中主应力系数和主应力方向对原状黏土各向异性的影响研究

摘要
图/表
参考文献(14)
相关文章 (15)

全文: PDF (1268 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要针对当前土体各向异性影响因素的研究比较缺乏，且研究对象多为无黏性土的现状，采用空心圆柱扭剪仪对中主应力系数和主应力方向变化情况下的杭州典型原状黏土的各向异性进行研究。试验结果表明：剪切过程中，中主应力系数b的取值对原状黏土的各向异性有显著影响，而主应力作用方向对原状黏土的各向异性无明显影响。b = 0时，原状黏土沿沉积方向呈横观各向同性。b = 0.5时，无论主应力作用方向如何，原状黏土试样的各向异性在应变上表现为轴向应变与切向应变大小相等、方向相反，体积应变始终等于第二主应变；当主应力轴偏转角较小时，试样破坏时表现出明显的剪胀性和应变软化现象，随着主应力轴的偏转角增大，试样在破坏时开始表现出明显的剪缩性，应变软化现象也逐渐消失，而b=0时则没有这样的特点。另外试验结果还表明，原状黏土在沉积方向上的压缩性最低，而与沉积方向成50°方向的压缩性最高。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	管林波
	周建
	张勋
	谢新宇

关键词 ：土力学, 中主应力系数, 主应力方向, 各向异性, 主应力轴旋转, 原状软粘土

Abstract：There was lack of knowledge about the anisotropy of soft intact clay since most studies were performed on cohesionless soils. A hollow cylinder apparatus(HCA) is used to study the anisotropy of typical Hangzhou intact clay to investigate the influence of the parameters of intermediate principal stress and the principal stress direction on anisotropy. It is revealed that the anisotropy of intact clay is greatly affected by the value of the parameters of intermediate principal stress b，and is hardly affected by the principal stress direction. The intact clay is transversely isotropic along the depositional plane when b equals zero. When b equals 0.5，the characteristic of anisotropy is different. Regardless of the direction of the principal stress，the radial strain and the tangential strain of the sample always equal in magnitude and opposite in direction. Meanwhile the volumetric strain of intact clay is equal to the value of the second principal strain. Apparent dilatancy and strain softening are observed when samples fail at small rotation angle. Shrinking is significantly noticed in the beginning of failure with the increase of the rotation angle，while strain softening gradually vanishes. All these phenomena are not observed in b equaling tests. Test results also present that the intact clays have the lowest compressibility along the direction of deposition and the highest compressibility along the direction of rotation angle 50°.

Key words： soil mechanics parameters of intermediate principal stress principal stress direction anisotropy principal stress rotation soft intact clay

引用本文:

管林波，周建，张勋，谢新宇. 中主应力系数和主应力方向对原状黏土各向异性的影响研究[J]. 岩石力学与工程学报, 2010, 29(S2): 3871-3877.
GUAN Linbo，ZHOU Jian，ZHANG Xun，XIE Xinyu. STUDY OF INFLUENCE OF PARAMETERS OF INTERMEDIATE PRINCIPAL STRESS AND PRINCIPAL STRESS DIRECTION ON ANISOTROPY OF INTACT CLAY. , 2010, 29(S2): 3871-3877.

链接本文:

https://rockmech.whrsm.ac.cn/CN/Y2010/V29/IS2/3871

[1] 张坤勇，殷宗泽，梅国雄. 土体两种各向异性的区别与联系[J]. 岩石力学与工程学报，2005，24(9)：1 599–1 604.(ZHANG Kunyong，YIN Zongze，MEI Guoxiong. Difference and connection of two kinds of anisotropy of soils[J]. Chinese Journal of Rock Mechanics and Engineering，2005，24(9)：1 599–1 604.(in Chinese))

[2] 张坤勇，殷宗泽，梅国雄. 土体各向异性研究进展[J]. 岩土力学，2004，25(9)：1 053–1 059.(ZHANG Kunyong，YIN Zongze，MEI Guoxiong. Development of soil¢s anisotropy study[J]. Rock and Soil Mechanics，2004，25(9)：1 053–1 059.(in Chinese))

[3] 徐志伟. 土体各向异性变形特性真三轴试验研究[博士学位论文][D]. 南京：河海大学，2003.(XU Zhiwei. Study on the characteristic of soil anisotropic deformation by true triaxial test[Ph. D. Thesis][D]. Nanjing：Hohai University，2003.(in Chinese) )

[4] KALIAKIN V N. An assessment of the macroscopic quantification of anisotropy in cohesive soils[C]// First Japan-U.S. Workshop on Testing，Modeling and Simulation in Geomechanics. [S. l.]：[s.n.]，2003：370–393.

[5] YAMADA Y，ISHIHARA K. Anisotropic deformation characteristic soft sand under three-dimensional stress conditions[J]. Soils and Foundations，1979，19(2)：79–94.

[6] 沈扬. 考虑主应力方向变化的原状软黏土试验研究[博士学位论文][D]. 杭州：浙江大学，2007.(SHEN Yang. Experimental study on effect of variation of principal stress orientation on undisturbed soft clay[Ph. D. Thesis][D]. Hangzhou：Zhejiang University，2007.(in Chinese))

[7] ARTHUR J R F，MENZIES B K. Inherent anisotropy in a sand[J]. Geotechnique，1972，22 (1)：115–128.

[8] LADE P V，DUNCAN J M. Cubical triaxial tests on cohesionless soil[J]. Journal of the Soil Mechanics and Foundations Division，1973，99(10)：793–812.

[9] SYMES M J P R，GENS A，HIGHT D W. Undrained anisotropy and principal stress rotation in saturated sand[J]. Geotechnique，1984，34(1)：11–27.

[10] HOQUE E，TATSUOKA F. Anisotropy in elastic deformation of granular materials[J]. Soils and Foundations，1998，38(1)：163–179.

[11] 周建，张金良，沈扬，等. 原状软黏土空心圆柱试样制备研究[J]. 岩土工程学报，2007，29(4)：618–621.(ZHOU Jian，ZHANG Jinliang，SHEN Yang，et al. Preparation of hollow cylindrical samples of intact soft clay[J]. Chinese Journal of Geotechnical Engineering，2007，29(4)：618–621.(in Chinese))

[12] 沈扬，周建，张金良，等. 新型空心圆柱仪的研制与应用[J]. 浙江大学学报(工学版)，2007，41(9)：1 450–1 456.(SHEN Yang，ZHOU Jian，ZHANG Jinliang，et al. Development and application of novel hollow cylinder apparatus[J]. Journal of Zhejiang University (Engineering Science)，2007，41(9)：1 450–1 456.(in Chinese))

[13] 沈扬，周建，龚晓南. 空心圆柱仪(HCA)模拟恒定围压下主应力轴循环旋转应力路径能力分析[J]. 岩土工程学报，2006，28(3)：281–287.(SHEN Yang，ZHOU Jian，GONG Xiaonan. Analysis on the ability of HCA to imitate cyclic principal stress rotation under constant confining pressure[J]. Chinese Journal of Geotechnical Engineering，2006，28(3)：281–287.(in Chinese))

[14] HIGHT D W，GENS A，SYMES M J. The development of a new hollow cylinder apparatus for investigating the effects of principal stress rotation in soils[J]. Geotechnique，1983，33(4)：355–383.