莱新铁矿软岩地层阶段充填法应用研究

摘要
图/表
参考文献(16)
相关文章 (15)

全文: PDF (1261 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要莱新铁矿地质条件复杂，矿岩软弱破碎，地下裂隙水发育，采场地压表现为在自重应力作用下，顶板出现拉应力破坏，导致顶板冒落。针对这种情况，就如何实现安全开采问题进行数值模拟分析。数值分析结果表明，与矩形采场结构相比，菱形采场结构能够较好的适应应力转移规律。据此，针对矿山工程实际，提出菱形采场结构阶段充填采矿方法。应用2D– 软件对菱形采场结构不同结构参数下的应力分布、变形特征及塑性区大小等进行数值计算。数值结果表明，菱形采场结构是一种基本稳定结构；其采场围岩及充填体未出现较大拉应力和塑性区，证明该方法在莱新铁矿的可行性；提出该方法在莱新铁矿应用的最佳结构参数，对莱新铁矿软岩条件下开采具有一定的指导作用。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	李文秀1
	刘新强2

关键词 ：采矿工程, 软岩, 菱形矿房, 分段充填, 数值模拟

Abstract：Because of complex geological conditions，weakness and crushing of ore and rock mass and developmental underground water，Laixin iron mine is one of the mines which is difficult to exploit in China. Under the self-weight stress，the tensile failure appears in the roof which leads to roof falling. By comparing with rectangle-shaped mining room，the diamond-shaped mining room can adapt to the stress transferring law. Then，the sublevel filling mining method with the diamond-shaped mining room is proposed based on the practical engineering；and the stress distribution，deformation characteristics and distribution of plastic zones are calculated by the 2D– software. The numerical results show that the diamond-shaped mining room is a stable structure. Tensile stress and plastic zone are not formed in roof and surrounding rock of the diamond-shaped mining room；and the sublevel filling method is feasible in soft rock strata in Laixin iron mine.

Key words： mining engineering soft rock diamond-shaped mining room sublevel filling numerical simulation

引用本文:

李文秀1，刘新强2. 莱新铁矿软岩地层阶段充填法应用研究[J]. 岩石力学与工程学报, 2010, 29(S2): 3749-3754.
LI Wenxiu1，LIU Xinqiang2. APPLICATION OF SUBLEVEL FILLING METHOD TO SOFT ROCK STRATA IN LAIXIN IRON MINE. , 2010, 29(S2): 3749-3754.

链接本文:

https://rockmech.whrsm.ac.cn/CN/Y2010/V29/IS2/3749

[1] 何满潮，景海河，孙晓明. 软岩工程力学[M]. 北京：科学出版社，2002.(HE Manchao，JING Haihe，SUN Xiaoming. Soft rock engineering mechanics[M]. Beijing：Science Press，2002.(in Chinese))

[2] 蔡美峰，何满潮，刘东燕. 岩石力学与工程[M]. 北京：科学出版社，2002.(CAI Meifeng，HE Manchao，LIU Dongyan. Rock mechanics and engineering[M]. Beijing：Science Press，2002.(in Chinese))

[3] 杨永兵. 边坡岩石强度与岩体强度的工程变换[J]. 金属矿山，2004，(9)：10–12.(YANG Yongbing. Engineering conversion of strength between slope rock and rock mass[J]. Metal Mine，2004，(9)：10–12.(in Chinese))

[4] AKSOY C O，ONARGAN T，YENICE H，et al. Determining the stress and convergence at Beypazaritrona field by three-dimensional elasto-plastic finite element analysis：a case study[J]. International Journal of Rock Mechanics and Mining Sciences，2006，43(2)：166–178.

[5] ZHU W C，LIU J，SHENG J C，et al. Analysis of coupled gas flow and deformation process with desorption and Klinkenberg effects in coal seams[J]. International Journal of Rock Mechanics and Mining Sciences，2007，44(7)：971–980

[6] YU X，ZHOU Y F，PENG S Z. Stability analysis of dam abutments by 3D elasto-plastic finite element method：a case study of Houhe gravity-arch dam in China[J]. International Journal of Rock Mechanics and Mining Sciences，2005，42(3)：415–430.

[7] DHAWAN K R，SINGH D N，GUPTA I D，et al. 2D and 3D finite element analysis of underground openings in an inhomogeneous rock mass[J]. International Journal of Rock Mechanics and Mining Sciences，2002，39(2)：217–227.

[8] DENG J，YUE Z Q，THAM L G，et al. Pillar design by combining finite element methods，neural networks and reliability：a case study of the Fenghuangshan copper mine，China[J]. International Journal of Rock Mechanics and Mining Sciences，2003，40(4)：585–599.

[9] 李夕兵，李地元，郭雷，等. 动力扰动下深部高应力矿柱力学响应研究[J]. 岩石力学与工程学报，2007，26(5)：922–928.(LI Xibing，LI Diyuan，GUO Lei，et al. Study on mechanical response of highly-stressed pillars in deep mining under dynamic disturbance[J]. Chinese Journal of Rock Mechanics and Engineering，2007，26(5)：922–928.(in Chinese))

[10] MERCER R A，BAWDEN W F. A statistical approach for the integrated analysis of mine-induced seismicity and numerical stress estimates，a case study part I：developing the relations[J]. International Journal of Rock Mechanics and Mining Sciences，2005，42(1)： 47–72.

[11] MERCER R A，BAWDEN W F. A statistical approach for the integrated analysis of mine induced seismicity and numerical stress estimates，a case study—part II：evaluation of the relations[J]. International Journal of Rock Mechanics and Mining Sciences，2005，42(1)：73–94.

[12] BRUNEAUA G，TYLERB D B，HADJIGEORGIOUA J，et al. Influence of faulting on a mine shaft—a case study：part I—background and instrumentation[J]. International Journal of Rock Mechanics and Mining Sciences，2003，40(1)：95–112.

[13] BRUNEAUA G，HUDYMAB M R，HADJIGEORGIOUA J，et al. Influence of faulting on a mine shaft—a case study：part II—numerical modelling[J]. International Journal of Rock Mechanics and Mining Sciences，2003，40(1)：113–125.

[14] QUESADA D，PICARD D，PUTOT C，et al. The role of the interbed thickness on the step-over fracture under overburden pressure[J]. International Journal of Rock Mechanics and Mining Sciences，2009，46(2)：281–288.

[15] ABDUL-WAHED M K，AL HEIB M，SEFAUTE G. Mining induced seismicity：seismic measurement using multiplet approach and numerical modeling[J]. International Journal of Coal Geology，2006，66(1/2)：137–147.

[16] GUO H，ADHIKARY D P，CRAIG M S. Simulation of mine water inflow and gas emission during longwall mining[J]. Rock Mechanics and Rock Engineering，2009，42(1)：25–51.