考虑时效特性的锚固岩质边坡变形可靠度分析

摘要
图/表
参考文献
相关文章 (15)

全文: PDF (1309 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要提出基于非侵入式随机有限元法的岩质边坡变形可靠度分析方法。建立考虑腐蚀效应的锚杆锚固力随服役时间变化模型。给出边坡变形可靠度分析非侵入式随机有限元法的计算步骤。研究锚固边坡变形失效概率与最大允许变形值之间的关系，并基于参数敏感性分析提出边坡最大允许变形取值方法。以锚固岩质边坡为例，证明所提方法的有效性。结果表明：非侵入式随机有限元方法为考虑时效特性的边坡变形可靠度分析提供一条有效的途径。随着锚杆服役时间增加，锚杆腐蚀作用对锚固边坡变形可靠度的影响越明显。考虑时效特性的边坡变形失效概率常用对数与边坡最大允许变形值间存在近似线性关系，而且随着边坡可靠度水平增加，该线性关系表现得越明显。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章

关键词 ：边坡工程, 岩质边坡, 变形, 最大允许变形值, 时变可靠度, 非侵入式随机有限元法

Abstract：A non-intrusive stochastic finite element method for time-variant serviceability reliability analysis of anchored rock slopes with consideration of rock bolt corrosion is proposed. A rock bolt corrosion model reflecting the variation of the anchored force of each rock bolt with service time is established. Consequently，the computational procedure for time-variant serviceability reliability analysis of the slope deformation using the non-intrusive stochastic finite element method is proposed. The relationship between the probability of failure for slope deformation and the maximum allowable deformation is investigated；and a method for determining the maximum allowable deformation of the slope is proposed based on parametric sensitivity analysis. An example of reliability analysis of anchored rock slope deformation subjected to surcharge loading is illustrated to demonstrate the validity and capability of the proposed method. The results indicate that the proposed non-intrusive stochastic finite element method can effectively evaluate time-variant serviceability reliability of rock slopes. The rock bolt corrosion has a significant influence on the serviceability reliability of rock slopes as the service time of rock bolts increases. In addition，an approximate linear relationship exists between the logarithm of the time-variant probability of failure for slope deformation，，and the maximum allowable deformation；and this linear relationship becomes more obvious as the reliability level of the slope increases.

Key words： slope engineering rock slopes deformation maximum allowable deformation time-variant reliability non-intrusive stochastic finite element method

收稿日期: 2013-01-16

引用本文:

蒋水华1，2，彭铭3，李典庆1，2，张利民3，周创兵1，2. 考虑时效特性的锚固岩质边坡变形可靠度分析[J]. 岩石力学与工程学报, 2013, 32(6): 1270-1278.
JIANG Shuihua1，2，PENG Ming3，LI Dianqing1，2，ZHANG Limin3，ZHOU Chuangbing1，2. TIME-VARIANT SERVICEABILITY RELIABILITY ANALYSIS OF ANCHORED ROCK SLOPES DEFORMATION. , 2013, 32(6): 1270-1278.

链接本文:

http://www.rockmech.org/CN/Y2013/V32/I6/1270

[1]	李英勇，张顶立，张宏博，等. 边坡加固中预应力锚索失效机制与失效效应研究[J]. 岩土力学，2010，31(1)：144-150.(LI Yingyong，ZHANG Dingli，ZHANG Hongbo，et al. Research on failure mechanism and effects of prestressed anchor cables for reinforcing slopes[J]. Rock and Soil Mechanics，2010，31(1)：144-150.(in Chinese)) " target="_blank">
[3]	CHAU T L，BOURGEOIS E，CORFDIR A. Finite element analysis of the effect of corrosion on the behavior of reinforced earth walls[J]. International Journal for Numerical and Analytical Methods in Geomechanics，2012，36(15)：1 741-1 756. " target="_blank">
[5]	YOUSSEF ABDEL MASSIH D S，SOUBRA A H. Reliability-based analysis of strip footings using response surface methodology[J]. International Journal of Geomechanics，2008，8(2)：134-143. " target="_blank">
[7]	MOLLON G，DIAS D，SOUBRA A H. Probabilistic analysis of tunneling-induced ground movements[J]. Acta Geotechnica，2012，DOI 10.1007/s11440-012-0182-7. " target="_blank">
[9]	程勇刚，常晓林，李典庆. 考虑岩体空间变异性的隧洞围岩变形随机分析[J]. 岩石力学与工程学报，2012，31(增1)：2 767-2 775. (CHENG Yonggang，CHANG Xiaolin，LI Dianqing. Deformation stochastic analysis of tunnel surrounding rock considering its spatial randomness[J]. Chinese Journal of Rock Mechanics and Engineering，2012，31(Supp.1)：2 767-2 775.(in Chinese))
[11]	曾宪明，陈肇元，王靖涛. 锚固类结构安全性与耐久性问题探讨[J]. 岩石力学与工程学报，2004，23(13)：2 235-2 242.(ZENG Xianming，CHEN Zhaoyuan，WANG Jingtao. Research on safety and durability of bolt and cable-supported structures[J]. Chinese Journal of Rock Mechanics and Engineering，2004，23(13)：2 235-2 242. (in Chinese))
[2]	彭衡和，邱贤辉. GFRP锚杆加固高速公路红砂岩边坡的工程实例分析[J]. 公路工程，2008，33(4)：114-117.(PENG Henghe，QIU Xianhui. Case study on GFRP bolts reinforcing red-sand stone slope in expressway[J]. Chinese Journal of Highway Engineering，2008，33(4)：114-117.(in Chinese))
[6]	MOLLON G，DIAS D，SOUBRA A H. Probabilistic analysis of circular tunnels in homogeneous soils using response surface methodology[J]. Journal of Geotechnical and Geoenvironmental Engineering，2009，135(9)：1 314-1 325. " target="_blank">
[10]	VU K A T，STEWART M G. Structural reliability of concrete bridges including improved chloride-induced corrosion models[J]. Structural Safety，2000，22(4)：313-333. " target="_blank">
[13]	陈昌富，成晓炜. 双滑块边坡锚固系统时变可靠性分析[J]. 岩土力学，2012，33(1)：197-203.(CHEN Changfu，CHENG Xiaowei. Time-varying reliability analysis of anchor system of rock slopes with double slide blocks[J]. Rock and Soil Mechanics，2012，33(1)：197-203.(in Chinese))
[14]	BHARGAVA K，GHOSH A K，MORI Y，et al. Corrosion-induced bond strength degradation in reinforced concrete-analytical and empirical models[J]. Nuclear Engineering and Design，2007，237(11)：1 140-1 157. " target="_blank">
[15]	BERVEILLER M，SUDRET B，LEMAIRE M. Stochastic finite elements：a non intrusive approach by regression[J]. European Journal of Computational Mechanics，2006，15(1/2/3)：81-92. " target="_blank">
[23]	SUDRET B. Global sensitivity analysis using polynomial chaos expansion[J]. Reliability Engineering and System Safety，2008，93(7)：964-979. " target="_blank">
[25]	徐前卫，尤春安，朱合华. 预应力锚索的三维数值模拟及其锚固机制分析[J]. 地下空间与工程学报，2005，1(2)：214-218.(XU Qianwei，YOU Chun?an，ZHU Hehua. Research on 3D numerical simulation of prestressed anchor cable and its anchoring mechanism[J]. Chinese Journal of Underground Space and Engineering，2005，1(2)：214-218.(in Chinese)) " target="_blank">
[4]	SHINODA M，HORII K，YONEZAWA T，et al. Reliability-based seismic deformation analysis of reinforced soil slopes[J]. Soils and Foundations，2006，46(4)：477-490. " target="_blank">
[8]	李典庆，蒋水华，周创兵. 基于非侵入式随机有限元法的地下洞室可靠度分析[J]. 岩土工程学报，2012，34(1)：123-129.(LI Dianqing，JIANG Shuihua，ZHOU Chuangbing. Reliability analysis of underground rock caverns using non-intrusive stochastic finite element method[J]. Chinese Journal of Geotechnical Engineering，2012，34(1)：123-129.(in Chinese))
[16]	GEO-SLOPE International Ltd. Stress-Deformation Modeling with SIGMA/W 2007 Version：an engineering methodology[M]. Calgary，Alberta，Canada：GEO-SLOPE International Ltd.，2010：143-224. " target="_blank">
[22]	TANG X S，LI D Q，RONG G，et al. Impact of copula selection on geotechnical reliability under incomplete probability information[J]. Computers and Geotechnics，2013，49：264-278. " target="_blank">
[12]	惠云玲，林志伸，李荣. 锈蚀钢筋性能试验研究分析[J]. 工业建筑，1997，27(6)：10-14.(HUI Yunling，LIN Zhisheng，LI Rong. Experimental study and analysis on the property of corroded rebar[J]. Chinese Journal of Industrial Construction，1997，27(6)：10-14.(in Chinese)) " target="_blank">
[28]	王超. 岩质边坡变形量预警标准分析[J]. 科技资讯，2011，(10)：93.(WANG Chao. Early warning standard analysis of rock slope deformation[J]. Chinese Journal of Science and Technology Information，2011，(10)：93.(in Chinese)) " target="_blank">
[17]	GEO-SLOPE International Ltd.. Stability modeling with SLOPE/W 2007 Version：an engineering methodology[M]. Calgary，Alberta，Canada：GEO-SLOPE International Ltd.，2010：69-76. " target="_blank">
[18]	ZOU J Z，WILLIANS D J，XIONG W L. Search for critical slip surfaces based on finite element method[J]. Canadian Geotechnical Journal，1995，32(2)：233-246. " target="_blank">
[20]	蒋水华，李典庆，周创兵. 随机响应面法最优概率配点数目分析[J]. 计算力学学报，2012，29(3)：345-351.(JIANG Shuihua，LI Dianqing，ZHOU Chuangbing. Optimal probabilistic collocation points for stochastic response surface method[J]. Chinese Journal of Computational Mechanics，2012，29(3)：345-351.(in Chinese))
[19]	LI D Q，CHEN Y F，LU W B，et al. Stochastic response surface method for reliability analysis of rock slopes involving correlated non-normal variables[J]. Computers and Geotechnics，2011，38(1)：58-68.
[21]	SHUKLA S K，HOSSAIN M M. Stability analysis of multi-directional anchored rock slope subjected to surcharge and seismic loads[J]. Soil Dynamics and Earthquake Engineering，2011，31(5/6)：841-844. " target="_blank">
[24]	FENTON G A，GRIFFITH D V. Bearing capacity prediction of spatially random c-? soils[J]. Canadian Geotechnical Journal，2003，40(1)：54-65. " target="_blank">
[26]	李宁，张鹏，于冲. 边坡预应力锚索加固的数值模拟方法研究[J]. 岩石力学与工程学报，2007，26(2)：254-261.(LI Ning，ZHANG Peng，YU Chong. Research on method of numerical simulation of prestressed anchor cable in slope[J]. Chinese Journal of Rock Mechanics and Engineering，2007，26(2)：254-261.(in Chinese))
[27]	张宁. 工程高边坡变形量预警标准研究[硕士学位论文][D]. 北京：北京交通大学，2009.(ZHANG Ning. Research on early warning standard of deformation for high engineering slope[M. S. Thesis][D]. Beijing：Beijing Jiaotong University，2009.(in Chinese)) " target="_blank">