADDIS M A，WU B. The role of the intermediate principal stress inwellbore stability studies：evidence from hollow cylinder tests[J].International Journal of Rock Mechanics and Mining Sciences and Geomechanics Abstracts，1993，30(7)：1 027-1 030.
[13]	CHEN X，TAN C P，HABERFIELD C M. Numerical evaluation of the deformation behavior of thick-walled hollow cylinders of shale[J]. International Journal of Rock Mechanics and Mining Sciences，2000，37(6)：947-961.
[14]	郭保华.岩样尺度、孔道及端部摩擦效应的数值分析[J]. 岩石力学与工程学报，2009，28(增2)：3391-3401.(GUO Baohua.Numerical analysis of size scale，inner hole and end restraint effects of rock samples[J]. Chinese Journal of Rock Mechanics and Engineering，2009，28(Supp.2)：3391-3401.(in Chinese))
[15]	周维垣，杨强. 岩石力学数值计算方法[M]. 北京：中国电力出版社，2005：1-90.(ZHOU Weiyuan，YANG Qiang. Numerical computational methods for rock mechanics[M]. Beijing：China Electric Power Press，2005：1-90.(in Chinese))
[16]	尤明庆，苏承东，缑勇.大理岩孔道试样的强度及变形特性的试验研究[J]. 岩石力学与工程学报，2007，26(增1)：2420-2429.(YOU Mingqing，SU Chengdong，GOU Yong. Experimental study on strength and deformation properties of hollow cylindrical specimens of marbles[J]. Chinese Journal of Rock Mechanics and Engineering，2007，26(Supp.1)：2420-2429.(in Chinese))
[17]	缑勇，苏承东，秦莞臻. 含孔道大理岩圆柱试样的尺寸效应[J].采矿与安全工程学报，2007，24(3)：302-305.(GOU Yong，SU Chengdong，QIN Guanzhen. Scale effects of marble hollow cylinder specimen[J]. Journal of Mining and Safety Engineering，2007，24(3)：302-305.(in Chinese))
[18]	尤明庆，苏承东. 砂岩孔道试样压拉应力下强度和破坏的研究[J]. 岩石力学与工程学报，2010，29(6)：1096-1105.(YOU Mingqing，SU Chengdong. Study of strength and failure of hollow cylinders and rings of sandstone under compression-tension stresses[J]. Chinese Journal of Rock Mechanics and Engineering，2010，29(6)：1096- 1105.(in Chinese))
[19]	尤明庆，苏承东. 层理倾角不同的砂岩变形破坏和强度的研究[J].河南理工大学学报：自然科学版，2009，28(5)：626-635.(YOU Mingqing，SU Chengdong. Study of the deformation，failure and strength of sandstone with various declined beddings[J].Journal of Henan Polytechnic University：Natural Science，2009，28(5)：626-635.(in Chinese))
[20]	徐芝纶. 弹性力学(上册)[M]. 北京：高等教育出版社，1979：89-94.(XU Zhilun. Elasticity mechanics(Vol. 1)[M]. Beijing：Higher Education Press，1979：89-94.(in Chinese))
[21]	尤明庆. 岩石的力学性质[M]. 北京：地质出版社，2007：158-163.(YOU Mingqing. Mechanical properties of rocks[M]. Beijing：GeologicalPublishing House，2007：158-163.(in Chinese))
[22]	俞茂宏. 双剪理论及其应用[M]. 北京：科学出版社，1998：68-81.(YU Maohong. Twin-shear theory and its applications[M]. Beijing：Science Press，1998：68-81.(in Chinese))